radio GMC ENVOY 2007 Get To Know Guide

11

ENTERTAINMENT

Audio SystemsLoad one CD into the SixDisc
CD Player

1. With the ignition on, press andrelease the LOAD side of the LOAD
CD button.
2. Wait for the indicator light at the right side of the slot to turn green.
3. Insert the disc partway into the slot, label side up; the player will pull the
disc in.

MultipleDisc CD Player
(if equipped)

• Press the H or HR button until the correct hour appears on the display.
• Press and hold the M or MIN button until the correct minute appears on
the display.
The time may be set with the ignition on
or off.

Set the time with an FM station’s
Radio Data System (RDS) setting
(if equipped)

• Press and hold both HR and MN for two seconds until UPDATED and the
clock symbol appear on the display.
• If the time is not available from the station, NO UPDAT appears in the
display.

Program radio station presets

1. Turn the radio on.
2. Press the BAND button to select theband (AM/FM1/FM2/XM1/XM2).
3. Use the seek or tune knob to tune in the desired station.
4. Press AUTO EQ to select the equalization that best suits the type
of station selected.
5. Press and hold one of the six numbered pushbuttons until a beep
sounds; release the button.
6. Repeat these steps for each station preset, using a different numbered
button for each station.

Display a station’ s INFO message
when INFO appears on the display

• Press INFO to see the message.
Once the complete message has been displayed, INFO disappears
from the display.

Tune to an RDS broadcast of a
selected program type

1. Press the TYPE button to select the
Program Type you want to listen to.
2. Press the or button.

Access one of the two available XM
Satellite Radio bands (if equipped)

• Press the BAND button until XM1 or XM2 appears on the display.

MP3 Radio (if equipped)

A CDR or CDRW containing MP3
audio tracks will play automatically when
inserted into the CD/MP3 player.

See Section 3 of your Owner Manual.

Getting to Know YourEnvoy12
CONVENIENCE
Headlamp Controls
The exterior lamps knob is located on
the instrument panel, to the left of thesteering wheel.
Turn off the Daytime Running Lamps
(DRL) and automatic headlamp
system
•Move the knob to the Off ( )
position.
The automatic headlamp system auto
matically reactivates at the next keyon.
Activate the Daytime Running Lamps
(DRL) and automatic headlamp system
• Move the knob to the Auto ( )
position.
•The automatic headlamp system will
turn on all exterior lamps and theinstrument panel/radio lights whenthey are needed during the day orwhen the vehicle is shifted out ofPark at night.
Load multiple CDs
1. With the ignition on, press and hold
the LOAD button for two seconds.The unit beeps and the light to theright of the slot begins to flash.
2. When the light stops flashing and
turns green, insert a disc partway,label side up.
3. The indicator light will begin blinking
and then turn green. Load anotherdisc at this time.
4. When loading more than one but
fewer than six CDs, press the LOADbutton again to signal that loading iscomplete.
When more than one disc is loaded,
a number for each disc is displayed.
5. To play a specific CD, press the CD
AUX button and then the number of
the CD you want to hear.
Asmall bar appears under the CD
number that is playing, and the tracknumber appears.
See Section 3 of your Owner Manual.
Note:CDs with any affixed labels may
jam in the CD player. Label a CD using
a permanent marker. If more than oneCD is inserted into the slot at one time,or if scratched or damaged CDs are
played, the CD player could be dam
aged. When using the CD player, useonly CDs in good condition withoutlabels; load one CD at a time; and keepthe CD player and the loading slot freeof foreign materials, liquids or debris.

13
Headlamp Washers
(if equipped)
Spray the headlamps with washer
fluid
• Press the headlamp washer button
(see “A” above) located on the
instrument panel to the left of thesteering wheel.
See Section 3 of your Owner Manual.
A
Manually activate the parking lamps,
sidemarker lamps, taillamps, instrument panel/radio lights and licenseplate lamps
• Move the knob to the parking lamp
( ) position.
Manually activate the headlamps, all
exterior tail/marker lamps and theinstrument panel/radio lights
• Move the knob to the On ( )
position.
Activate the fog lamps
• Press the button (see “A” below)
located on the instrument panel to
the right of the exterior lamps switchonce.
• An indicator lamp will illuminate.
•To turn them off, press the button
again.
See Section 3 of your Owner Manual.
A