turn signal GMC ENVOY 2007 Get To Know Guide

Page 2 of 20

A.Exterior Lamp Controls
B.Air Outlets
C.Turn Signal/Multifunction Lever
D.OnStar
®/Audio Steering Wheel
Controls
E.Instrument Panel Cluster
F.Audio Steering Wheel ControlsG.Ignition Switch
H.Audio System
I.Climate Controls
J.Hood Release
K.Driver Information Center (DIC)
Steering Wheel Controls
L.Transfer Case ControlsM.Shift Lever
N.Lighter
O.Accessory Power Outlets
P.Parking Brake
Q.Rear Window Washer/Wiper
R.Rear Window Defogger
S.Glove Box
Getting to Know YourEnvoy2
See Section 3 of your Owner Manual.
Instrument Panel
DRIVER INFORMATION

Page 12 of 20

Getting to Know YourEnvoy12
CONVENIENCE
Headlamp Controls
The exterior lamps knob is located on
the instrument panel, to the left of thesteering wheel.
Turn off the Daytime Running Lamps
(DRL) and automatic headlamp
system
•Move the knob to the Off ( )
position.
The automatic headlamp system auto
matically reactivates at the next keyon.
Activate the Daytime Running Lamps
(DRL) and automatic headlamp system
• Move the knob to the Auto ( )
position.
•The automatic headlamp system will
turn on all exterior lamps and theinstrument panel/radio lights whenthey are needed during the day orwhen the vehicle is shifted out ofPark at night.
Load multiple CDs
1. With the ignition on, press and hold
the LOAD button for two seconds.The unit beeps and the light to theright of the slot begins to flash.
2. When the light stops flashing and
turns green, insert a disc partway,label side up.
3. The indicator light will begin blinking
and then turn green. Load anotherdisc at this time.
4. When loading more than one but
fewer than six CDs, press the LOADbutton again to signal that loading iscomplete.
When more than one disc is loaded,
a number for each disc is displayed.
5. To play a specific CD, press the CD
AUX button and then the number of
the CD you want to hear.
Asmall bar appears under the CD
number that is playing, and the tracknumber appears.
See Section 3 of your Owner Manual.
Note:CDs with any affixed labels may
jam in the CD player. Label a CD using
a permanent marker. If more than oneCD is inserted into the slot at one time,or if scratched or damaged CDs are
played, the CD player could be dam
aged. When using the CD player, useonly CDs in good condition withoutlabels; load one CD at a time; and keepthe CD player and the loading slot freeof foreign materials, liquids or debris.

Page 16 of 20

Getting to Know YourEnvoy16
PERFORMANCE & MAINTENANCE
Malfunction Indicator Lamp
(Service Engine Soon Lamp)
This instrument panel cluster lamp
illuminates under a variety of conditionswhen the OnBoard Diagnostics II (OBDII) system detects a malfunction in the
vehicle’s emission controls.
If the Malfunction Indicator Lamp
is lit steadily, check the gas cap toensure it is present and securely fastened
• Turn the cap clockwise until a ratch
eting sound is heard, signaling that itis secure.
•If this is the cause of the condition, a
few driving trips with the cap installedproperly should turn the light off.
See Section 3 of your Owner Manual.
Electronically Controlled
Air Suspension (if equipped)
Occasional whirring and/or hissing
sound under the rear of the vehicle
• This sound indicates that the sys
tem’s air compressor is operating to
provide a level ride height, and is normal.
See Section 4 of your Owner Manual.
Air Inflator System (if equipped)
Locate the air
inflator unit and kit
The inflator unit is in
the rear compart
ment on the passenger side of thevehicle, behind an
access cover.
An inflator kit, with a
22foot hose and three nozzle adapters,is located in the glove box.
Use the air inflator
1. Open the access cover.
2. Attach the appropriate nozzle adapter
to the end of the hose (if required).
3. Attach that end of the hose to the
object you are inflating. Attach theother end of the hose to the inflatoroutlet.
4. Press and release the on/off switch
to turn the air inflator on. An indicator
light verifies that the inflator is
running.
5. When inflation is complete, press and
release the on/off switch again.
6.Remove the hose from the outlet
(load leveling will not operate when
the hose is attached to the outlet).
See Section 5 of your Owner Manual.