oil change GMC YUKON 2007 Get To Know Guide

23
the vehicle is required, the system
should be turned off.
To turn off the traction control part of the
system, press the (StabiliTrak) button located below the climate controlson the instrument panel.
To turn off the traction control and stabil
ity enhancement systems, press andhold the button for five seconds.
When the system is turned off, the
StabiliTrak light will illuminate.
See Section 4 of your Owner Manual.
The Tire Pressure Monitor alerts you
when a significant reduction in pressureoccurs in one or more of your vehicle’s
tires by illuminating the (Low Tire
Pressure) warning light, which will remain
on until you correct the tire pressure.You
may also have a CHECK TIRE PRESSURE message appear on the DIC (ifequipped).
Correcting the Tire Pressure
When the low tire pressure warning light
illuminates, you must fill the tire to the
proper tire inflation pressure. The Tireand Loading Information label shows thecorrect inflation pressure for the tireswhen they’re cold. “Cold” means yourvehicle has been sitting for at least threehours or driven no more than one mile.
You can temporarily remove the DIC mes
sage by acknowledging it with your DIC
controls. However, at the next vehiclestartup, the DIC message will reappear ifthe tire pressure has not been corrected.
During cooler conditions, the low tire
pressure warning light may appear whenthe vehicle is first started and then turn
Tire Pressure Monitor
off as you start to drive the vehicle. This
could be an early indicator that your tirepressures are getting low and need tobe inflated to the proper pressure.
See Section 5 of your Owner Manual.
The Oil Life System calculates engine oil
life based on vehicle use and displays
CHANGE ENGINE OIL in the Driver
Information Center (DIC) when it’s nec
essary to change your engine oil and fil
ter. The Oil Life System should be reset
to 100% only following an oil change.
Reset the Oil Life System using the DIC:
1. Turn on the ignition.
2. Press the (Vehicle Information)
button until the DIC displays OIL LIFEREMAINING.
3. Press and hold the (Set/Reset)
button until 100% is displayed.
4. Turn off the ignition.
Reset the Oil Life System without the DIC:
1. Turn on the ignition, with the engine off.
2. Fully press and release the accelera
tor pedal slowly three times withinfive seconds.
3.If the CHANGE ENGINE OILmes
sage flashes, the system is reset;
otherwise, repeat the procedure.
4.Turn off the ignition.
See Section 5 of your Owner Manual.
Resetting the Engine
Oil Life System
Note: The Tire Pressure Monitor can
alert you about low tire pressure, but itdoesn’t replace normal monthly tiremaintenance.