GREAT WALL PEGASUS 2006 Service Manual

BE-63
Trouble Possible causes Repairing approaches Page
Receiver
CD recorderLack of power supply Burned out fuse
Wiring failureChange the fuse and check whether there is
short circuit;
Make reparation as required
Loudspeaker doesn
t work Faalure of loudspeaker
Wiring failureChaange the loudspeaker;
Make reparation as required.
Do not read the tape or disc Receiver failure or Change the receiver or CD recorder
CD recorder failure
AM or FM doesn
t work Receiver or CD recorder failure Change the receiver or CD recorder
VCD Non-opening of devices Aerial failure
Wiring failure
Main machine failureChange or repair it as required;
Make reparation as required.
Change the main device
Neither image nor sound is
broadcastedFailure of main device;
converter box failure plus disc box
failureMake inspection as required and change
the parts with failure
No image when backing up Wiring failure
Failure of video cameraConduct an inspection as required and
change the parts with failure
FM/TV failure Failure of aerial amplifier
Weak signal from TV station
Make an inspection as required and change
the parts with failure
Screen cannot be turned over Unsuitable main device adjustment
Failure of main deviceAdjust according to the application
instruction;change the main device
Disc box cannot be pushed Failure of disc box Make an inspection as required
outside
Bass speaker doesn
t work Wiring failure
Failure of bass speakerMake reparation as required.
Change the bass speaker.
Electric
aerialNon-raising when receiver is
openedWiring failure
Failure of electric aerialMake reparation as required.
Change the electric aerial
Falling seize-up Wiring failure
Failure of electric aerial.Make an inspection as required and change
the parts with failure.BE-64
BE-64
BE-64
BE-65
BE-65
Inspection on Common Trouble
Body Electric System
Acoustical Equipment System

BE-64
Inspection on Common Trouble
k
v
kk
v
ON
OFF
blue screen
black screen
(a) Main engine cannot be opened
Ther is no action when pressing
the
ower
key repeatedlyCheck whether the voltage of
ACC and storage cell reaches
12 VCheck the fuse in power wire
or the power supply of the
entire vehicle
Failure of main
engine
(b) No voice or image when broadcasting

NO CDC
displayed on
screenRe-open the deviceCheck whether there is image
when backing upFailure of main
engine
Be normal after
returning
Check the converter box works
normally (whether the lamp is
light or not)Failure of converter
box
Failure of disc box
(c) There is no image when backing up
There is no image in
video cameraWhether the screen display
is blue screenFailure of video
camera
The backing up wire is not connected
well; reconnect it to the positive polar
of 12V of reverse gear
Body Electric System
Acoustical Equipment System

BE-65
Failure of disc box
v
k
k
ON
v
OFF
OFF
Invalid
Invalid
(d) FM/TV failures
FM receiving effection is
not goodWhether the signal of local TV
station is weakPay attention to the
receiving location
Check whether the aerial
interface peels off
The receiving effection of
TV station is badWhether the signal of local
TV station is weakPay attention to the
receiving location
Check whether amplifier works
normally (the lamp is lighting )Turn the amplifier switch to

ON
position
Search the TV station for
another timeAmplifier failure
(e) disc box cannot be sent out
Disc box cannot be sent out
Press
OPEN
keyMove the small window
shrapnel at bottom of disc box
then it can be sent out
Body Electric System
Acoustical Equipment System

BE-66
Mount of bass speaker and VCD
(a) bass speaker
Connect the audio output wires of bass speaker with the sockets in bass speaker correspondingly according
to the wire color (red plugging element should be plugged in red socket, yellow plugging element in white
socket, the grounding wire (black), power wire (yellow) and signal wire (blue) should be fixed at the
corresponding positions (GND
12V
REM) on bass speaker tightly.
(b) multi-disc VCD
The feed cables of VCD main device should be connected as marked, when connecting the plugging element
of wire harness of video camera (CAM) with the plugs on main device (CAM), notice should be taken on the
two arrow marks so as to prevent the plugging element damage; The audio output wire plugging elements (red
and yellow plugs) of bass speaker should be connected with the red and white sockets of mainframe (AV OUT);
the plugging elements of TV receiving input wire of amplifier should be connected with either of the plugging
elements(AV AN) of the mainframe; the plugging element (black and white ACC) of anode wire of power
supply should be connected with the red socket (ACC) of mainframe wire harness; grounding wire plugging
element (black GND) should connect with the black socket of mainframe wire harness; the plugs of audio input
wire of deci-disc data converter should be connected with the red and white socket on mainframe according
to the plugs color (the plugs (red, white CD OUT) of audio input wire of eight-disc box should be connected
with the red, white socket (CD IN) on mainframe according to the plug color, the yellow power wire plugging
element (BATT) should be connected with the yellow power wire socket (BATT) on mainframe, the electric
aerial, plugging elements of control wire of function amplifier should be connected with the electric aerial
(CTL), socket of control line of function amplifier on mainframe. After completing the connection of plugging
elements, wrap the connecting position with adhesive strap in order to prevent those plugging elements from
peeling off, the plugging element of feed cable of TV receiving aerial can connect with any two of the four
holes on amplifier, meanwhile, turn on the switch (with a red indicating lamp) of amplifier when watching the
TV play. When mounting the VCD mainframe, push the wire harness innermost as can as possible so that there
is spacious room for mainframe, then push in the mainframe, notice should be taken not to damage the wire
harness. Fasten the mainframe to the degree that it cannot be pull out by hand after assembling, if it cannot be
clamped tightly, prize out the two clips on the inner sleeve, then fasten the mainframe, and mount on the
external decoration frame finally. When disassembling the mainframe, tear down the external decoration
frame first, then insert the special key into the open grooves at two sides to pull out the mainframe.Body Electric System
Acoustical Equipment System

BE-67
Connecting Sketch of VCD System
SY SJ
Bl B R YACC BATT
Gr/B Gr V/B V W/B W G/B G
Y
video
R
right sound
track
W
left sound
track
VCD output
WCD/AUDIOOUT/L RCD/AUDIOOUT/R
ACC
RADIO ANTENNA IN
Notice:
1. The aerial control should be
highly effective;
2. The control of function amplifier
should be highly effective;
3. The disc device should be
earthed fixedly
groundingright front right rearleft frontleft rear
screen connecting wire of disc box grounding wiredisc box
Y video input
RAV audio input
R
RAV audio input
L
TV aerial input
camera input
radar inputRCD audio input
R
L
YD function amplifier control
BL aerial control
W audio output
R L
RCD audio inputR audio output
back up signal
Body Electric System
Acoustical Equipment System

BE-68Body Electric System
Wire Harness Distribution
Housing wire harness
1 back-up lamp switch
2 starter
3 starter
4 oil pressure sensor
5 grounding wire
6 grounding wire
7 connected to protective box II
8 protective box II
9 connected to protective box II
10 starter11 air-conditioner compressor12water temperature sensor
13 washer motor
14 right headlamp
15 right lever-shaped lamp
16 electric horn
17 generator
18 left headlamp
19 left lever-shaped lamp
20 front turn lamp of left side
21 connected to protective box I
1
2
P
4 5 6 7
8
V
1011
12
13
14
NR1617
18
192021
Wire harness distribution
aê

BE-69
SL SK SY SJ
1 connected to cab wire harness
2 connected to cab wire harness
3 odometer sensor
4 back-up lamp switch
5 turn lamp on right side
6 grounding wire
7 brush motor
8 protective box II
9 wire connecting with accumulator anode
10 wire connecting with accumulator anode
11 electromagnetic fan
12 washer motor
13 right fog lamp
14 right turn lamp
15 right headlamp
16 right small lamp17 horn electric horn
18 left turn lamp
19 left small lamp
20 left headlamp
21 left fog lamp
22 pressure switch of air-conditioner
23 generator
24 generator
25 grounding wire
26 turn lamp on left side
27 brake liquid level sensor
28 connected to cab wire harness
29 connected to cab wire harness
30 connected to cab wire harness
31 flasher relay
1
O
3
4
5
6
7
8
9
10
11
12
13
14
151617
18
19
20 21222324252627282930
31
Housing wire harness (continued)
Body Electric System
Wire Harness Distribution

BE-70
SF
1
2 P
4 5 6
7
8 9 10
11 12 13
14
15 16 1718 19
20
21
22
23
2425262728
29
30 3132
33
34
3536
37
38
39
40
41
42
43
44 45 46 47
48
49 50 51
52
53
54
555657 5859
Housing wire harness (continued)
60 61
1 left door lamp switch
2 defrost switch at tail door
3 window regulator at tail door
4 parking brake switch
5 ignition lock
6 combined switch
7 instrument
8 combined switch shell
9 grounding wire
10 amplifying plate of air-conditioner
11 heat-sensitive resistance
12 control panel of air-conditioner
13 A/C Switch
14 glove-box lamp switch
15 glove-box lamp
16 speed-adjusting resistance
17 blower
18 indoor temperature sensor
19 right front loudspeaker
20 brush motor
21 turn lamp on right side22 electric fan relay
23 maxi-fuse
24 joint of wire harness at right front door
25 right front door lamp switch
26 right electric back-up mirror
27 grounding wire
28 rear sound box wire
29 ashtray lamp
30 CD Device wire
31 cigarette lighter A
32 cigarette lighter B
33 dual flasher switch
34 fog lamp switch
35 temperature indicator
36 stop lamp switch
37 brake liquid level sensor
38 control case of central control lock
39 left front loudspeaker
40 automatic aerial
41 turn lamp on left side
42 generator43 left front conner lamp
44 left front lever-shaped lamp
45 front fog lamp
46 left headlamp
47 temperature control switch
48 connected to wire of 220
49 spraying motor A
50 spraying motor B
51 right front conner lamp
52 right headlamp
53 horn A
54 horn B
55 right front lever-shaped lamp
56 right front fog lamp
57 electric fan
58 outdoor temperature sensor
59 connected to chassis wire harness
anright central wire harness
60 connected to left central wire harness
61 connected to engine wire harness
Body Electric System
Wire Harness Distribution

BE-71
Cab wire harness
aê
1 right front turn lamp
2 outdoor temperature sensor
3 right lever-shaped lamp
4 front fog lamp
5 horn
6 accumulator wire of 220V
7 electromagnetic fan
8 temperature control switch
9 protective box II
10 turn signal lamp on right side
11 brush motor
12 plug of engine wire harness
13 wire harness at right rear door
14 plug of frame wire harness
15 door lamp switch
16 wire harness at right front door
17 door lamp
18 right external electric rear vision mirror
19 protective box III
20 indoor temperature sensor
21 right loudspeaker22 speed-adjusting resistance
23 air blower
24 grounding wire
25 A/C switch
26 controlling element
27 ashtray lamp
28 receiver wire
29 cigarette lighter
30 cigarette lighter
31 rear sound box wire
32 amplifying plate of air-conditioner
33 grounding wire
34 heat-sensitive resistance
35 dual flasher switch
36 fog lamp switch
37 temperature indicator
38 combined switch shell lamp
39 combined switch
40 ignition switch
41 combination instrument A
42 combination instrument B43 parking brake switch
44 brake switch
45 left loudspeaker
46 control case of central control lock
47 grounding wire
48 grounding wire
49 voltage regulator
50 brake liquid level alarming device
51 protective box I
52 plug of wire harness at left rear door
53 door lamp
54 door lamp switch
55 ceiling lamp
56 lamp for reading
57 door lamp
58 door lamp switch
59 backup radar screen
60 right rear loudspeaker
61 highly-mounted stop lamp
62 left rear loudspeaker
1
2
34
5 6
789 10111213
14
15
16
17
18
19
20
2122
23
2425
26
27
28
29 30313233
34
35
36
373839
40
41
4243
4445
4647
48
4950
5152 53
54
55
56
5758 59
60
61
62
Body Electric System
Wire Harness Distribution

BE-72
pi=ph
1 grounding wire
2 wire harness at right front door
3 warm air motor
4 wire harness at right front door
5 control case of central control lock
6 heat-sensitive resistance
7 speed-adjusting resistance
8 connected to housing wire harness
9 connected to housing wire harness
10 A/C switch
11 air-volume switch
12 ashtray luminous lamp
13 ECU
14 receiver
15 rear loudspeaker
16 cigarette lighter
17 cigarette lighter grounding wire
18 cigarette lighter luminous lamp
19 fog lamp switch
20 dual flasher switch21 luminous lamp on air-conditioner panel
22 combined switch
23 instrument
24 instrument
25 stop lamp switch
26 connected to roof wire harness
27 connected to housing wire harness
28 connected to housing wire harness
29 connected to housing wire harness
30 connected to wire harness at left front door
31 connected to wire harness at left front door
32 connected to wire harness at left front door
33 protective box I
34 grounding wire
35 wire harness at left front door
36 connected to wire harness at left rear door
37 parking brake switch
38 connected to wire harness at right rear door
39 right front door lamp switch
40 connected to chassis wire harness
1
2
3
4
5
6
7
8
910
11
12
13 14
1516
17
18 19
20
21
2223
24
25
26
27
28
2930
31
32
33
343536 37 38
39
Cab Wire harness (continued)
40
Body Electric System
Wire Harness Distribution