HONDA CIVIC HATCHBACK 2003 7.G Repair Manual
Page 61 of 275
If you exceed 10,000 miles (16,000
km) without having the scheduled
maintenance perf ormed, this
indicator will remain on as a constant
reminder.Your dealer will reset this indicator
af ter completing the scheduled
maintenance. If this maintenance is
done by someone other than your
Honda dealer, reset the indicator as
f ollows.
Hold the button until the indicator
resets (approximately ten
seconds).
Turn of f the engine.
Press and hold the Select/Reset
buttonintheinstrumentpanel,
then turn the ignition switch ON
(II).
1. 2. 3.
Indicator L ights
Inst rument s and Cont rols
62
Page 62 of 275
This shows your speed in miles per
hour (mph). The smaller inner
numbers are the speed in kilometers
per hour (km/h).
This shows your speed in kilometers
per hour (km/h). The smaller inner
numbers are the speed in miles per
hour (mph).This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it.
To reset a trip meter, display it, and
then press and hold the Select/Reset
button until the number resets to‘‘0.0’’.
There are two trip meters: Trip A
and Trip B. Switch between these
displays and the odometer by
pressing the Select/Reset button
repeatedly. Each trip meter works
independently, so you can keep track
of two dif f erent distances.
The odometer shows the total dis-
tance your car has been driven. It
measures miles in the U.S. model
and kilometers in the Canadian
model.
It is illegal under U.S. f ederal law and
Canadian provincial regulations to
disconnect, reset, or alter the
odometer with the intent to change
the number of miles or kilometers
indicated.
U.S. model
Canadian model
Speedometer Odometer Trip Meter
Gauges
Inst rument s and Cont rols
63
MAINTENANCE
REQUIRED
INDICATOR
TACHOMETER TEMPERATURE GAUGE
ODO/TRIPMETER
U.S. model shown SPEEDOMETER
SELECT/RESET BUTTON FUEL GAUGE
Page 63 of 275
The tachometer shows the engine
speed in revolutions per minute
(rpm). To protect the engine f rom
damage, never drive with the
tachometer needle in the red zone.
The needle returns to the bottom
after you turn off the ignition. The
gauge shows the f uel level reading
immediately af ter you turn the ignition switch back ON (II).
This shows the temperature of the
engine’s coolant. During normal
operation, the pointer should rise
from the bottom mark to about the
middle of the gauge. In severe
driving conditions, such as very hot
weather or a long period of uphill
driving, the pointer may rise to the
upper blue zone. If it reaches the red
(Hot) mark, pull saf ely to the side of
the road. Turn to page for
instructions and precautions on
checking the engine’s cooling
system.
This shows how much f uel you have.
It is most accurate when the vehicle
is on level ground. It may show
slightly more or less than the actual
amount when you are driving on
curvy or hilly roads.
232
Gauges
Inst rument s and Cont rolsT achometer
Fuel Gauge Temperature Gauge
64 MAINTENANCE
REQUIRED
INDICATOR
TACHOMETER SPEEDOMETER
TEMPERATURE GAUGE
ODO/TRIPMETER
U.S model shown SELECT/RESET BUTTONFUEL GAUGE
Avoid driving with an extremely low
f uel level. Running out of f uel could
cause the engine to misf ire, damaging
the catalytic converter.
Page 64 of 275
Î
Î
Thetwoleversonthesteering
column contain controls f or driving
f eatures you use most of ten. The lef t
lever controls the turn signals,
headlights, and high beams. The
right lever controls the windshield
washers and wipers.
The tilt adjustment lever on the
underside of the steering column
allows you to tilt the steering wheel.
To use the horn, press the pad around the ‘‘H’’ logo.
Controls Near the Steering Wheel
Inst rument s and Cont rols65
HEADLIGHTS/
TURN SIGNALS
(P. 66/68)
WINDSHIELD WIPERS/
WASHERS
(P. 68/69) REAR WINDOW DEFOGGER
(P. 70)
MIRROR CONTROLS
(P. 88) TILT ADJUSTMENT
(P. 71)HORN
(P. 70)
HAZARD WARNING LIGHTS
Page 65 of 275
The rotating switch on the lef t lever
controls the lights. Turning this
switch to the ‘‘ ’’ position turns
on the parking lights, taillights,
instrument panel lights, side-marker
lights, and rear license plate lights.
Turning the switch to the ‘‘ ’’
position turns on the headlights.If you leave the lights on with the
ignition switch in ACCESSORY (I)
or LOCK (0), you will hear a
reminder beeper when you open the
driver’s door.
To change f rom low beams to high
beams, push the turn signal lever
f orward until you hear a click. The
blue high beam indicator will light
(see page ). To return to low
beams, pull the turn signal lever
back.59
Headlights
Controls Near the Steering Wheel
Inst rument s and Cont rols
66
Page 66 of 275
To f lash the high beams, pull the
turn signal lever back lightly, then
release it. The high beams will come
on and go off.
The high beams will stay on f or as
long as you hold the lever back, no
matter what position the headlight
switch is in.The daytime running lights come on
automatically when the ignition
switch is turned to the ON (II)
position. They go out automatically
when the light switch is ON.
Theknobontheinstrumentpanel
controls the brightness of the instru-
ment panel lights. Turn the knob to
adjust the brightness.
Controls Near the Steering Wheel
Inst rument s and Cont rols
Daytime Running L ights Instrument Panel Brightness
(Canadian Model)
67
Page 67 of 275
Signal a turn or lane change with this
lever. Push down on the lever to
signal a lef t turn, and up to signal a
right turn. If you push it up or down
all the way, the turn signal continues
to blink even when you release the
lever. It shuts off automatically as
you complete the turn.To signal a lane change, push lightly
on the turn signal lever in the proper
direction and hold it. The lever will
return to the center position as soon
as you release it.
The right lever controls the wind-
shield wipers and washers. The
rotary switch at the end of the lever
has f ive positions;MIST: mist
OFF: off
INT: intermittent
LO: low speed
HI: high speed
Controls Near the Steering Wheel
Inst rument s and Cont rols
T urn Signals
Windshield Wipers
68
Page 68 of 275
In intermittent, the wipers operate
every f ew seconds. In low speed and
high speed, the wipers run continu-
ously.
To operate the wipers in mist mode,
push the control lever up f rom the
OFF position. The wipers run at high
speed until you release the lever.
This gives you a quick way to clear
the windshield.To clean the windshield, pull back on
the wiper control lever. The washers
spray until you release the lever.
The wipers run at low speed while
you’re pulling the lever, then
complete one more sweep of the
windshield af ter you release it.
Therotatingswitchontheright
lever controls the rear window wiper
and washer.
To turn on the rear window wiper,
rotate the switch to ‘‘ON’’. The
wiper will complete two sweeps to
clear the window, then operate every
7 seconds. When you turn the wiper
switch to the ‘‘OFF’’ position or turn
of f the ignition switch, the wiper
returns to its parked position.
CONT INUED
Controls Near the Steering Wheel
Inst rument s and Cont rols
Windshield Washers
Rear Window Wiper and Washer
69
Page 69 of 275
To clean the rear window, rotate and
hold the switch one position up f rom
‘‘ON’’, or rotate and hold it one
position down f rom ‘‘OFF’’. The
washer sprays while you hold the
switch. The wiper operates while you
hold the switch, then completes two
more sweeps af ter you release it.Pushtheredbuttontoturnonthe
hazard warning lights (f our-way
flashers). This causes all four
outside turn signals and both
indicators in the instrument panel to
f lash. Use the hazard warning lights
if you need to park in a dangerous
area near heavy traffic, or if your car
is disabled.The rear window def ogger will clear
fog,frost,andthinicefromthe
window. Push the def ogger button to
turn it on and of f . The light in the
button lights to show the def ogger is
on. If you do not turn it of f , the
def ogger will shut itself of f af ter
about15minutes.Italsoshutsoff
when you turn of f the ignition. You
have to turn it on again when you
restart the car.
Rear Window Def ogger
Hazard Warning
Controls Near the Steering Wheel
Inst rument s and Cont rols
70
Page 70 of 275
Make sure the rear window is clear
and you have good visibility bef ore
starting to drive.Make any steering wheel adjustment
bef ore you start driving.
To adjust the steering wheel upward
or downward:Push the lever under the steering
column all the way down.
Thedefoggerwiresontheinsideof
the rear window can be accidentally
damaged. When cleaning the glass,
always wipe side to side.
Move the steering wheel to the
desired position, making sure the
wheel points toward your chest,
not toward your f ace. Make sure
you can see the instrument panel
gauges and the indicator lights.
Push the lever up to lock the
steering wheel in that position.
Make sure you have securely
locked the steering wheel in place
by trying to move it up and down.
1.
4.
3.
2.
See page f or important saf ety
inf ormation about how to properlyposition the steering wheel. 17
Inst rument s and Cont rols
Controls Near the Steering Wheel
Steering Wheel A djustment
71
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
inacrash.
Adjust the steering wheel only
when the vehicle is stopped.