light HONDA CIVIC HATCHBACK 2004 7.G Workshop Manual

Page 170 of 215

You hear nothing, or almost
nothing. The engine’s starter
motor does not operate at all, or
operates very slowly.
You can hear the starter motor
operating normally, or the starter
motor sounds like it is spinning
f aster than normal, but the engine
does not start up and run.When you turn the ignition switch to
START (III), you do not hear the
normal noise of the engine trying to
start. You may hear a clicking sound
or series of clicks, or nothing at all.
Turn the ignition switch to START
(III). If the headlights do not dim,
check the condition of the f uses. If
thefusesareOK,thereis
probably something wrong with
the electrical circuit f or the
ignition switch or starter motor.
You will need a qualif ied
technician to determine the
problem (see
on page ).
If the headlights dim noticeably or
go out when you try to start the
engine, either the battery is dis-
charged or the connections are
corroded. Check the condition of
the battery and terminal connec-
tions (see page ). You can
then try jump starting the vehicle
f rom a booster battery (see page
).
Turn the ignition switch to ON (II).
Turn on the headlights, and check
their brightness. If the headlights
are very dim or don’t light at all,
the battery is discharged. See
on page .
Check the transmission interlock.
The clutch pedal must be pushed
all the way to the f loor or the
starter will not operate.
Check these things:
Diagnosing why the engine won’t
start f alls into two areas, depending
on what you hear when you turn the
key to START (III):
173185
162
173
Nothing Happens or the Starter
Motor Operates Very Slowly
Emergency T owing
Jump Starting T aking Care of t he Unexpect ed
If theEngineWon’tStart
171
 — —y


y
() y 
y

Page 171 of 215

In this case, the starter motor’s
speed sounds normal, or even f aster
than normal, when you turn the
ignition switch to START (III), but
the engine does not run.Do you have f uel? Check the f uel
gauge; the warning light may not
be working.
There may be an electrical
problem, such as no power to the
f uel pump. Check all the f uses
(see page ).
Are you using a properly coded
key? An improperly coded key will
cause the immobilizer system
indicator in the dash panel to blink
rapidly(seepage ).
Are you using the proper starting
procedure? Ref er to
on page . If youfindnothingwrong,youwill
need a qualif ied technician to f ind
the problem. See
on page .
123 65 181
185
T he Starter Operates Normally
Starting the
Engine Emergency
Towing
If theEngineWon’tStart
T aking Care of t he Unexpect ed
172
 — —y

 y
() y 
y

Page 172 of 215


´ ´
Although this seems like a simple
procedure, you should take several
precautions.
Connect the second jumper cable
to the negative ( ) terminal on
the booster battery. Connect the
other end to the grounding strap
as shown. Do not connect this
jumper cable to any other part of
the engine.
If the booster battery is in another
vehicle, have an assistant start
that vehicle and run it at a fast idle.
Open the hood, and check the
physical condition of the battery.
In very cold weather, check the
condition of the electrolyte. If it
seems slushy or like ice, do not try
jump starting until it thaws.
Turn of f all the electrical
accessories: heater, A/C, stereo
system, lights, etc. Put the
transmission in Neutral and set
the parking brake.
Connect one jumper cable to the
positive ( ) terminal on your
battery. Connect the other end to
the positive ( ) terminal on the
booster battery.
1. 2. 3.
4. 5.
Jump Starting
T aking Care of t he Unexpect ed
173
NOTICE:
A battery can explode if you do
not follow the correct procedure,
seriously injuring anyonenearby.
Keep all sparks, open flames,
and smoking materials away
from the battery. If a battery sits in extreme
cold, the electrolyte inside can f reeze.
Attempting to jump start with a f rozen
battery can cause it to rupture.
 — —y


y
() y 
y

Page 178 of 215

However, if the brake pedal does not
f eel normal, you should take
immediate action. A problem in one
part of the system’s dual circuit
design will still give you braking at
two wheels. You will f eel the brake
pedal go down much f arther bef ore
the vehicle begins to slow down, and
you will have to press harder on the
pedal.
Slow down by shif ting to a lower
gear, and pull to the side of the road
when it is saf e. Because of the long
distance needed to stop, it is
hazardous to drive the vehicle. You
should have it towed and repaired as
soon as possible (seeon page ).
If you must drive the vehicle a short
distance in this condition, drive
slowly and caref ully.
If the brake system indicator comes
on while driving, the brake f luid level
is probably low. Press lightly on the
brake pedal to see if it f eels normal.
If it does, check the brake f luid level
thenexttimeyoustopataservice
station (see page ).
If the f luid level is low, take your
vehicle to a dealer and have the
brake system inspected f or leaks or
worn brake pads. The brake system indicator
normally comes on when
you turn the ignition switch
to ON (II), and as a
reminder to check the
parking brake. It will stay
on if you do not f ully
release the parking brake.
144 185Emergency
Towing
Brake System Indicator
T aking Care of t he Unexpect ed 179
Canada
U.S.
 — —y

 y
() y 
y

Page 180 of 215

Turn the ignition switch to LOCK
(0). Make sure the headlights and
all other accessories are of f .
Remove the cover f rom the f use
box.
Check each of the large f uses in
the under-hood f use box by
looking through the top at the wire
inside. Remove the screws with a
phillips-head screwdriver.
The vehicle’s f uses are located in
two fuse boxes. The interior fuse
box is located underneath the
steering column. To open it, turn the
knobsasshown.
If something electrical in your
vehicle stops working, check f or a
blown f use f irst. Determine f rom the
chart on pages and ,or the
diagram on the f use box lid, which
f uses control that device. Check
those fuses first, but check all the
f uses bef ore deciding that a blown
f use is the cause. Replace any blown
f uses, and check if the device works.
The under-hood f use box is located
in the back of the engine
compartment on the lef t side. To
open it, push the tabs as shown. 1. 2. 3.
183 184
Checking and Replacing Fuses
Fuses
T aking Care of t he Unexpect ed
181
UNDER-HOOD
INTERIOR
FUSE
BLOWN
 — —y

y
() y 
y

Page 182 of 215


Î No. Amps. Circuits Protected
1 23456789
1011121314151617181920 20A15A
7.5A
20A10A15A15A20A10A40A30A40A40A40A20A20A20A60A80A40A50A Condenser Fan
Small Light
Interior Light
Cooling Fan
Hazard
FI ECU
Horn, Stop
ABS (F/S)
Back Up
ABS Motor
Rear Defroster
Heater Motor
Power Window
Option
Lef t Headlight
Door Lock
Right Headlight
Main Fuse EPS
Main Fuse Battery
Main Fuse Ignition
On Canadian model
Fuse Locations
T aking Care of t he Unexpect ed 183
UNDER-HOOD FUSE BOX
 — —y

y
() y 
y

Page 183 of 215

µµ µ µ µ


Î Î

No. Amps. Circuits Protected No. Amps. Circuits Protected
123456789
10 15A20A
(10A) 10A
7.5A
(20A) 7.5A
10A
7.5A Ignition Coil
LAF Heater
Daytime Running Lights
Alternator
Not Used
Power Window Relay
Moonroof
ACC Radio
Rear Wiper
Meter 111213141516171819202122 23 2425
7.5A
(7.5A) 10A10A
(20A) 15A15A
7.5A 30A 20A20A ABS
Daytime Running Lights
SRS
Power Mirror
Not Used
Heated Seat
Fuel Pump
Accessory Power Socket
Turn Signal Lights
Front Wiper
Not Used
Front Passenger’s Power
Window
Driver’s Power Window
Not Used
Not Used
2: Not Used
1: On Canadian model
1 1
2
Fuse Locations
T aking Care of t he Unexpect ed
184
INTERIOR FUSE BOX
 — —y

y
() y 
y

Page 190 of 215

µµµ
µ µµµµµµµµµµµµµµ µ
Specif ications
T echnical Inf ormation 191
Air Conditioning
Lights
Fuses
Battery Alignment
Tires
HFC-134a (R-134a)
16.9 18.6 oz (500 550 g) SP-10
12 V 60 W 0.00 in (0.0 mm)
0.08 in (2.0 mm)
0°45°
1°33’
P205/55R16 89V
T135/70D15 99M
30 psi (210 kPa , 2.1 kgf/cm
)
30 psi (210 kPa , 2.1 kgf/cm)
60 psi (420 kPa , 4.2 kgf/cm)
12 V 45 AH/20 HR
Refrigerant type
Charge quantity
Lubricant type Headlights
Front turn signal
Front parking light
Side turn signal light
Front side marker
Rear turn signal lights
Stop/Taillights
Rear side marker lights
Back-up lights
High-mount brake light
License plate lights
Front ceiling light/Spotlights
Center ceiling light
Cargo area light 12 V 5 W
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
8W
5W
5W
5W
18 W
2CP(3.8W)
21/5 W
21 W
2CP(3.8W)
5W
3CP(5W)
21 W
12 V 51 W
Interior
Under-hood
Capacity Toe-in
CamberCaster Size
Pressure
See page 183 or the fuse box
cover.
See page 184 or the fuse label
attached to the inside of the fuse
box door under the dashboard. FrontRear
FrontRear
Front
Front/Rear
Spare
FrontRear
Spare
HILO
(HB3)(HB4)
 — —y

 y
() y 
y

Page 193 of 215



The burning of gasoline in your
vehicle’s engine produces several by-
products. Some of these are carbon
monoxide (CO), oxides of nitrogen
(NOx) and hydrocarbons (HC).
Gasoline evaporating f rom the tank
also produces hydrocarbons. Con-
trolling the production of NOx, CO,
and HC is important to the environ-
ment. Under certain conditions of
sunlight and climate, NOx and HC
react to f orm photochemical ‘‘smog.’’
Carbon monoxide does not contri-
bute to smog creation, but it is a
poisonous gas. The United States Clean Air Act
sets standards f or automobile
emissions. It also requires that
automobile manufacturers explain to
owners how their emissions controls
workandwhattodotomaintain
them. This section summarizes how
the emissions controls work.
Scheduled maintenance is on page
.
In Canada, Honda vehicles comply
with the Canadian Motor Vehicle
Saf ety Standards (CMVSS) f or
Emissions valid at the time they are
manuf actured.
Your vehicle has a Positive
Crankcase Ventilation System. This
keeps gasses that build up in the
engine’s crankcase f rom going into
the atmosphere. The Positive Crank-
case Ventilation valve routes them from the crankcase back to the
intake manif old. They are then
drawn into the engine and burned.
As gasoline evaporates in the f uel
tank, an evaporative emissions
control canister f illed with charcoal
adsorbs the vapor. It is stored in this
canister while the engine is of f . Af ter
the engine is started and warmed up,
the vapor is drawn into the engine
and burned during driving.
The Onboard Ref ueling Vapor
Recovery (ORVR) system captures
the f uel vapors during ref ueling. The
vapors are adsorbed in a canister
f illed with activated carbon. While
driving, the f uel vapors are drawn
into the engine and burned of f .
131
Emissions Cont rols
T echnical Inf ormation The Clean Air Act
Crankcase Emissions Control
System
Evaporative Emissions Control
System
Onboard Ref ueling Vapor
Recovery
194
 — —y

 y
() y 
y

Page 197 of 215

Select a nearby lightly traveled
major highway where you can
maintain a speed of 50 to 60 mph
(80to97km/h)foratleast20
minutes. Drive on the highway in
5th.Donotusethecruisecontrol.
When traffic allows, drive for 90
seconds without moving the
accelerator pedal. (Vehicle speed
may vary slightly; this is okay.) If
you cannot do this f or a
continuous 90 seconds because of
traf f ic conditions, drive f or at least
30 seconds, then repeat it two
more times (for a total of 90
seconds).Then drive in city/suburban
traffic for at least 10 minutes.
When traf f ic conditions allow, let
the vehicle coast f or several
seconds without using the
accelerator pedal or the brake
pedal.
If the testing f acility determines the
readiness codes are still not set, see
your Honda dealer.
St at e Emissions T est ing
T echnical Inf ormation
198
 — —y


y
() y  
y

Page:   < prev 1-10 ... 11-20 21-30 31-40 41-50 51-60 61-70 next >