navigation system HONDA CR-V 2007 RD1-RD5, RE7 / 3.G Service Manual

Page 185 of 352

µ´
µ´
CD Changer (Models with navigation system)
Features
181
JOYSTICK
POWER/VOLUME
KNOB
CD BUTTON
RANDOM
BUTTON
REPEAT BUTTON
REWIND BUTTONSKIP BUTTON
SKIP BUTTON
CD ICON
TUNE BAR
U.S. EX-L model
CD CHANGER ICON
OPEN
BUTTON AUDIO
BUTTON SCAN
BUTTON Canadian EX-L model
FAST FORWARD
BUTTON POWER/VOLUME
KNOB
CD BUTTON
REPEAT BUTTONTUNE BAR
OPEN
BUTTON
AUDIO
BUTTON
SCAN
BUTTON JOYSTICK
RANDOM
BUTTON REWIND BUTTON SKIP BUTTON
SKIP BUTTON
CD CHANGER ICON
FAST FORWARD
BUTTON
CD ICON

Page 186 of 352

Open the center console cover,
then slide open the CD changer
cover by pulling it rearward.Push the EJECT button to remove
the CD magazine. The magazine
will pop up automatically.
Your vehicle has the CD changer in
the center console.
CD-R,CD-RWdisc,andCD
compressedinMP3andWMAwill
not work in this unit. Video CDs and
DVD discs also will not work.
Do not spill any liquids on the center
console. Spilled liquids can damage
electrical components in the CD
changer.
1. 2.
CD Changer (Models with navigation system)
L oading CDs in the Changer
182
EJECT BUTTON

Page 187 of 352

To install a CD into the magazine,
push the button while pulling out
on the tab.Store all six trays in the magazine,
and reinstall the magazine in the
CD changer as shown.
PutaCDonthetraywiththe
printed surf ace f acing up as shown.
Reinstall the tray in the magazine.
Repeat this procedure to open the
other f ive trays.
Make sure to slide the CD
changer cover closed until it clicks.
To remove CDs f rom the CD
changer, ref er to the loading
procedure.
3. 4.
5.
6.
7.
CD Changer (Models with navigation system)
Features
183

Page 188 of 352

ÛÝ
T o pl a

y CDs, the ignition switch
must be in the ACCESSORY (I) or
ON (II) position.
You operate the CD changer with
the same controls used f or the in-
dash disc player or the radio. To
select the CD changer, touch the
CDC icon. The disc and track
numbers are displayed. The system
will continuously play a CD until you
change modes. T
o select a dif f erent disc, press the
or side of the TUNE bar. If you select an empty position in the
CD changer, the system will try to
load the CD in the next available
slot.
You can use the preset buttons while
a disc is playing to select passages
and change tracks. Each preset
buttonfunctionisshownonthe
bottom of the screen.
CD Changer (Models with navigation system)
To Play a CD
184
TUNE
BARPRESET BUTTONS
Do not use CDs with adhesive labels.
The label can curl up and cause the CD
to jam in the unit.

Page 189 of 352

µµ µ
µ µ
µ µ µ
Push the button
(preset 6) to play the next track on
the disc. Push the button
(preset5)oncetoreplaythetrackin
play; press it twice to replay the
previous track.
To move more rapidly
within a track, press and hold the (preset 4) or (preset 3)
button.
To
continuously replay a track, press
and release the RPT button (preset
1). You will see TRACK REPEAT in
the display. Press the RPT button
again to turn it off.
To continuously
replay the current CD, press and
hold the RPT button (preset 1) until
you see the DISC REPEAT in the
display. Press it again to turn it of f . Press and release the RDM button
(preset 2) to play the tracks in
random order. You will see TRACK
RANDOM in the display. Press the
RDM button again to return to
normal play.
To play all
tracks in each CD in random order,
press and hold the RDM button
(preset 2) until you see DISC
RANDOM in the display. Press the
RDM button again to return to
normal play.
The SCAN
f unction samples all the tracks on
the selected disc in the order they
are recorded. To activate it, press
and release the SCAN button. You
will see TRACK SCAN in the display,
and you will get a 10 second
sampling of each track on the
selected CD. Press the SCAN button
again to get out of scan mode. Press and hold the
SCAN button to get a 10 second
samplingof thefirstsongof each
disc in the CD changer. You will see
DISC SCAN in the display. Press and
hold the button again to turn it off.
CD Changer (Models with navigation system)
SK IP
FF/REW
REPEAT (Track Repeat)
DISC REPEAT RANDOM (Track Random)
DISC RANDOM
SCA N (T rack Scan)
DISC SCAN
Features
185

Page 190 of 352


Î PresstheAM/FMorCD/XM
buttontoswitchtotheradioor
satellite radio while a CD is playing.
If there is a PC card in the audio unit,
touch the CARD icon to switch to
the PC card while a CD is playing.
Touch the CDC icon again to play
the CD in the CD changer.
If you turn the system of f while a CD
in the CD changer is playing, the CD
will stay in the drive. When you turn
the system back on, the CD will be in
pause mode. Touch the CDC icon on
the audio screen. The CD will begin
playing where it lef t of f .:OnU.S.EX-Lmodelonly
To Stop Playing a CD
CD Changer (Models with navigation system)
186

Page 191 of 352

Insert a dif f erent disc. If the new
disc plays, there is a problem with
the f irst disc. If the error message
cycle repeats and you cannot clear it,
take your vehicle to a dealer. If you see an error message in the
display while playing a disc, f ind the
cause in the chart to the right. If you
cannot clear the error message, take
your vehicle to your dealer.
Thechartontherightexplainsthe
error messages you may see in the
display while playing a disc.
If you see an error message in the
display while playing a disc, press
the eject button. After ejecting the
disc, check it for damage or
deformation. If there is no damage,
insert the disc again.
Theaudiosystemwilltrytoplaythe
disc. If there is still a problem, the
error message will reappear. Press
the eject button, and pull out the disc.Cause Solution
Error
Message
FOCUS Error
Mechanical Error The disc is pulled out.
Check if it is inserted correctly in the disc
player.
Make sure the disc is not scratched or damaged.
Press the eject button, and pull out the disc.
Check the disc for damage or deformation.
If the disc cannot be pulled out, or the error
message does not disappear after the disc is
ejected, see your dealer.
CD Changer (Models with navigation system)
Features
187
DISC ERROR
MECH ERROR

Page 192 of 352

µµ


Playing a PC card (Models with navigation system)
188
REPEAT BUTTON RANDOM
BUTTON
REWIND BUTTON JOYSTICK
TUNE BAR PC CARD ICON
TRACK LIST ICON
U.S. EX-L model
Canadian EX-L model
OPEN
BUTTON
CD/XM
BUTTON
SCAN
BUTTON
AUDIO BUTTON
SKIP
BUTTON
FAST
FORWARD
BUTTON
POWER/VOLUME
KNOB
REPEAT BUTTON
TUNE BAR OPEN
BUTTON
SCAN
BUTTON POWER/VOLUME
KNOB
RANDOM
BUTTON SKIP
BUTTON
FAST
FORWARD
BUTTON
REWIND BUTTON TRACK LIST ICON
PC CARD ICON
PLAY
MODE
ICON AUDIO BUTTON PLAY
MODE
ICON
SKIP
BUTTON
SKIP
BUTTON JOYSTICK
CD/AUX
BUTTON

Page 193 of 352





You operate the PC card player with
the same controls used f or the radio
and the disc player. To load or play a
card, the ignition switch must be in
the ACCESSORY (I) or ON (II)
position.
Based on PCMCIA 2.1/JEIDA 4.2,
the recommended PC cards f or the
PC card reader are: Always use the recommended
memory card with the appropriate
adapter (if an adapter is needed).
Some memory cards will not work in
this unit.
When you insert a PC card into
the slot, make sure you put it in
straight. If you cannot insert it,
remove it, and insert again.
Do not keep PC cards in the
vehicle. Direct sunlight and high
heat will damage them.
To avoid damaging the card
reader, do not insert hard disc
drive cards into the PC card slot.
You cannot close the screen
(move it to the upright position)
until the PC card is inserted all the
way into its slot or removed. Never insert f oreign objects into
the PC card slot.
The specif ications f or compatible
MP3 f iles are: Sampling f requency: 32/44.1/48 kHz (MPEG1)
24/22.05/16 kHz (MPEG2)
Compatible with variable bit rate
and multi-session
Maximum layers
(including ROOT): 8 layers Bit rate: 32/40/48/56/64/80/96/ 112/128/160/192/224/256/
320 kbps (MPEG1)
8/16/24/32/40/48/56/64/
80/96/112/128/160 kbps
(MPEG2)
SD memory card CompactFlash
Flash ATA The PC card player reads and plays
cards in MP3 or WMA f ormats.
Depending on the f ormat, the screen
will indicate ‘‘MP3’’ or ‘‘WMA’’ when
a card is playing. The card limit of
the player is 255 f olders and 999
tracks. If the card has a complex
structure, it takes some time f or the
system to begin playing it. To Play a PC card
Playing a PC card (Models with navigation system)
Features
189
NOTE:

Page 194 of 352




µCompatible with variable bit rate
and multi-session
Maximum layers
(including ROOT): 8 layers
In WMA f ormat, DRM (digital rights
management) f iles cannot be played.
If the system finds a DRM file, it
skips that f ile and plays the next
available f older or f ile. The PC card slot is behind the
navigation screen. To use the PC
card player, press the OPEN button
beside the screen. The screen f olds
back, and the PC card slot appears.Insert a PC card straight into the slot.
The drive will read the PC card and
begin to play it.
Return the screen to the upright
position by pressing the CLOSE
button on the edge of the screen
panel.
Push the AUDIO button beside the
screen to show the audio display and
operate the PC card player.
You can also operate the audio
system without using the control
icons on the audio screen. Press any
of the appropriate control buttons.
The status bar appears on the
bottom of the screen. On the
navigation screen, you can see the
audio inf ormation whenever you
touch the AUDIO INFO icon on the
screen.
The specif ications f or compatible
WMA f iles are:
Sampling f requency:
32/44.1/48 kHz
Bit rate:
48/64/80/96/128/160/192 kbps
Loading a PC Card
Playing a PC card (Models with navigation system)
190
PC CARD SLOT

Page:   < prev 1-10 ... 11-20 21-30 31-40 41-50 51-60 61-70 next >