buttons HONDA CR-V 2011 RD1-RD5, RE7 / 3.G Owners Manual

Î ÎÎ
Î
Î Î Î
Î
Î ÎÎ
To use the horn, press the center pad of the steering wheel.
If equipped.
Ref er to the navigation system manual.
1:2:3:
Your Vehicle at a Glance
4
SHIFT LEVER
HORN
BLUETOOTH HANDSFREELINK SYSTEM
VOICE CONTROL BUTTONS AUDIO SYSTEM
AUDIO SYSTEM
(P.194)
(P.80/115) (P.315)
(P.269)
(P.81)
HEADLIGHTS/
TURN SIGNALS
(P.76)
MIRROR CONTROLS
REMOTE AUDIO CONTROLS
(P.255)
STEERING WHEEL
ADJUSTMENTS
PARKING BRAKE PEDAL
(P.81)
NAVIGATION SYSTEM
VOICE CONTROL SWITCHES
(P.115)
VEHICLE STABILITY
ASSIST (VSA) SYSTEM
OFF SWITCH
(P.325)
CLOCK
(P.259)
(P.145, 157)
INSTRUMENT PANEL BRIGHTNESS
(P.79)
HAZARD WARNING
BUTTON (P.79)
PASSENGER AIRBAG
OFF INDICATOR
(P.33)
WINDSHIELD
WIPERS/WASHERS
(P.75)
(P.266)
CRUISE CONTROL
BUTTONS SEAT HEATER SWITCHES
(P.111)
(P.123)
ACCESSORY POWER SOCKET
REAR WINDOW DEFOGGER BUTTON/
HEATED MIRRORS BUTTON
1
2 2 2
2
3 22
Main Menu

After all occupants have adjusted
their seats and head restraints, and
put on their seat belts, it is very
important that they continue to sit
upright, well back in their seats, with
their feet on the floor, until the
vehicle is safely parked and the
engine is of f .
The front seats have adjustable seat
belt anchors. To adjust the height of
an anchor, press and hold the release
buttons, and slide the anchor up or
down as needed (it has f our
positions). This could cause
very serious injuries in a crash.
See page f or additional
inf ormation about your seat belts
and how to take care of them. Using a seat
belt that is not working properly can
result in serious injury or death.
Have your dealer check the belt as
soon as possible.
If a seat belt does not seem to work
properly, it may not protect the
occupant in a crash.
Sitting improperly can increase the
chance of injury during a crash. For
example, if an occupant slouches,
lies down, turns sideways, sits
forward, leans forward or sideways,
or puts one or both f eet up, the
chance of injury during a crash is
greatly increased.
19 Maintain a Proper Sitting
Position
6.
Never place t he shoulder port ion of a
lap/shoulder belt under your arm orbehind your back.
No one should sit in a seat wit h aninoperat ive seat belt .
Protecting A dults and T eens
16
RELEASE BUTTONS
Main MenuTable of Contents

Î ÎÎ
Î
Î
Î
Î Î ÎÎ Î
To use the horn, press the center pad of the steering wheel.
If equipped.
Ref er to the navigation system manual.
1:2:3:
Controls Near the Steering Wheel
74
PARKING BRAKE PEDAL
HORN
REMOTE AUDIO CONTROLS
STEERING WHEEL
ADJUSTMENTS HEATED MIRROR BUTTON
NAVIGATION SYSTEM
VOICE CONTROL BUTTONS
BLUETOOTH HANDSFREELINK SYSTEM
VOICE CONTROL BUTTONS
(P.325)
(P.255) (P.81)
(P.269)
(P.81)
(P.123)
(P.266)
(P.76)
ACCESSORY POWER SOCKET(P.111)
MIRROR CONTROLS (P.115) HEADLIGHTS/
TURN SIGNALS
VEHICLE STABILITY
ASSIST (VSA) SYSTEM
OFF SWITCH
SEAT HEATER SWITCHESREAR WINDOW DEFOGGER BUTTON (P.80)
(P.115)
HAZARD WARNING
BUTTON
PASSENGER AIRBAG
OFF INDICATOR
INSTRUMENT PANEL BRIGHTNESS
(P.79)
WINDSHIELD
WIPERS/WASHERS
(P.75)
(P.33)
CRUISE CONTROL BUTTONS (P.79)
(P.194)
(P.315)
(P.145, 157) CLOCK
(P.259)
AUDIO SYSTEM
AUDIO SYSTEM
SHIFT LEVER1
2
2
3 2 22 2
Main MenuTable of Contents

Î
Î
: Canadian models
Vents, Heating, and A/C
130
TEMPERATURE
CONTROL DIAL
AIR CONDITIONING
(A/C) BUTTON
FAN CONTROL DIAL
MAX A/C BUTTON RECIRCULATION BUTTON
MODE CONTROL BUTTONS
REAR WINDOW DEFOGGER
LX and U.S. EX models
REAR WINDOW DEFOGGER/
HEATED MIRROR BUTTON
Main MenuTable of Contents

Turn this dial to increase or decrease
the fan speed and airflow.
Turning this dial clockwise increases
the temperature of the airflow.When the recirculation indicator is
on, air f rom the vehicle’s interior is
sent throughout the system again.
When the indicator is off, air is
brought in f rom the outside of the
vehicle (fresh air mode).
The outside air intakes f or the
heating and cooling system are at
the base of the windshield. Keep this
area clear of leaves and other debris.
Thesystemshouldbeleftinfresh
air mode under almost all conditions.
Keeping the system in recirculation
mode, particularly with the A/C of f ,
can cause the windows to fog up.
Switch to recirculation mode when
driving through dusty or smoky
conditions, then return to fresh air
mode.
This button turns the air
conditioning on and of f . The
indicatorinthebuttonisonwhen
the A/C is on.
The system automatically
turns on the A/C and switches to
recirculation mode (see page to
use this setting). Air f lows f rom the
center and side vents in the
dashboard. Pressing the , A/C,
or any of the mode buttons cancels
MAX A/C, but the A/C stays on. Airf low is divided between
the vents in the dashboard and the
f loor vents. Air flows from the center
and corner vents in the dashboard.
Use the mode control buttons to
select the vents air flows from. Some
air will f low f rom the dashboard
corner vents in all modes.
This button turns the rear window
def ogger of f and on (see page ).
Pushing this button also turns the
power mirror heaters on and of f .
/
80
133
CONT INUED
Canadian models only
Vents, Heating, and A/C
Fan Control Dial
T emperature Control Dial
Air Conditioning (A/C) Button Recirculation Button
MAX A/C Button Mode Control
Rear Window Def ogger
Button
Features
131
Main MenuTable of Contents

Playing the AM/FM Radio (LX model)
Features
145
AM
BUTTONFM
BUTTON
PRESET BUTTONS A.SEL/SCAN
BARTUNE KNOB
U.S. and Canadian LX models
SEEK/SKIP BAR
POWER/VOLUMEKNOB
Main MenuTable of Contents

µµ
µ
You can use any of f ive methods to
f ind radio stations on the selected
band: tune, seek, scan, the preset
buttons, and auto select.
Use the TUNE knob to
tune the radio to a desired f requency.
Turn the knob to the right to tune to
a higher f requency, and turn it to the
lef t to tune to a lower f requency.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
power/volume knob or the AM or
FM button. Adjust the volume by
turning the power/volume knob.
The scan f unction samples
all stations with strong signals on the
selected band. To activate it, press
the right side of the A. SEL/SCAN
bar, then release it. You will see
SCAN in the display. The system will
scan f or a station with a strong signal.
When it f inds one, it will stop and
play that station for about 10 seconds.
If you do nothing, the system will
then scan f or the next strong station
and play it f or 10 seconds. When it
plays a station you want to listen to,
press the SCAN side of the bar again.
The band and f requency that the
radio was last tuned to is displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is broad-
castinginstereo.Stereo
reproduction on AM is not available.
The seek f unction
searches up and down f rom the
current f requency to f ind a station
with a strong signal. To activate it,
press the or side of the
SEEK bar, then release it.
To Select a Station
TUNE
To Play the AM/FM Radio
SCAN
SEEK /SK IP
Playing the AM/FM Radio (LX model)
146
Main MenuTable of Contents

µµ µ
If you do not like the stations auto
select has stored, you can store
other f requencies on the preset
buttons as previously described.
For inf ormation on AM/FM radio
f requencies and reception, see page
.
Each preset button can
store one f requency on AM and two
f requencies on FM.
Select the desired band, AM or
FM. You can store one f requency
on FM1, and one f requency on
FM2witheachpresetbutton.
Usethetune,seek,orscan
function to tune the radio to a
desired station.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM. ,pressthe
A. SEL side of the bar. This restores
the presets you originally set.
Press the lef t side of the
A. SEL/SCAN bar. You will see
A. SEL f lashing in the display, and
the system goes into scan mode f or
several seconds. It stores the
f requencies of six AM, and twelve
FM stations in the preset buttons.
You will see a ‘‘0’’ displayed af ter
pressing a preset button if auto
select cannot f ind a strong station f or
every preset button.
Pick a preset button (1 6), and
hold it until you hear a beep. If you are
traveling and can no longer receive
your preset stations, you can use the
auto select feature to find stations in
the local area.
1. 2. 3. 4. 250
To turn of f auto select
Preset A UT O SEL ECT
Playing the AM/FM Radio (LX model)
Features
147
Main MenuTable of Contents

Playing the FM/AM Radio (EX and EX-L models without navigation system)
Features
157
BUTTONBUTTON
BUTTON
EX models
AM BUTTON BUTTON
A.SEL
BUTTON FM
BUTTON
SCAN
BUTTON VOL/SELECT KNOB
VOL/SELECT KNOB
AM BUTTON
A.SEL
BUTTON FM
BUTTON
SCAN
BUTTON
SEEK
BUTTON SEEK
BUTTONSEEK
BUTTON
SEEK
BUTTON
PRESET BUTTONS PRESET BUTTONS PRESET BUTTONS
PRESET BUTTONS
BUTTON BUTTON
EX-L models
Main MenuTable of Contents

µµµ
You can use any of f ive methods to
f ind radio stations on the selected
band: tune, seek, scan, the preset
buttons, and auto select. Use the SEEK button to
tune to a desired f requency. Press
the button to tune to a higher
f requency, and the button to
tune to a lower f requency.
You can also operate the tune
f unction by using the VOL/SELECT
knob. Press the VOL/SELECT knob
and you will see ‘‘SEL’’ in the display.
Turn the knob right to tune to a
higher f requency, or lef t to tune to a
lower f requency. To turn it of f , press
the VOL/SELECT knob or button, or button.
The system will return to the normal
display about 10 seconds af ter you
stop adjusting the tune mode. The SEEK f unction
searches up and down f rom the
current f requency to f ind a station
with a strong signal. To activate it,
press and hold the or side
of the SEEK button until you hear a
beep, then release it.
The scan f unction samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
When the system finds a strong
signal, it will stop and play that
station f or about 10 seconds.
If you do nothing, the system will
then scan f or the next strong station
and play it f or 10 seconds. When it
plays a station you want to listen to,
press the SCAN button again.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
FM or AM button. Adjust the volume
by turning the VOL/SELECT knob.
The band and f requency that the
radio was last tuned to are displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is
broadcasting in stereo. Stereo
reproduction in AM is not available.
To Play the FM/AM Radio
To Select a Station T UNE SEEK
SCAN
Playing the FM/AM Radio (EX and EX-L models without navigation sys tem)
158
Main MenuTable of Contents