start stop button HONDA ELEMENT 2003 1.G Owners Manual

µ
CONT INUED
The shif t lever has six positions. It
must be in Park or Neutral to start
the engine. When you are stopped in
D, 2, 1, N, or R, press f irmly on the
brake pedal, and keep your f oot of f
the accelerator pedal.YoucannotshiftoutofParkwiththe
brake pedal pressed when the
ignition switch is in LOCK (0) or
ACCESSORY (I).
This position mechani-
cally locks the transmission. Use
Park whenever you are turning of f or
starting the engine. To shif t out of
Park, you must press on the brake
pedal and have your f oot of f the
accelerator pedal. Press the release
button on the side of the shift lever
to move it out of park.
To shift from:
PtoR
RtoN
NtoD Dto2 2to1
1to2
2toD
DtoN NtoR RtoP Do this:
Press the brake pedal and
press the release button.
Press the release button.
Move the lever.
Automatic Transmission
Driving
Shif t L ever Positions
Park (P)
179
SHIFT LEVER

µ
µ Use Neutral if you
need to restart a stalled engine, or if
it is necessary to stop brief ly with
the engine idling. Shif t to Park posi-
tion if you need to leave the vehicle
f or any reason. Press on the brake pe-
dal when you are moving the shif t
lever from Neutral to another gear.
If you have done all of the above and
still cannot move the lever out of
Park, see Shif t Lock Release on page
. Your vehicle has a reverse lockout so
you cannot accidentally shif t to
Reverse when the vehicle speed
exceeds 5 mph (8 km/h).
You must also press the release
button to shift into Park. To avoid
transmission damage, come to a
complete stop bef ore shif ting into
Park. The shif t lever must be in Park
bef ore you can remove the key f rom
the ignition switch. To shif t to Reverse
f rom Park, see the explanation under
Park. To shif t to Reverse f rom
Neutral, come to a complete stop and
then shift. Press the release button
bef ore shif ting into Reverse f rom
Neutral. If you cannot shif t to Reverse when
the vehicle is stopped, press the
brake pedal, and slowly shift to
Neutral. Then press the release
button, and shift to Reverse.
If there is a problem in the reverse
lockout system, or your vehicle’s
battery is disconnected or goes dead,
you cannot shif t to Reverse. (Ref er
to Shif t Lock Release on page ).
183
183
Neutral (N)
Reverse (R)
Automatic Transmission
Driving180

µµ
The O/D OFF indicator also comes
on f or a f ew seconds when you turn
the ignition switch to ON(II). When overdrive is of f , the
transmission selects only the f irst
three gears. Turn the O/D of f to
provide engine braking when going
down a steep hill. You can also avoid
the transmission f rom cycling
between third and f ourth gears in
stop-and-go driving. To shif t to Second,
pressthereleasebuttonontheside
of the shif t lever. This position locks
the transmission in second gear. It
does not downshif t to f irst gear
when you come to a stop. Second
gives you more power when climbing,
and increased engine braking when
going down steep hills. Use second
gear when starting out on a slippery
surf ace or in deep snow. It will help
reduce wheelspin. If you exceed the maximum speed
f or the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may f eel
the engine cut in and out. This is
caused by a limiter in the engine’s
computer controls. The engine will
run normally when you reduce the
RPM below the red zone.
To shif t f rom Second to
First, press the release button on the
side of the shift lever. With the lever
in this position, the transmission
locks in f irst gear. By upshif ting and
downshif ting through 1, 2, and D,
you can operate this transmission
much like a manual transmission
without a clutch pedal.
If you shif t into First when the
vehiclespeedisabove31mph(50
km/h), the transmission shifts into
second gear f irst to avoid sudden
engine braking.
Automatic Transmission
Driving
Second (2) Engine Speed L imiter
First (1)
182