belt HONDA PILOT 2012 2.G Owner's Guide

Push and pull the child seat
f orward and f rom side-to-side to
verif y that it is secure enough to
stay upright during normal driving
maneuvers. If the child seat is not
secure, unlatch the belt, allow it to
retract f ully, then repeat these
steps.A child seat with a tether can be
installed in any seating position in
the second or third row.
To deactivate the lockable retractor
and remove a child seat, unlatch the
buckle, unroute the seat belt, and let
the belt fully retract. Since a tether can provide additional
security to the lap/shoulder belt
installation, we recommend using a
tether whenever one is required or
available.
Af ter conf irming that the belt is
locked, grab the shoulder part of
the belt near the buckle, and pull
up to remove any slack from the
lap part of the belt. Remember, if
the lap part of the belt is not tight,
the child seat will not be secure.
To remove slack, it may help to
putweightonthechildseat,or
push on the back of the seat while
pulling up on the belt.
4.
5.
CONT INUED
Installing a Child Seat with a
Tether
Installing a Child Seat
Driver and Passenger Saf ety
53
Table of ContentsMain Menu

When a child reaches the
recommended weight or height limit
for a forward-facing child seat, the
child should sit in a back seat on a
booster seat and wear the lap/
shoulder belt.
The f ollowing pages give
instructions on how to check proper
seat belt f it, what kind of booster
seat to use if one is needed, and
important precautions f or a child
who must sit in f ront.To determine if a lap/shoulder belt
properly f its a child, have the child
put on the seat belt, then ask
yourself :
Does the child sit all the way back
against the seat?
Do the child

Does the shoulder belt cross
between the child

If a child who uses a booster seat
must ride in f ront, move the vehicle
seat as far back as possible and be
sure the child is wearing the seat
belt properly.
A child may continue using a booster
seat until the tops of their ears are
even with the top of the vehicle

Î Î
Î
Î
Î
Î Î
The U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the tex
t.
4WD models only
If equipped
1:2:
Instrument Panel
Inst rument s and Cont rols
Except T ouring models
65
CRUISE MAIN INDICATOR
PARKING BRAKE AND BRAKE
SYSTEM INDICATOR
STARTER SYSTEM INDICATOR LOW FUEL INDICATOR
MALFUNCTION INDICATOR LAMP
SECURITY SYSTEM INDICATORWASHER LEVEL INDICATOR
SIDE AIRBAG OFF
INDICATOR
LOW OIL PRESSURE INDICATOR
VTM-4 INDICATOR
CHARGING SYSTEM INDICATOR
FUEL ECONOMY INDICATOR
A/T TEMPERATURE
INDICATOR
LOW TIRE PRESSURE
INDICATOR
VEHICLE STABILITY ASSIST (VSA)
SYSTEM INDICATOR
INFORMATION DISPLAY
IMMOBILIZER SYSTEM
INDICATOR TIRE PRESSURE MONITORING SYSTEM (TPMS) INDICATOR
FOG LIGHT
INDICATOR LIGHTS ON INDICATOR
POWER TAILGATE INDICATOR
ANTI-LOCK BRAKE SYSTEM
INDICATORCRUISE CONTROL
INDICATOR
SEAT BELT REMINDER
INDICATOR
DOOR-OPEN INDICATOR
MAINTENANCE MINDER INDICATOR (P.75)
(P.68)
(P.68)
(P.75)
DAYTIME RUNNING LIGHTS
INDICATOR (P.77) (P.68)
(P.77)
(P.74)
(P.72)
VSA OFF INDICATOR
(P.76) (P.81) (P.76)
(P.70) (P.73)
(P.74)
(P.76)
(P.76)
(P.70) (P.76)
HIGH BEAM INDICATOR (P.76)
(P.69)
(P.67)
SUPPLEMENTAL RESTRAINT SYSTEM
INDICATOR (P.70)
(P.77)
(P.78)
(P.78)
(P.79)
(P.73)
(P.71)
(P.71)
1
1
2
2 1
Main MenuTable of Contents

Î
Î
Î
The U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the tex
t.
: 4WD models only
Instrument Panel
On T ouring models
66
CRUISE MAIN INDICATOR
FOG LIGHT
INDICATOR
DOOR-OPEN INDICATOR
MESSAGE INDICATOR
SECURITY SYSTEM INDICATOR
IMMOBILIZER SYSTEM
INDICATOR
MULTI-INFORMATION DISPLAY LOW FUEL INDICATOR
LIGHTS ON INDICATOR
CRUISE CONTROL INDICATOR
LOW TIRE PRESSURE/
TPMS INDICATOR SIDE AIRBAG OFF INDICATOR
A/T TEMPERATURE INDICATOR
FUEL ECONOMY INDICATOR
MALFUNCTION INDICATOR LAMP
CHARGING SYSTEM INDICATOR
VTM-4 INDICATOR
LOW OIL PRESSURE INDICATOR
VEHICLE STABILITY ASSIST (VSA)
SYSTEM INDICATOR (P.68)
(P.75) (P.68)
(P.68)
(P.77) (P.74)
(P.72)
VSA OFF INDICATOR
(P.76) (P.85)(P.76)
(P.70)
(P.76)(P.76)
ANTI-LOCK BRAKE SYSTEM
INDICATOR (P.70)
(P.76)
(P.78) (P.77)
(P.75)
(P.79)
HIGH BEAM INDICATOR
PARKING BRAKE AND BRAKE
SYSTEM INDICATOR
SEAT BELT REMINDER
INDICATOR (P.76)
(P.69)
(P.67)
SUPPLEMENTAL
RESTRAINT SYSTEM
INDICATOR (P.70)
(P.71)
(P.71)
Main MenuTable of Contents

The instrument panel has many
indicators to give you important
inf ormation about your vehicle. This indicator comes on when youturn the ignition switch to the ON
(II) position. It reminds you and your
passengers to f asten your seat belts.
A beeper also sounds if you have not
f astened your seat belt.
If your f ront passenger does not
f asten their seat belt, the indicator
comes on about 6 seconds af ter the
ignition switch is turned to the ON
(II) position. If either of you do not f asten your
seat belt while driving, the beeper
will sound and the indicator will f lash
again at regular intervals. For more
inf ormation, see page .
You will also see a ‘‘FASTEN SEAT
BELT

This indicator comes on when there
is a system message on the multi-
inf ormation display. Press the INFO
button on the steering wheel (see
page ) to see the message (see
page ).
Most of the time, this indicator
comes on along with other indicators
in the instrument panel such as the
seat belt reminder indicator, SRS
indicator, VSA system indicator, etc.
This indicator comes on f or a f ew
seconds when you turn the ignition
switch to the ON (II) position. It
remindsyouthatitistimetotake
your vehicle in f or scheduled
maintenance. The maintenance main
items and sub items will be displayed
in the inf ormation display. See page
f or more inf ormation on the
Maintenance Minder .
This indicator goes of f when your
dealer resets it after completing the
required maintenance service. This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. If it comes on at any other
time, there is a problem in the 4WD
system. Take the vehicle to your
dealer to have it checked.
If the indicator blinks while driving,
the VTM-4 fluid temperature is too
high. Pull to the side of the road
when it is saf e, shif t to Park, and let
the engine idle until the indicator
goes out.
85
92
559
4WD models only
Except Touring models On Touring models
Message Indicator
Maintenance Minder
Indicator VTM-4 Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
75
TM
Continuing to drive with the VTM-4
indicator blinking may cause serious
damage to the system.
Main MenuTable of Contents

The left and right halves can be
f olded separately.To unlatch the detachable anchor
bef ore f olding the seat-back, insert
the latch plate into the slot on the
side of the anchor buckle (see
page ) and allow the seat belt
to retract. Store the detachable
anchor and seat belt latch plates in
the retractor housing.
Lower the head restraints to their
lowest positions.
Pull up the handle on the outside
of the seat-back.
Fold the seat-back forward. Reverse this procedure to return the
seat to the upright position. Make
sure the seat is locked securely
bef ore driving.
Make sure that the folded seat-back
does not press against the f ront
passenger

Use the latch plate to release the
seat belt from the detachable
anchor (see page ).
Lower the head restraints to their
lowest positions.To f old the third row seat,
the second row seat-back must be
f olded down or in the f ull up right
position.
Unlock the seat-back by pulling
the handle. Push the seat-back
forward.
Make sure the outer shoulder belts
are positioned in each holding slot on
the side panel whenever the third
seat is f olded. Reverse this procedure to return the
seat to the upright position. Make
sure the seat is locked securely
bef ore driving. Reconnect the seat
belts to the detachable anchors.
Make sure all items in the cargo area
are secured. Loose items can f ly
f orward and cause injury if you have
to brake hard (See
on page ).
1. 2.
3.
163
506
Folding the T hird Row Seat
Carrying Cargo
Seats
162
NOTE:
HANDLE
Third seat
Main MenuTable of Contents