AUX HUMMER H2 2007 User Guide

Page 278 of 570

DVD Control Buttons
To bring up the DVD control buttons, briey press
the power button located on the face of the
monitor. This toggles the on-screen soft key
choices to either monitor or DVD control.
If the power button is pressed for more than
two seconds, the power could turn off.
AV Input Jack (Audio/Video Input Jack):The
audio/video input jack allows viewing of auxiliary
sources such as portable DVD players, gamestations, or video cameras, on each monitor
individually. The AV input jack is located on the
lower left side of the monitor and is identied
on the monitor as the AUX (auxiliary) input jack.
P(Power):Press this button to turn the DVD
player on and off. Press this button briey to toggle
between monitor and DVD on-screen functions.
X(Eject):The eject button is located on the
DVD player next to the DVD loader slot. Press this
button to eject the disc. If the ejected disc is
partially left in the DVD player, the disc does not
reload until it is pushed back into the player.
r(Play):Press the soft key button on the
monitor, located under the play symbol to start
playback of a disc. On DVDs and video CDs with
playback control (PBC), menu screens can display
automatically. It might be necessary to press the
play soft key button again to begin playing.
There is a play position memory feature for DVD
and video CD only. If the DVD player is turned off
and then turned back on, the DVD player resumes
playback from the same point it stopped. The play
position memory is erased if the disc is removed.
278

Page 284 of 570

Battery Replacement
To change the remote control batteries, do the
following:
1. Slide the battery door, located on the back of
the remote control, down.
2. Replace the two AAA batteries in the
compartment. Make sure they are installed
correctly, using the diagram on the inside
of the battery compartment.
3. Close the battery door.
If the remote control is to be stored for a long
period of time, remove the batteries and keep them
in a cool, dry place.
Using the RSE On-Screen
Display (OSD) Menu
To use the RSE OSD menu while using the DVD
player or an auxiliary device, do the following:
1. Press the SETUP button on the system’s
remote control to access the general setup
menu, see “Remote Control” earlier in
this section.
2. Once this menu is on the screen, press the
directional arrows and then the ENTER
button to navigate the screen.
This menu lets you select default preferences
for language, video, audio, and ratings.
Not all DVDs support all of the feature defaults
in the setup menus. If a feature is not
supported, the defaults are provided by the
DVD media.
The default language selection applies to all
future DVDs.
3. Press the RETURN button on the system’s
remote control to exit this menu, or wait for
the menu to time out.
284

Page 285 of 570

To use the RSE OSD menu while using a CD or
an MP3, do the following:
1. Make sure a CD or an MP3 is loaded in the
RSE system and that the system is not in
auxiliary, then press the SETUP button on the
system’s remote control.
2. Once the general setup menu is on the
screen, press the directional arrows on
the system’s remote control and then the
ENTER button to navigate the screen.
This menu lets you select default preferences
for language and playback settings.
3. Press the RETURN button on the system’s
remote control to exit this menu, or wait for
the menu to time out.Advanced MP3 CD Menu Displays and
Operation
To use the RSE OSD menu for advanced MP3
CD menu displays and operation, do the following:
1. Insert an MP3 CD and then select it for
playback from the RSE on-screen display
menu. The name of the folder shows on the
monitor’s top line and the names of songs
show in columns underneath.
When an MP3 is selected for play, all les
and folders are accessed in the order in which
they were written to the CD. Because of
this, the order in which they are expected to
play might not match the order in which
they are actually played.
2. Press the directional arrows on the system’s
remote control to help navigate through the
folders, then press ENTER or PLAY to
start playing a selection.
3. You can also press the GO button on the
system’s remote control to directly access
the Songs. See “GO” under Remote Control
Buttons (DVD Control Functions) earlier in
this section.
285

Page 506 of 570

Fuses Usage
LT TRNLeft Turn Signals and
Sidemarkers
VEH STOPVehicle Stoplamps, Brake
Module, Electronic Throttle
Control Module
RT TRLR ST/TRN Right Turn Signal/Stop Trailer
RT TRNRight Turn Signals and
Sidemarkers
BODY Harness Connector
DDM Driver Door Module
LOCKSRear Doors and Liftgate
Power Lock Relay Feed
ECC Liftgate
TBC 2C Truck Body Controller
FLASH Flasher Module
CB LT DOORSLeft Rear Power Window
Circuit Breaker and Driver
Door Module
TBC 2B Truck Body Controller
TBC 2A Truck Body Controller
Circuit Breaker Usage
AUX PWR 2 Midgate Controller (SUT Only)
Center Instrument Panel Fuse Block
The center instrument panel utility block is
located underneath the instrument panel, to the
left of the steering column.
Device Usage
SEO Special Equipment Option
TRAILERTrailer Brake Wiring,
Off-Road Lamps Harness
Connector
UPFIT Uptter (Not Used)
SL RIDE Ride Control (Not Used)
HDLR 2Headliner Wiring
Connector 2
506

Page 509 of 570

*1— Gasoline Engine and Fuel Injection Rail #2.
*2— Gasoline Engine and Fuel Injection Rail
#1.
*3— Gasoline Engine; Oxygen Sensors.
*4— Gasoline Engine; Oxygen Sensors.
*5— Ignition 1
*6— Powertrain Control Module, Fuel Pump.
*7— Supplemental Brake Assist.
*8— Sunroof.
Fuses Usage
GLOW PLUG Not Used
CUST FEED Gasoline Accessory Power
HYBRID Not Used
WSW/HTRHeated Windshield Washer
(Special Edition Only)
STUD #1Accessory Power/Trailer
Wiring
MBEC 1Mid Bussed Electrical Center
Power Feed, Front Seats,
Right Doors
Fuses Usage
BLWR Front Climate Control Fan
LBEC 2Left Bussed Electrical Center,
Door Modules, Door Locks,
Auxiliary Power Outlet—Rear
Cargo Area and Instrument
Panel
STUD #2*Accessory Power/Trailer
Wiring Brake Feed
ABS Anti-lock Brakes
VSES/ECASElectronically Controlled Air
Suspension
IGN A Ignition Switch
IGN B Ignition Switch
LBEC 1Left Bussed Electrical Center,
Left Doors, Truck Body
Controller, Flasher Module
TRL PARK Parking Lamps Trailer Wiring
RR PARKPassenger’s Side Rear
Parking and Sidemarker
Lamps
LR PARKDriver’s Side Rear Parking
and Sidemarker Lamps
509

Page 510 of 570

Fuses Usage
PARK LP Parking Lamps Relay
STRTR Starter Relay
INTPARK Roof Marker Lamps
STOP LP Stoplamps
TBC BATTTruck Body Controller
Battery Feed
SEO B2 Off-Road Lamps
4WS Not Used
AUX PWRInstrument Panel Outlets,
Rear Cargo Area Power
Outlets, Console
PCM 1 Powertrain Control Module
ETC/ECMElectronic Throttle Control,
Electronic Brake Controller
IGN EInstrument Panel Cluster,
Air Conditioning Relay, Turn
Signal/Hazard Switch, Starter
Relay, Electronic Brake
Controller TC2 Mode Switch
RTDElectronic Brake Controller
Battery FeedFuses Usage
TRL B/U Backup Lamps Trailer Wiring
F/PMP Fuel Pump (Relay)
B/U LPBack-up Lamps, Automatic
Transmission Shift Lock
Control System
RR DEFOG Rear Window Defogger
HDLP-HI Headlamp High Beam Relay
PRIME Not Used
AIRBAGSupplemental Inatable
Restraint System
FRT PARKFront Parking Lamps,
Sidemarker Lamps
DRLDaytime Running Lamps
(Relay)
SEO IGN Rear Defog Relay
TBC IGN1 Truck Body Controller Ignition
HI HDLP-LTDriver’s Side High Beam
Headlamp
LH HID Not Used
DRL Daytime Running Lamps
510

Page:   < prev 1-10 11-20