HYUNDAI I10 2020 Service Manual

3-9
03
Seat cushion height
(for driver’s seat, if equipped)
OAC3039004R
To change the height of the seat
cushion:
‡Push down the lever several times,
to lower the seat cushion.
‡Pull up the lever several times, to
raise the seat cushion.
Armrest
(for driver’s seat, if equipped)
OAC3039005R
Pull the armrest down to use it.
Seatback pocket (if equipped)
OAI3039033
The seatback pocket is provided on
the back of the front seatback.
CAUTION
Do not put heavy or sharp objects
in the seatback pockets. In an acci-
dent they could come loose from
the pocket and injure occupants.

3-10
Safety system
Rear seats (if equipped)
The rear seatbacks can be folded to
facilitate carrying long items or to
increase the luggage capacity of the
vehicle.
WARNING
‡Never allow passengers to sit on
top of the folded down seatback
whilst the vehicle is moving. This
is not a proper seating position
and no seat belts are available
for use. This could result in seri-
ous injury or death in case of an
accident or sudden stop.
‡Objects carried on the folded
down seatback should not
extend higher than the top of the
front seatbacks. This could allow
cargo to slide forward and cause
injury or damage during sudden
stops.1. Set the front seatback to the
upright position and if necessary,
slide the front seat forward.
2. Lower the rear head restraints to
the lowest position (if equipped
with adjustable head restraints).
OAI3039010
3. Insert the rear lap/shoulder belt
plate into the holder on the side
trim. It will prevent the lap/shoulder
belt from interfering with the seat-
back when folding.

3-11
03
OAC3039006TU
OAC3039007TU
4. Pull up the seatback lever and fold
the seatback toward the front of
the vehicle.
To use the rear seat, lift and push up
the seatback backward. Push the
seatback firmly until it clicks into
place. Make sure the seatback is
locked in place.
When returning the rear seatbacks to
the upright position, remember to
return the rear shoulder belts to their
proper position.
WARNING
When you return the rear seatback
to its upright position after being
folded down:
Be careful not to damage the seat
belt webbing or buckle. Do not
allow the seat belt webbing or
buckle to get caught or pinched in
the rear seat. Ensure that the seat-
back is completely locked into its
upright position by pushing on the
top of the seatback. Otherwise, in
an accident or sudden stop, the
seat could fold down and allow
cargo to enter the passenger com-
partment, which could result in
serious injury or death.
NOTICE
‡When returning the rear seat-
backs to the upright position,
remember to return the rear
shoulder belts to their proper
position.
‡Routing the seat belt webbing
through the rear seat belt guides
will help keep the seat belts from
being trapped behind or under
the seats.

3-12
Safety system
WARNING
Cargo
Cargo should always be secured
to prevent it from being thrown
about the vehicle in a collision and
causing injury to the vehicle occu-
pants. Do not place objects in the
rear seats, since they cannot be
properly secured and may hit the
front seat occupants in a collision.
WARNING
Cargo loading
Make sure the engine is off, the
Automated manual transmission
is in N (Neutral) or the Manual
transmission is in R (Reverse) or
1st, and the parking brake is
securely applied whenever loading
or unloading cargo. Failure to take
these steps may allow the vehicle
to move if the shift lever is inadver-
tently moved to another position.
Head restraint
The vehicle’s front and rear seats
have adjustable head restraints. The
head restraints provide comfort for
passengers, but more importantly
they are designed to help protect
passengers from whiplash and other
neck and spinal injuries during an
accident, especially in a rear impact
collision.
WARNING
To reduce the risk of serious injury
or death in an accident, take the
following precautions when adjust-
ing your head restraints:
‡Always properly adjust the head
restraints for all passengers
BEFORE starting the vehicle.

3-13
03

ODN8039067L
Adjust the head restraints so the
middle of the head restraints is
at the same height as the height
of the top of the eyes.
‡NEVER adjust the head restraint
position of the driver’s seat when
the vehicle is in motion.
‡Adjust the head restraint as
close to the passenger’s head as
possible. Do not use a seat cush-
ion that holds the body away
from the seatback.
‡Make sure the head restraint
locks into position after adjust-
ing it.
NOTICE
To prevent damage, NEVER hit or
pull on the head restraints.
CAUTION
When there is no occupant in the
rear seats, adjust the height of the
head restraint to the lowest posi-
tion. The rear seat head restraint
can reduce the visibility of the rear
area.
Front seat head restraints
OOSEV038012L
The driver’s and front passenger’s
seats are equipped with adjustable
head restraints for the passengers
safety and comfort.
OGB034007
Forward and rearward adjustment
The head restraint may be adjusted
forward to 3 different positions by
pulling the head restraint forward to
the desired detent. To adjust the
head restraint to it’s furthest rear-
wards position, pull it fully forward to
the farthest position and release it.

3-14
Safety system
OAC3039039R
Adjusting the height up and down
To raise the head restraint:
1. Pull it up to the desired position (1).
To lower the head restraint:
1. Push and hold the release button
(2) on the head restraint support.
2. Lower the head restraint to the
desired position (3).
NOTICE
OHI038136
If you recline the seatback towards
the front with the head restraint
and seat cushion raised, the head
restraint may come in contact with
the sunvisor or other parts of the
vehicle.
OAC3039041R
Removal/Reinstall
To remove the head restraint:
1. Recline the seatback (2) using the
seatback angle lever or switch (1).
2. Raise head restraint as far as it
can go.
3. Press the head restraint release
button (3) whilst pulling the head
restraint up (4).
WARNING
NEVER allow anyone to travel in a
seat with the head restraint
removed.

3-15
03
OAC3039040R
To reinstall the head restraint :
1. Recline the seatback.
2. Put the head restraint poles (2) into
the holes whilst pressing the
release button (1).
3. Adjust the head restraint to the
appropriate height.
4. Recline the seatback (4) using


seatback angle lever or switch (3).
WARNING
Always make sure the head
restraint locks into position after
reinstalling and adjusting it prop-
erly.
Rear seat head restraints
OAI3039007
* : 5 Seater
The rear seats are equipped with
head restraints in all the seating posi-
tions for the passenger’s safety and
comfort.
OAI3039008
Adjusting the height up and down
To raise the head restraint:
1. Pull it up to the desired position (1).
To lower the head restraint:
1. Push and hold the release button
(2) on the head restraint support.
2. Lower the head restraint to the
desired position (3).

3-16
Safety system
OAI3039009
Removal and installation
To remove the head restraint :
1. Raise it as far as it can go.
2. Press the release button (1) whilst
pulling upward (2).
To reinstall the head restraint :
1. Put the head restraint poles (3) into
the holes whilst pressing the
release button (1).
2. Adjust the head restraint to the
appropriate height.
Seat warmers (if equipped)
Seat warmers are provided to warm
the seats during cold weather.
WARNING
The seat warmers can cause a
SERIOUS BURN, even at low tem-
peratures and especially if used
for long periods of time.
Passengers must be able to feel if
the seat is becoming too warm so
they can turn it off, if needed.
People who cannot detect temper-
ature change or pain to the skin
should use extreme caution, espe-
cially the following types of pas-
sengers:
‡Infants, children, elderly or dis-
abled persons, or hospital outpa-
tients.
‡People with sensitive skin or
who burn easily.
‡Fatigued individuals.
‡Intoxicated individuals.
‡People taking medication that
can cause drowsiness or sleepi-
ness.

3-17
03
WARNING
NEVER place anything on the seat
that insulates against heat when
the seat warmer is in operation,
such as a blanket or seat cushion.
This may cause the seat warmer to
overheat, causing a burn or dam-
age to the seat.
NOTICE
To prevent damage to the seat
warmers and seats:
‡Never use a solvent such as
paint thinner, benzene, alcohol
or petrol to clean the seats.
‡Do not place heavy or sharp
objects on seats equipped with
seat warmers.
‡Do not change the seat cover. It
may damage the seat warmer or
air ventilation system.
OAC3039008TU
Whilst the engine is running, push
either of the switches to warm the
driver’s seat or front passenger’s
seat.
During mild weather or under condi-
tions where the operation of the seat
warmer is not needed, keep the
switches in the OFF position.
‡Each time you push the switch, the
temperature setting of the seat is
changed as follows:


OFFJHIGH ()JMIDDEL ()JLOW ()
K
‡The seat warmer defaults to the
OFF position whenever the ignition
switch is turned on.
‡When pressing the switch for more
than 1.5 seconds with the seat
warmer operating, the seat warmer
will turn OFF.

3-18
Safety system
SEAT BELTS
This section describes how to use the
seat belts properly. It also describes
some of the things not to do when
using seat belts.
Seat belt safety precautions
Always fasten your seat belt and
make sure all passengers have fas-
tened their seat belts before starting
any trip. Air bags (if equipped) are
designed to supplement the seat belt
as an additional safety device, but
they are not a substitute. Most coun-
tries require all occupants of a vehicle
to wear seat belts.
WARNING
Seat belts must be used by ALL
passengers whenever the vehicle
is moving. Take the following pre-
cautions when adjusting and wear-
ing seat belts:
‡ALWAYS properly restrain chil-
dren under age 13 in the rear
seats.
‡NEVER allow children to ride in
the front passenger seat. If a
child age 13 or older must be
seated in the front seat, move the
seat as far back as possible and
properly restrain them in the
seat.
‡NEVER allow an infant or child to
be carried on an occupant’s lap.
‡NEVER ride with the seatback
reclined when the vehicle is mov-
ing.
‡Do not allow children to share a
seat or seat belt.
‡Do not wear the shoulder belt
under your arm or behind your
back.‡Never wear a seat belt over frag-
ile objects. If there is a sudden
stop or impact, the seat belt can
damage it.
‡Do not use the seat belt if it is
twisted. A twisted seat belt will
not protect you properly in an
accident.
‡Do not use a seat belt if the web-
bing or hardware is damaged.
‡Do not latch the seat belt into the
buckles of other seats.
‡NEVER unfasten the seat belt
whilst driving. This may cause
loss of vehicle control resulting
in an accident.
‡Make sure there is nothing in the
buckle interfering with the seat
belt latch mechanism. This may
prevent the seat belt from fasten-
ing securely.
‡No modifications or additions
should be made by the user
which will either prevent the seat
belt adjusting devices from oper-
ating to remove slack, or prevent
the seat belt assembly from
being adjusted to remove slack.
WARNING
Damaged seat belts and seat belt
assemblies will not operate prop-
erly. Always replace:
‡Frayed, contaminated, or dam-
aged webbing.
‡Damaged hardware.
‡The entire seat belt assembly
after it has been worn in an acci-
dent, even if damage to webbing
or assembly is not apparent.