heating HYUNDAI I10 2021 Owners Manual

4-4
Instrument cluster
Engine Coolant Temperature
Gauge
OJS048104L
This gauge indicates the temperature
of the engine coolant when the igni-
tion switch is in the ON position.
NOTICE
If the gauge pointer moves beyond
the normal range area toward the
“130” position, it indicates over-
heating that may damage the
engine.
Do not continue driving with an
overheated engine. If your vehicle
overheats, refer to “If the Engine
Overheats” in chapter 7.
WARNING
Never remove the radiator cap or
reservoir cap when the engine is
hot. The engine coolant is under
pressure and could cause severe
burns. Wait until the engine is cool
before adding coolant to the reser-
voir.
Fuel Gauge
OAC3049005R
This gauge indicates the approximate
amount of fuel remaining in the fuel
tank.
i Information
‡ 7he fuel tank capacity is given in
chapter 2.
‡ 7he fuel gauge is supplemented by a
low fuel warning light, which will
illuminate when the fuel tank is
nearly empty.
‡ 2n inclines or curves, the fuel gauge
pointer may fluctuate or the low fuel
warning light may come on earlier
than usual due to the movement of
fuel in the tank.

4-24
Instrument cluster
Low engine oil (if equipped)
This warning message is displayed
when the engine oil level should be
checked.
If this warning message is displayed,
check the engine oil level as soon as
possible and add engine oil as
required.
Slowly pour the recommended oil lit-
tle by little into a funnel. (Oil refill
capacity : approximately 0.15 ~ 0.26
gal. (0.6 ~ 1.0 l)
Use only the specified engine oil.
(Refer to "Recommended lubricants
and capacities" in chapter 8.)
Do not overfill the engine oil. Make
sure the oil level is not above F (Full)
mark on the dipstick.
NOTICE
If the message is displayed contin-
uously after adding the engine oil
and travelling approximately
50~100 km after the engine warms
up, we recommend that the system
be checked by a HYUNDAI autho-
rised repairer.
Engine has overheated
(if equipped)
This warning message is displayed
when the engine coolant temperature
is above 120°C (248°F). This means
that the engine is overheated and
may be damaged.
If your vehicle is overheated, refer
to “Overheating” in chapter 7.
Check headlight (if equipped)
This warning message is displayed if
the headlamps are not operating
properly.
In addition, if a specific lamp(turn sig-
nal lamp etc.) is not operating proper-
ly, the warning message according to
a specific lamp (turn signal lamp etc.)
is displayed. A corresponding bulb
may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same watt-
age rating.
Check brake light (if equipped)
This warning message is displayed if
the stop lamps are not operating
properly. A lamp may need to be
replaced.
Make sure to replace the burned out
bulb with a new one of the same watt-
age rating.

5
Rear view monitor (RVM) ................................................................................ 5-48
Reverse parking distance warning (PDW) ..................................................... 5-49
Manual climate control system .......................................................................5-53
Heating and air conditioning ........................................................................5-54
System operation ..........................................................................................5-58
System maintenance .....................................................................................5-59
Automatic climate control system ..................................................................5-62
Automatic heating and air conditioning ......................................................5-63
Manual heating and air conditioning .......................................................... 5-64
System operation ......................................................................................... 5-68
System maintenance ..................................................................................... 5-70
Windscreen defrosting and defogging ........................................................... 5-73
Automatic climate control system ............................................................... 5-74
Defroster ........................................................................................................ 5-75
Storage compartment ...................................................................................... 5-77
Centre console storage ................................................................................. 5-77
Glove box ....................................................................................................... 5-78
Interior features ............................................................................................... 5-79
Cigarette lighter ............................................................................................. 5-79
Ashtray ........................................................................................................... 5-79
Cup holder .................................................................................................... 5-80
Sunvisor .......................................................................................................... 5-81
Power outlet ...................................................................................................5-82
USB charger .................................................................................................. 5-83
Wireless mobile phone charging system .................................................... 5-83
Clock .............................................................................................................. 5-86
Coat hook ...................................................................................................... 5-86
Floor mat anchor(s) ....................................................................................... 5-87
Luggage net (holder) .................................................................................... 5-88
Cargo area cover .......................................................................................... 5-88
Exterior features .............................................................................................. 5-89
Roof rack ....................................................................................................... 5-89
Infotainment system ....................................................................................... 5-90
USB port ........................................................................................................ 5-90
Antenna ......................................................................................................... 5-90

5-54
Convenient features
Heating and air conditioning
1. Start the engine.
2. Set the mode to the desired posi-
tion.
To improve the effectiveness of
heating and cooling :
- Heating:
- Cooling:
Mode selection
OAC3059100R
3. Set the temperature control to the
desired position.
4. Set the air intake control to Fresh
mode.
5. Set the fan speed control to the
desired speed.
6. If air conditioning is desired, turn
the air conditioning system on.

5-58
Convenient features
System operation
Ventilation
1. Select the Face Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
Heating
1. Select the Floor Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
5. If desired, turn the air conditioning
ON with the temperature control
knob set to heat in order to dehu-
midify the air before it enters into
the cabin.
If the windscreen fogs up, select the
Floor & Defrost
mode or press
the Front Defrost
mode.
2peration 7ips

5-59
05
i Information
‡ When using the air conditioning sys-
tem, monitor the temperature gauge
closely whilst driving up hills or in
heavy traffic when outside tempera-
tures are high. Air conditioning sys-
tem operation may cause engine
overheating. Continue to use the
blower fan but turn the air condi-
tioning system off if the temperature
gauge indicates engine overheating.
‡ When opening the windows in humid
weather, air conditioning may create
water droplets inside the vehicle.
Since excessive water droplets may
cause damage to electrical equip-
ment, air conditioning should only
be used with the windows closed.
Air conditioning system operation
tips

5-63
05
Automatic heating and air con-
ditioning
OAI3059110I
1. Press the AUTO button.
The modes, fan speeds, air intake
and air-conditioning will be controlled
automatically according to the tem-
perature setting you select.
OAI3059111I
2. Turn the temperature control knob
to set the desired temperature. If
the temperature is set to the lowest
setting (Lo), the air conditioning
system will operate continuously.

5-64
Convenient features
Manual heating and air condi-
tioning
The heating and cooling system can
be controlled manually by pushing
buttons other than the AUTO button.
In this case, the system works
sequentially according to the order of
buttons selected. When pressing any
EXWWRQH[FHSWWKH$872EXWWRQZKLOVW
using automatic operation, the func-
tions not selected will be controlled
automatically.
1. Start the engine.
2. Set the mode to the desired posi-
tion.
To improve the effectiveness of
heating and cooling, select the
mode according to the following:
- Heating :
- Cooling :
Mode selection
OAC3059100R
3. Set the temperature control to the
desired position.
4. Set the air intake control to fresh
mode.
5. Set the fan speed control to the
desired speed.
6. If air conditioning is desired, turn
the air conditioning system on.
7. Press the AUTO button in order to
convert to full automatic control of
the system.

5-68
Convenient features
Air conditioning
OAI3059107I
3XVKWKH$&EXWWRQWRPDQXDOO\WXUQ
the air conditioning system on (indi-
cator light will illuminate).
Push the button again to turn the air
conditioning system off.
OFF mode
OAI3059116I
Push the OFF button of the front to
turn off the air climate control system.
However, you can still operate the
mode and air intake buttons as long
as the ignition switch is in the ON
position.
System operation
Ventilation
1. Select the Face Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
Heating
1. Select the Floor Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
5. If desired, turn the air conditioning
ON with the temperature control
knob set to heat in order to dehu-
midify the air before it enters into
the cabin.
If the windscreen fogs up, select the
Floor & Defrost
mode or press
the Front Defrost
mode.

5-73
05
WARNING
Windscreen heating
Do not use the or position
during cooling operation in
extremely humid weather. The dif-
ference between the temperature
of the outside air and that of the
windscreen could cause the outer
surface of the windscreen to fog
up, causing loss of visibility. In
this case, set the mode selection
knob or button to the
position
and fan speed control knob or but-
ton to lower speed.