system HYUNDAI I10 2022 Owners Manual

5-45
05
Front Room Lights
OAC3059029TU
: The front or rear room lights
come on when the front or
rear doors are opened if the
engine is running or not. When
doors are unlocked by the
remote key or smart key, the
front and rear lights come on
IRU DSSUR[LPDWHO\  VHFRQGV
as long as any door is not
opened. The front and rear
room lights go out gradually
DIWHU DSSUR[LPDWHO\  VHF-
onds if the door is closed.
However, if the ignition switch
is in the ON position or all
doors are locked, the front and
rear lights will turn off. If a door
is opened with the ignition
switch in the ACC position or
the OFF position, the front and
rear lights stay on for about 20
minutes.
: With the Front Room Light in
this position, the front and rear
room lights remain on at all
times.
: With the Front Room Light in
this position the front and rear
room lights remain off at all
times.
Luggage compartment light
OAC3059063TU
The luggage compartment light comes
on when the tailgate is opened.
NOTICE
The luggage compartment comes
on as long as the tailgate lid is
open. To prevent unnecessary
charging system drain, close the
tailgate lid securely after using the
tailgate.
Glove box light (if equipped)
OAC3059030R
7KH JORYH ER[ OLJKW FRPHV RQ ZKHQ
WKHJORYHER[LVRSHQHG
The parking lights or headlights must
EH21IRUWKHJORYHER[OLJKWWRIXQF-
tion.

5-46
Convenient features
OAC3059031TU
„Front
„Rear
OAC3059032TU
A : Wiper speed control
· MIST (
) – Single wipe
· OFF (O) – Off
· INT (---) – Intermittent wipe
(if equipped)
· LO (1) – Low wiper speed
· HI (2) – High wiper speed
B : Intermittent wipe time
adjustment
C : Wash with brief wipes
D : Rear wiper/washer control/
Wash with brief wipes
·
– Wash with brief wipes
· ON (
) – Continuous wipe
· OFF (O) – Off
Windscreen wipers
Operates as follows when the ignition
switch is in the ON position.
MIST (
) : For a single wiping cycle,
push the lever upward
and release. The wipers
will operate continuously
if the lever is held in this
position.
OFF (O) : Wiper is not in operation.
INT (---) : Wiper operates intermit-
tently at the same wiping
intervals. To vary the speed
setting, turn the speed con-
trol knob (B).
LO (1) : The wiper runs at a lower
speed.
HI (2) : The wiper runs at a higher
speed.
i Information
If there is heavy accumulation of snow
or ice on the windscreen, defrost the
windscreen for about 10 minutes, or
until the snow and/or ice is removed
before using the windscreen wipers to
ensure proper operation.
If you do not remove the snow and/or
ice before using the wiper and washer,
it may damage the wiper and washer
system.
WIPERS AND WASHERS

5-48
Convenient features
OAC3059039TU
OAC3059040R
5HDU9LHZ0RQLWRUZLOODFWLYDWHZKHQ
the ignition switch is in the ON posi-
tion and the shift lever is in the R
(Reverse) position.
This is a supplemental system that
shows behind the vehicle through the
audio or infotainment system screen
whilst backing-up.
WARNING
Rear View Monitor is not a safety
device. It only serves to assist the
driver in identifying objects direct-
ly behind the middle of the vehicle.
The camera does NOT cover the
complete area behind the vehicle.
WARNING

5-49
05
OAC3059037TU
[A] : Rear sensors
Reverse Parking Distance Warning
system assists the driver during
reverse movement of the vehicle by
FKLPLQJLIDQ\REMHFWLVVHQVHGZLWKLQ
the distance of 120 cm (48 in) behind
the vehicle.
This system is a supplemental sys-
WHP WKDW VHQVHV REMHFWV ZLWKLQ WKH
range and location of the sensors, it
FDQQRW GHWHFW REMHFWV LQ RWKHU DUHDV
where sensors are not installed.
WARNING

5-51
05
To turn off Reverse Parking
Distance Warning system
(if equipped)
OAC3059038R
Push the button to turn off Reverse
Parking Distance Warning system.
The indicator light on the button will
turn on.
Non-operational conditions of
Reverse Parking Distance
Warning system
Reverse Parking Distance Warning
system may not operate normally
when:

5-53
05
MANUAL CLIMATE CONTROL SYSTEM
ãIF EQUIPPED
ä
OAI3059100
1. Temperature control knob
2. Fan speed control knob
3. Mode selection knob
4. Air intake control button
(recirculated air position or outside
(fresh) air position)$&$LUFRQGLWLRQLQJEXWWRQ
(if equipped)
6. Rear window defroster button
(if equipped)

5-54
Convenient features
Heating and air conditioning
1. Start the engine.
2. Set the mode to the desired posi-
tion.
To improve the effectiveness of
heating and cooling :
- Heating:
- Cooling:
Mode selection
OAC3059100R
3. Set the temperature control to the
desired position.
4. Set the air intake control to Fresh
mode.
5. Set the fan speed control to the
desired speed.
6. If air conditioning is desired, turn
the air conditioning system on.

5-55
05
OAI3059118
The mode selection knob controls the
direction of the air flow through the
ventilation system.
Air can be directed to the floor, dash-
board outlets, or windscreen. Five
symbols are used to represent Face,
Bi-Level, Floor, Floor-Defrost and
Defrost air position.
Face-Level (B, ')
Air flow is directed toward the upper
body and face. Additionally, each out-
let can be controlled to direct the air
discharged from the outlet.
Bi-Level (B, C, ')
Air flow is directed towards the face
and the floor.
Floor-Level (A, C, ')
Most of the air flow is directed to the
floor, with a small amount of the air
being directed to the windscreen,
side window defrosters and side
vents.
Floor/'efrost-Level (A, C, ')
Most of the air flow is directed to the
floor and the windscreen with a small
amount directed to the side window
defrosters and side vents.
'efrost-Level (A, ')
Most of the air flow is directed to the
windscreen with a small amount of air
directed to the side vents.

5-56
Convenient features
OAC3059103R
Instrument panel vents
The instrument panel vent air flow
FDQ EH GLUHFWHG XSGRZQ RU OHIWULJKW
XVLQJWKHYHQWDGMXVWPHQWOHYHU
7R FORVH WKH YHQW DGMXVWPHQW OHYHU
rotate it to the outer side till the end.
To open the vent, rotate it to the inner
side.
Temperature control
OAI3059119
The temperature will increase by
turning the knob to the right.
The temperature will decrease by
turning the knob to the left.
Air intake control
OAI3059106
The air intake control button is used
to select either Fresh mode (outside
air) or Recirculation mode (cabin air).
Recirculation mode
When Recirculation
mode is selected, air
from the passenger
compartment will be
recirculated through the
system and heated or
cooled according to the
function selected.
Fresh mode
When Fresh mode is
selected, air enters the
vehicle from outside and
is heated or cooled
according to the function
selected.

5-57
05
i Information
2perating the system primarily in
Fresh mode is recommended. 8se
Recirculation mode temporarily only
when needed.
Prolonged operation of the heater in
Recirculation mode and without the
A/C 21 can cause fogging of the wind-
screen.
In addition, prolonged use of the A/C
21 in Recirculation mode may result
in excessively dry, dehumidified air in
the cabin and may promote formation
of musty vent odor due to stagnant air.
WARNING