engine HYUNDAI I10 2023 Manual PDF

6-84
Whilst driving
i Information
‡ 'uring normal cruise control opera-
tion, when the SE7 switch is activat-
ed or reactivated after applying the
brakes, the cruise control will acti-
vate after approximately 3 seconds.
7his delay is normal.
‡ Before activating the cruise control
function, the system will check to
verify that the brake switch is oper-
ating normally. 'epress the brake
pedal at least once after turning 21
the ignition or starting the vehicle.
Cruise control switch
2$,
CRUISE/7XUQV FUXLVH FRQ-
trol system on or
off.
5(65HVXPHVRULQFUHDVHVFUXLVH
control speed.
6(76HWVRUGHFUHDVHVFUXLVHFRQ-
trol speed.
&$1&(/&DQFHOV FUXLVH FRQWURO
operation.
To set Cruise Control speed
2$,
3XVK WKH &58,6( button
on the steering wheel to turn the
system on. The CRUISE/

indicator on the LCD display will
illuminate.
2. Accelerate to the desired speed,
ZKLFK PXVW EH PRUH WKDQ  PSK
NPK
i Information
For manual transmission vehicles, you
should depress the brake pedal at least
once to set the cruise control after
starting the engine.

6-89
06
i Information
7he ESC system (if equipped) must be
turned 2FF before rocking the vehicle.
NOTICE
If you are still stuck after rocking
the vehicle a few times, have the
vehicle pulled out by a tow vehicle
to avoid engine overheating, pos-
sible damage to the transmission,
and tyre damage. See “Towing” in
chapter 6.
Smooth cornering
Avoid braking or gear changing in
corners, especially when roads are
wet. Ideally, corners should always
be taken under gentle acceleration.
Driving at night
Night driving presents more hazards
than driving in the daylight. Here are
VRPHLPSRUWDQWWLSVWRUHPHPEHU

6-90
Whilst driving
Hydroplaning
If the road is wet enough and you are
going fast enough, your vehicle may
have little or no contact with the road
surface and actually ride on the water.
The best advice is SLOW DOWN
when the road is wet.
The risk of hydroplaning increases
as the depth of tyre tread decreas-
es, refer to “Tyre replacement” in
chapter 8.
Driving in flooded areas
Avoid driving through flooded areas
unless you are sure the water is no
higher than the bottom of the wheel
hub. Drive through any water slowly.
Allow adequate stopping distance
because brake performance may be
reduced.
After driving through water, dry the
brakes by gently applying them sev-
eral times whilst the vehicle is moving
slowly.
Highway driving
Tyres
$GMXVWWKHW\UHLQIODWLRQDVVSHFLILHG
Under-inflation may overheat or dam-
age the tyres.
Do not install worn-out or damaged
tyres, which may reduce traction or
fail the braking operation.
i Information
1ever over-inflate your tyres above the
maximum inflation pressure, as speci-
fied on your tyres.
Fuel, engine coolant and engine
oil
Driving at higher speeds on the high-
way consumes more fuel and is less
efficient than driving at a slower, more
PRGHUDWH VSHHG 0DLQWDLQ D PRGHU-
ate speed in order to conserve fuel
when driving on the highway.
%H VXUH WR FKHFN ERWK WKH HQJLQH
coolant level and the engine oil before
driving.
Drive belt
A loose or damaged drive belt may
overheat the engine.

6-91
06
The severe weather conditions of
winter quickly wear out tyres and
cause other problems. To minimise
winter driving problems, you should
WDNHWKHIROORZLQJVXJJHVWLRQV
Snow or icy conditions
You need to keep sufficient distance
between your vehicle and the vehicle
in front of you.
Apply the brakes gently. Speeding,
rapid acceleration, sudden brake
applications, and sharp turns are
potentially very hazardous practices.
During deceleration, use engine brak-
ing to the fullest extent. Sudden brake
applications on snowy or icy roads
may cause the vehicle to skid.
To drive your vehicle in deep snow, it
may be necessary to use snow tyres
or to install tyre chains on your tyres.
Always carry emergency equipment.
Some of the items you may want to
carry include tyre chains, tow straps
or chains, a flashlight, emergency
IODUHVVDQGDVKRYHOMXPSHUFDEOHV
a window scraper, gloves, ground
cloth, coveralls, a blanket, etc.
Snow tyres
WARNING
Snow tyres should be equivalent
in size and type to the vehicle’s
standard tyres. Otherwise, the
safety and handling of your vehi-
cle may be adversely affected.
If you mount snow tyres on your vehi-
cle, make sure to use radial tyres of
the same size and load range as the
RULJLQDOW\UHV0RXQWVQRZW\UHVRQDOO
four wheels to balance your vehicle’s
handling in all weather conditions.
The traction provided by snow tyres
on dry roads may not be as high as
your vehicle’s original equipment
tyres. Check with the tyre dealer for
maximum speed recommendations.
i Information
'o not install studded tyres without
first checking local and municipal reg-
ulations for possible restrictions
against their use.
WINTER DRIVING

6-93
06
Chain Installation
When installing tyre chains, follow the
manufacturer’s instructions and
mount them as tightly possible. Drive
VORZO\ OHVV WKDQ  PSK  NPK
with chains installed. If you hear the
chains contacting the body or chas-
sis, stop and tighten them. If they still
make contact, slow down until the
noise stops. Remove the tyre chains
as soon as you begin driving on
cleared roads.
When mounting snow chains, park
the vehicle on level ground away from
traffic. Turn on the vehicle Hazard
Warning Flasher and place a triangu-
lar emergency warning device behind
the vehicle (if available). Always
SODFH WKH YHKLFOH LQ 3 3DUN DSSO\
the parking brake and turn off the
engine before installing snow chains.
NOTICE
When using tyre chains:

6-94
Whilst driving
To prevent locks from freezing
To prevent the locks from being fro-
zen, spray approved de-icing fluid or
glycerin into key holes. When a lock
opening is already covered with ice,
spray approved de-icing fluid over the
ice to remove it. When an internal
part of a lock freezes, try to thaw it
with a heated key. Carefully use the
KHDWHGNH\WRDYRLGDQLQMXU\
Use approved window washer anti-
freeze solution in system
To prevent the window washer from
being frozen, add authorized window
washer anti-freeze solution, as speci-
fied on the window washer container.
Window washer anti-freeze solution
is available from a HYUNDAI autho-
rised repairer, and most vehicle
accessory outlets. Do not use engine
coolant or other types of anti-freeze
solution to prevent any damage to the
vehicle paint.
Do not let your parking brake
freeze
Under some conditions your parking
brake can freeze in the engaged posi-
tion.
This is most likely to happen when
there is an accumulation of snow or
ice around or near the rear brakes or
if the brakes are wet. When there is
the risk that your parking brake may
freeze, temporarily apply it with the
VKLIWOHYHULQ1IRU$XWRPDWHG0DQXDO
Transmission) or in first or reverse
gear (for manual transmission). Also,
block the rear wheels in advance, so
the vehicle may not roll. Then, release
the parking brake.Do not let ice and snow
accumulate underneath
Under some conditions, snow and ice
can build up under the fenders and
interfere with the steering. When driv-
ing in such conditions during the
severe winter, you should check
underneath the vehicle on a regular
basis, to ensure that the front wheels
and the steering components is
unblocked.
Carry emergency equipment
In accordance with weather condi-
tions, you should carry appropriate
emergency equipment, whilst driving.
Some of the items you may want to
carry include tyre chains, tow straps
or chains, flashlight, emergency
IODUHV VDQG VKRYHO MXPSHU FDEOHV
window scraper, gloves, ground cloth,
coveralls, blanket, etc.
Do not place objects or materials
in the engine compartment
3XWWLQJ REMHFWV RU PDWHULDOV LQ WKH
engine compartment may cause an
engine failure or combustion,
because they may block the engine
cooling. Such damage will not be
covered by the manufacturer’s war-
ranty.

Hazard warning flasher ...................................................................................... 7-3
In case of an emergency whilst driving ............................................................ 7-3
If the engine stalls whilst driving .................................................................... 7-3
If the engine stalls at a crossroad or crossing ............................................... 7-3
If you have a flat tyre whilst driving ............................................................... 7-4
If the engine will not start .................................................................................. 7-5
If the engine doesn’t turn over or turns over slowly ..................................... 7-5
If the engine turns over normally but doesn’t start ...................................... 7-5
Jump starting ...................................................................................................... 7-6
If the engine overheats ...................................................................................... 7-9
Tyre Pressure Monitoring System (TPMS) ........................................................7-10
TPMS reset procedure .....................................................................................7-11
Tyre pressure monitoring system .................................................................. 7-12
Low tyre pressure telltale ............................................................................... 7-14
Low tyre pressure position telltale and tyre pressure telltale ..................... 7-14
TPMS (Tyre Pressure Monitoring System) malfunction indicator ............... 7-15
Changing a tyre with TPMS ...........................................................................7-16
If you have a flat tyre (with spare tyre) .............................................................7-18
Jack and tools ................................................................................................7-18
Changing tyres................................................................................................7-19
Jack label ....................................................................................................... 7-23
EC Declaration of conformity for Jack......................................................... 7-24
If you have a flat tyre (with tyre mobility kit) .................................................. 7-25
Introduction ................................................................................................... 7-25
Notes on the safe use of the tyre Mobility Kit ............................................. 7-26
Components of the Tyre Mobility Kit ............................................................7-27
Using the Tyre Mobility Kit ............................................................................ 7-28
Distributing the sealant ................................................................................. 7-30
Checking the tyre inflation pressure ............................................................ 7-30
7. Emergency situations
7

7-3
07
OAC3079001TU
The hazard warning flasher serves as
a warning to other drivers to exercise
extreme caution when approaching,
overtaking, or passing your vehicle.
It should be used whenever emer-
gency repairs are being made or
when the vehicle is stopped near the
edge of a roadway.
To turn the hazard warning flasher on
or off, press the hazard warning flash-
er button with the ignition switch in
any position. The button is located in
the centre fascia panel. All turn signal
lights will flash simultaneously.
‡The hazard warning flasher oper-
ates whether your vehicle is run-
ning or not.
‡The turn signals do not work when
the hazard flasher is on
HAZARD WARNING FLASHER IN CASE OF AN EMERGENCY
WHILST DRIVING
,IWKHHQJLQHVWDOOVZKLOVW
GULYLQJ
‡Reduce your speed gradually,
keeping a straight line. Move cau-
tiously off the road to a safe place.
‡Turn on your hazard warning flash-
er.
‡Try to start the engine again. If your
vehicle will not start, we recom-
mend that you contact a HYUNDAI
authorised repairer.
,IWKHHQJLQHVWDOOVDWDFURVV-
URDGRUFURVVLQJ
If the engine stalls at a crossroads or
crossing, if safe to do so, move the
shift lever to the N (Neutral) position
and then push the vehicle to a safe
location.

7-7
07
i,QIRUPDWLRQ
3E
An inappropriately disposed
battery can be harmful to the
environment and human
health. Dispose of the battery
according to your local law(s)
or regulations.
Jump starting procedure
1. Position the vehicles close enough
that the jumper cables will reach,
but do not allow the vehicles to
touch.
2. Avoid fans or any moving parts in
the engine compartment at all
times, even when the vehicles are
turned off.
3. Turn off all electrical devices such
as radios, lights, air conditioning,
etc. Put the vehicles in N (Neutral,
for Automated manual transmis-
sion vehicle) or neutral (for Manual
transmission vehicle), and set the
parking brakes. Turn both vehicles
OFF.
OAC3079002TU
4. Connect the jumper cables in the
exact sequence shown in the illus-
tration. First connect one jumper
cable to the red, positive (+) jump-
er terminal of your vehicle (1).
5. Connect the other end of the jump-
er cable to the red, positive (+) bat-
tery/jumper terminal of the assist-
ing vehicle (2).
6. Connect the second jumper cable
to the black, negative (-) battery/
chassis ground of the assisting
vehicle (3).
7. Connect the other end of the sec-
ond jumper cable to the black, neg-
ative (-) chassis ground of your
vehicle (4).
Do not allow the jumper cables to
contact anything except the correct
battery or jumper terminals or the
correct ground. Do not lean over
the battery when making connec-
tions.

7-8
Emergency situations
8. Start the engine of the assisting
vehicle and let it run at approxi-
mately 2,000rpm for a few minutes.
Then start your vehicle.
If your vehicle will not start after a few
attempts, it probably requires servic-
ing. In this event please seek quali-
fied assistance. If the cause of your
battery discharging is not apparent,
have your vehicle checked by a
HYUNDAI authorised repairer.Disconnect the jumper cables in the
exact reverse order you connected
them:
1. Disconnect the jumper cable from
the black, negative (-) chassis
ground of your vehicle (4).
2. Disconnect the other end of the
jumper cable from the black, nega-
tive (-) battery/chassis ground of
the assisting vehicle (3).
3. Disconnect the second jumper
cable from the red, positive (+) bat-
tery/jumper terminal of the assist-
ing vehicle (2).
4. Disconnect the other end of the
jumper cable from the red, positive
(+) jumper terminal of your vehicle
(1).