CAN HYUNDAI I20 2017 Workshop Manual

)'#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
AA void driving with a very low fuel
level. Running out of fuel could
cause the engine to misfire damag-
ing the catalytic converter.
OdometerThe odometer indicates the total dis-
tance that the vehicle has been driv-
en and should be used to determine
when periodic maintenance should
be performed.
- Odometer range : 0 ~ 1599999 kilo- meters or 999999 miles.
Information
It is forbidden to alter the odometer of
all vehicles with the intent to change
the mileage registered on the odome-
ter. The alteration may void your war-
ranty coverage.i
NOTICEFuel Gauge
Running out of fuel can expose
vehicle occupants to danger.
You must stop and obtain addi-
tional fuel as soon as possible
after the warning light comes on or
when the gauge indicator comes
close to the “E (Empty)” level.
WARNING
OIB044116OIB044115
■Ty p e A■Ty p e B , C

)'
#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
OOutside Temperature GaugeThis gauge indicates the current out-
side air temperatures by 1°C (1°F).
- Temperature range : - 40°C ~ 85°C
(-40°F ~ 211°F)
The outside temperature on the dis-
play may not change immediately
like a general thermometer to pre-
vent the driver from being inattentive.
The temperature unit (from °C to °F
or from °F to °C) can be changed as
below procedures (if equipped).
- User Settings Mode in the Cluster : You can change the temperature
unit in the “Other Features -
Temperature unit” .
Transaxle Shift IndicatorContinuously Variable TransaxleShift Indicator (if equipped)This indicator displays which
Continuously Variable Transaxle shift
lever is selected. • Park : P
• Reverse : R
• Neutral : N
•Drive : D
• Sports Mode : 1, 2, 3, 4, 5, 6
OIB044156/OIB044155
■
Type A
■Type B,C
OIB044118
■Type A■Type B
■Type COIB044117/OHCR046128

EEngine Oil PressureWarning LightThis warning light illuminates:• Once you set the ignition switch or
Engine Start/Stop button to the ON
position.
- It remains on until the engine isstarted.
• When the engine oil pressure is low.If the engine oil pressure is low:1.Drive carefully to the nearest safelocation and stop your vehicle.
2.Turn the engine off and check the engine oil level (For more details,
refer to “Engine Oil” in chapter 7). If
the level is low, add oil as required.
If the warning light remains on after
adding oil or if oil is not available,
we recommend that you have the
vehicle inspected by an authorized
HYUNDAI dealer as soon as possi-
ble.
- Engine Oil Pressure Warning Light
• If the engine does not stop imme- diately after the Engine Oil
Pressure Warning Light is illumi-
nated, severe damage could
result.
• If the warning light stays on while the engine is running, it indicates
that there may be serious engine
damage or malfunction. In this
case,
1. Stop the vehicle as soon as it is safe to do so.
2. Turn off the en gine and check
the oil level. If the oil level is low,
fill the engine oil to the proper
level.
3. Start the engine again. If the warning light stays on after the
engine is started, turn the engine
off immediately. In this case, we
recommend that you have the
vehicle inspected by an author-
ized HYUNDAI dealer.
Low Fuel Level WarningLightThis warning light illuminates:When the fuel tank is nearly empty.
If the fuel tank is nearly empty, add
fuel as soon as possible.
- Low Fuel Level
Driving with the Low Fuel Level
warning light on or with the fuel level
below “E (Empty)” can cause the
engine to misfire and damage the
catalytic converter (if equipped).
NOTICE
NOTICE
)'#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3

IImmobilizer Indicator
Light (without smart key) (if equipped)This indicator light illuminates:When the vehicle detects the immo-
bilizer in your key properly while the
ignition switch is ON.
- At this time, you can start the engine.
- The indicator light goes off after
starting the engine.This indicator light blinks:When there is a malfunction with the
immobilizer system.
In this case, we recommend that you
have the vehicle inspected by an
authorized HYUNDAI dealer.
Immobilizer IndicatorLight (with smart key) (if equipped)This indicator light illuminates for
up to 30 seconds:When the vehicle detects the smart
key in the vehicle properly while the
Engine Start/Stop button is ACC or
ON.
- At this time, you can start the engine.
- The indicator light goes off after starting the engine.This indicator light blinks for a few
seconds:When the smart key is not in the
vehicle.
- At this time, you can not start theengine.
This indicator light illuminates for
2 seconds and goes off:When the vehicle can not detect the
smart key which is in the vehicle while
the Engine Start/Stop button is ON.
In this case, we recommend that you
have the vehicle inspected by an
authorized HYUNDAI dealer.This indicator light blinks:• When the battery of the smart key is weak.
- At this time, you can not start theengine. However, you can start the
engine if you press the Engine
Start/Stop button with the smart
key. (For more details, refer to
“Starting the Engine” in chapter 5).
• When there is a malfunction with the immobilizer system.
In this case, we recommend that
you have the vehicle inspected by
an authorized HYUNDAI dealer.
)')#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3

GGlow Indicator Light
(Diesel Engine)This indicator light illuminates:When the engine is being preheated
with the ignition switch or Engine
Start/Stop button in the ON position.
- The engine can be started after the
glow indicator light goes off.
- The illumination time varies with the engine coolant temperature, air
temperature, and battery condition.
If the indicator light remains on or
blinks after the engine has warmed
up or while driving, there may a mal-
function with the engine preheating
system.
In this case, we recommend that you
have the vehicle inspected by an
authorized HYUNDAI dealer.
Information -
Engine
Preheating
If the engine does not start within 10
seconds after the preheating is com-
pleted, set the ignition switch or
Engine Start/Stop button to the
LOCK or OFF position for 10 seconds
and then to the ON position in order
to preheat the engine again.
KEY OUT Indicator Light (if equipped)When the Engine Start/Stop button
is in the ACC or ON position, if any
door is open, the system checks for
the smart key.This indicator light blinks:When the smart key is not in the
vehicle and any door is open with the
ignition switch or Engine Start/Stop
button in the ACC or ON position.
- At this time, if you close all doors,
the chime will also sound for
approximately 5 seconds.
- The indicator will go off while the vehicle is moving.
i
)')#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
KEY
OUT

)'#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
IItems
Explanation
Automatically Unlock
• Disable : The auto door unlock operation will be canceled.
• Vehicle Off: All doors will be automatically unlocked when the ignition key is removed from theignition switch or the Engine Star/Stop button is set to the OFF position.
Door
Light
Items
Explanation
One Touch Turn Signal
• Off: The one touch turn signal function will be deactivated.
• 3, 5, 7 Flashes : The lane change signals will blink 3, 5, or 7 times when the turn signal lever is moved slightly.For more details, refer to “Light” in this chapter.
Head Lamp Delay
• Off: The headlamp delay function will be deactivated.
• On: The head lamp delay function will be activated.For more details, refer to “Light” in this chapter.
User settings mode (Cluster Type B)In this mode, you can change setting of the instrument cluster, doors, lamps, and so on.

)')
#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
IItems
Explanation
Steering Position
• Off : The steering position function will be deactivated.
• On : The steering position function will be activated.
Items
Explanation
Service Interval
In this mode, you can activate the service interval function with mileage (km or mi.) and period
(months).
• Off : The service interval function will be deactivated.
• On :You can set the service interval (mileage and months).
Service interval
Other features Steering
Items
Explanation
Temperature Unit
Choose the temperature unit. (°C,°F)
Language
Choose the language.

)'#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
IItems
Explanation
Auto Lock
• Disable : The auto door lock operation will be deactivated.
• Enable on Speed : All doors will be automatically locked when the vehicle speed exceeds 9.3mph (15km/h).
• Enable on Shift : All doors will be automatically locked if the Continuously Variable Transaxle shift lever is shifted from the P (Park) position to the R (Reverse), N (Neutral), or D (Drive) position.
Auto Unlock
• Disable : The auto door unlock operation will be canceled.
• Vehicle Off: All doors will be automatically unlocked when the ignition key is removed from the ignition switch or the Engine Star/Stop button is set to the OFF position.
• On Shift to P: All doors will be automatically unlocked if the automatic transaxle shift lever is shift- ed to the P (Park) position.
Door
Light
Items
Explanation
One Touch Turn Signal
• Off: The one touch turn signal function will be deactivated.
• 3, 5, 7 Flashes : The lane change signals will blink 3, 5, or 7 times when the turn signal lever is moved slightly.For more details, refer to “Light” in this chapter.
Head Lamp Delay
• Off: The headlamp delay function will be deactivated.
• On: The head lamp delay function will be activated.For more details, refer to “Light” in this chapter.
User settings mode (Cluster Type C)In this mode, you can change setting of the instrument cluster, doors, lamps, and so on.

)'
#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
IItems
Explanation
Wiper/Light Display
• Off : The Wiper/Light Display function will be deactivated.
• On : The Wiper/Light Display function will be activated.
Rear Wiper Display
• Off : The Rear Wiper Display function will be deactivated.
• On : The Rear Wiper Display function will be activated.
Gear Position Pop-up
If you select this function, the current shift gear position is displayed in the cluster for about 2
seconds when shifting into other positions (P/R/N/D).
If you do not select this function, the shift gear Pop-up is not displayed in the cluster.
Convenience
Items
Explanation
Service Interval
In this mode, you can activate the service interval function with mileage (km or mi.) and period
(months).
• Off : The service interval function will be deactivated.
• On :You can set the service interval (mileage and months).
Service interval

)'#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3DDistance To Empty (1)
(if equipped)• The distance to empty is the esti-
mated distance the vehicle can be
driven with the remaining fuel.
- Distance range: 1 ~ 1999 km or 1 ~ 1999 mi.
• If the estimated distance is below 1 km (1 mi.), the trip computer will
display “---” as distance to empty.
And, "Low Fuel" warning message
is displayed.
Information
If the vehicle is not on level ground or the battery power has been inter-
rupted, the distance to empty func-
tion may not operate correctly.
The distance to empty may differ from the actual driving distance as
it is an estimate of the available
driving distance.
The trip computer may not register additional fuel if less than 6 liters
(1.6 gallons) of fuel are added to the
vehicle.
The fuel economy and distance to empty may vary significantly based
on driving conditions, driving
habits, and condition of the vehicle.
Average Fuel Consumption (2) (ifequipped)• The average fuel economy is calcu-
lated by the total driving distance
and fuel consumption since the last
average fuel economy reset.
- Fuel economy range: 0.0 ~ 99.9 L/100km, km/L or MPG
• The average fuel economy can be reset both manually and automati-
cally.Manual resetTo clear the average fuel economy
manually, press the [OK] button (or
RESET button) on the steering wheel
for more than 1 second when the
average fuel economy is displayed.Automatic resetTo make the average fuel economy
be reset automatically whenever refu-
eling, select the “Auto Reset” mode in
User Setting menu of the LCD dis-
play.
i
OIB044159