oil capacities HYUNDAI I20 2020 Owners Manual

3-11
03
RECOMMENDED LUBRICANTS AND CAPACITIES
To help achieve proper engine and powertrain performance and durability, use only
lubricants of the proper quality. The correct lubricants also help promote engine
efficiency that results in improved fuel economy.
These lubricants and fluids are recommended for use in your vehicle.
Lubricant Volume Classification
Engine oil *1 *2 *4
(drain and refill)Petrol 1.0 T-GDi
bACEA C2
Petrol Smartstream G1.2
bSAE 0W20, API SN PLUS/SP
or ILSAC GF-6
(Diesel) 1.5 WGT
bACEA C5, 0W-20
Manual
transmission fluid
(Intelligent manual
transmission fluid)Petrol 1.0 T-GDia
b
API GL-4, SAE 70W Petrol Smartstream G1.2a
b
(Diesel) 1.5 WGTa
b
Intelligent manual
transmission
system actuator
fluidPetrol 1.0 T-GDi
bSAE J1704 DOT-4 LV,
ISO4925 CLASS-6,
FMVSS116 DOT-4,
FMVSS116 DOT-3
Dual clutch
transmission fluidPetrol 1.0 T-GDia
bAPI GL-4, SAE 70W
Intelligent variable
transmission fluidPetrol Smartstream G1.2
bCVTF SP-CVT1 *
3
*1 : Refer to the recommended SAE viscosity numbers on the next page.
*
2 : Requires <API SN Full synthetic> grade engine oil. If a lower grade engine oil (mineral oil
including Semi-synthetic other than API SN plus) is used, then the engine oil and engine oil
filter must be replaced as indicated severe maintenance condition.
*
3 : Use only specified genuine Intelligent Variable Transmission fluid. The use of non-specified
fluid (even marked as compatible with genuine) could result in shift quality deterioration and
vibrations, eventually, the transmission failure.
*
4 :We recommend that you use the engine oils approved by HYUNDAI Motor India Ltd. We
recommend that you consult an authorized HYUNDAI dealer for details.
CoolantPetrol 1.0 T-GDi
b
MIXTURE, Antifreeze with
water (Ethylene glycol base
coolant for aluminum radiator) Petrol Smartstream G1.2
b
Diesel 1.5 WGT
b
Brake/Clutch fluida
bFMVSS116 DOT-4
Fuel 37
b-

5-22
Instrument cluster
Low engine oil (if equipped)
This warning message is displayed when
the engine oil level should be checked.
If this warning message is displayed,
check the engine oil level as soon as
possible and add engine oil as required.
Slowly pour the recommended oil little
by little into a funnel.
Use only the specified engine oil. (Refer
to "Recommended lubricants and
capacities" section in chapter 2.)
Do not overfill the engine oil. Make sure
the oil level is not above F (Full) mark on
the dipstick.
NOTICE
If the message is displayed
continuously after adding the engine
oil and travelling approximately
50~100 km after the engine warms up,
we recommend that the system be
checked by an authorized HYUNDAI
dealer.
Engine has overheated
(if equipped)
This warning message is displayed
when the engine coolant temperature
is above 120°C (248°F). This means that
the engine is overheated and may be
damaged.
If your vehicle is overheated, refer to
“Overheating” section in chapter 8.
Check headlight (if equipped)
This warning message is displayed if the
headlamps are not operating properly.
In addition, if a specific lamp(turn signal
lamp etc.) is not operating properly, the
warning message according to a specific
lamp (turn signal lamp etc.) is displayed.
A corresponding bulb may need to be
replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.
Check brake light (if equipped)
This warning message is displayed if the
stop lamps are not operating properly. A
lamp may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.

10-28
Maintenance
ENGINE OIL
Checking the engine oil level
(Petrol Engine )
OBI3090003OBI3090003
„„Petrol Engine (1.0 T-GDi)Petrol Engine (1.0 T-GDi)
OBC3090009OBC3090009
„„Petrol Engine (Smartstream G1.2)Petrol Engine (Smartstream G1.2)
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach
normal operating temperature.
3. Turn the engine off and wait for a few
minutes (about 15 minutes) for the oil
to return to the oil pan.
4. Pull the dipstick out, wipe it clean, and
reinsert it fully.
5. Pull the dipstick out again and check
the level. The level should be between
F (Full) and L (Low).
OBI3090004OBI3090004
„„Petrol Engine (1.0 T-GDi)Petrol Engine (1.0 T-GDi)
OBC3090013OBC3090013
„„Petrol Engine (Smartstream G1.2)Petrol Engine (Smartstream G1.2)
If it is near or at L (Low), add enough
oil to bring the level to F (Full). Do not
overfill.
Use a funnel to help prevent oil from
being spilled on engine components.
Use only the specified engine oil. (Refer
to “Recommended lubricants and
capacities” in chapter 2.)

10-30
Maintenance
OBI3090007OBI3090007
If it is near or at L, add enough oil to
bring the level to F. Do not overfill.
Use only the specified engine oil.
• If exceeding the maintenance
schedule for replacement of engine
oil, the engine oil performance
may deteriorate and the engine
condition may be affected. Therefore,
the replacement cycle should be
observed.
• If not using the recommended oil,
replace it according to the severe
usage maintenance conditions.
(Refer to “Recommended lubricants
and capacities” in chapter 2.)
WARNING
Radiator hose
Be very careful not to touch the
radiator hose when checking or adding
engine oil as it may be hot enough to
burn you.
CAUTION
• Do not spill engine oil, when adding
or changing engine oil. If you drop
the engine oil on the engine room,
wipe it off immediately.
• When you wipe the oil level gauge,
you should wipe it with a clean cloth.
When mixed with debris, it can cause
engine damage.