engine HYUNDAI I20 2022 Owner's Guide

5-20
Instrument cluster
Shift to N to start engine
(for smart key system and
Automatic transmission/Dual clutch
transmission) / iMT (intelligent
manual transmission))
This warning message is displayed if
you try to start the engine with the shift
button not in the N (Neutral) position.
i Information
You can start the engine with the shift
lever in the N (Neutral) position.
Check BRAKE SWITCH fuse (for
smart key system and Automatic
transmission/Dual clutch
transmission)
This warning message is displayed if the
brake switch fuse is disconnected.
You need to replace the fuse with a new
one. If that is not possible, you can start
the engine by pressing the Engine Start/
Stop button for 10 seconds in the ACC
position.
Lights mode
OIK047163LOIK047163L
This indicator displays which exterior
light is selected using the lighting
control.

5-22
Instrument cluster
Low engine oil (if equipped)
This warning message is displayed when
the engine oil level should be checked.
If this warning message is displayed,
check the engine oil level as soon as
possible and add engine oil as required.
Slowly pour the recommended oil little
by little into a funnel.
Use only the specified engine oil. (Refer
to "Recommended lubricants and
capacities" section in chapter 2.)
Do not overfill the engine oil. Make sure
the oil level is not above F (Full) mark on
the dipstick.
NOTICE
If the message is displayed
continuously after adding the engine
oil and travelling approximately
50~100 km after the engine warms up,
we recommend that the system be
checked by an authorized HYUNDAI
dealer.
Engine has overheated
(if equipped)
This warning message is displayed
when the engine coolant temperature
is above 120°C (248°F). This means that
the engine is overheated and may be
damaged.
If your vehicle is overheated, refer to
“Overheating” section in chapter 8.
Check headlight (if equipped)
This warning message is displayed if the
headlamps are not operating properly.
In addition, if a specific lamp(turn signal
lamp etc.) is not operating properly, the
warning message according to a specific
lamp (turn signal lamp etc.) is displayed.
A corresponding bulb may need to be
replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.
Check brake light (if equipped)
This warning message is displayed if the
stop lamps are not operating properly. A
lamp may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.

5-27
05
User settings mode
In this mode, you can change setting of the instrument cluster, doors, lamps, and so
on.
Door
ItemsExplanation
Auto Lock• Disable : The auto door lock operation will be deactivated.
• Enable on Speed : All doors will be automatically locked when the
vehicle speed exceeds 9.3 mph (15km/h).
• Enable on Shift : All doors will be automatically locked if the dual
clutch transmission shift lever is shifted from the P (Park) position
to the R (Reverse), N (Neutral), or D (Drive) position. (Only when the
engine is running.)
Auto Unlock• Disable : The auto door unlock operation will be canceled.
• Vehicle Off: All doors will be automatically unlocked when the ignition
key is removed from the ignition switch or the Engine Star/Stop button
is set to the OFF position.
• On Shift to P: All doors will be automatically unlocked if the dual clutch
transmission shift lever is shifted to the P (Park) position. (Only when
the engine is running.)
Light
ItemsExplanation
IlluminationTo adjust the brightness of the instrument panel illumination.
One Touch Turn
Signal• Off: The one touch turn signal function will be deactivated.
• 3, 5, 7 Flashes : The lane change signals will blink 3, 5, or 7 times when
the turn signal lever is moved slightly.
For more details, refer to “Light” in chapter 5.
Ambient light
brightness• Off/Level 1/Level 2/Level 3/Level 4
To adjust the brightness of the Ambient Light (cabin mood light setting).
Ambient LightTo activate or deactivate the Ambient Light (cabin mood light setting)
function.
Head Lamp
Delay• Off: The headlight delay function will be deactivated.
• On: The headlight delay function will be activated.
For more details, refer to “Light” in chapter 5.

5-29
05
Other features
ItemsExplanation
Fuel Economy
Auto Reset• Off : The average fuel economy will not reset automatically whenever
refueling.
• After Ignition : The average fuel economy will reset automatically
whenever it has passed 4 hours after turning OFF the engine.
• After Refueling : The average fuel economy will reset automatically
when refueling.
For more details, refer to “Trip Computer” in this chapter.
Fuel Economy
UnitChoose the fuel economy unit. (Km/L, L/100km)
Temperature
UnitChoose the temperature unit. (°C,°F)
Tyre pressure
unitTo select the tire pressure unit. (psi, kPa, bar)
Language
ItemsExplanation
LanguageChoose the language.
Reset
ItemsExplanation
ResetYou can reset the menus in the User Settings Mode. All menus in the
User Settings Mode are reset to factory settings, except language and
service interval.

5-31
05
OQXI049117OQXI049117
„„ Type A Type A
OQXI049118OQXI049118
„„ Type B Type B
Tripmeter (km or mi.)
A : Tripmeter A
B : Tripmeter B
This mode indicates the distance of
individual trips selected since the last
tripmeter reset.
The meter’s working range is from 0.0
to 9999.9 km. (0.0 to 9999.9 miles).
Pressing the trip mode/reset button for
more than 1 second, when the tripmeter
is being displayed, clears the tripmeter
to zero (0.0).
OQXI049119OQXI049119
Distance to empty (if equipped)
(km or mi.)
This mode indicates the estimated
distance to empty based on the current
fuel in the fuel tank and the amount of
fuel delivered to the engine. When the
remaining distance is below 50 km (30
miles), “---” will be displayed.
The meter’s working range is from 50 to
999 km (30 to 615 miles).

5-33
05
NOTICE
• If the vehicle is not on level ground
or the battery power has been
interrupted, the “Distance to empty”
function may not operate correctly.
The trip computer may not register
additional fuel if less than 6 liters
(1.6 gallons) of fuel are added to the
vehicle.
• The fuel consumption and distance to
empty may vary significantly based
on driving conditions, driving habits,
and condition of the vehicle.
• The distance to empty value is an
estimate of the available driving
distance. This may differ from the
actual driving distance available.
OQXI049122OQXI049122
Average speed (km/h or MPH)
This mode calculates the average speed
of the vehicle since the last average
speed reset.
Even if the vehicle is not in motion, the
average speed keeps going while the
engine is running.
Pressing the RESET button for more
than 1 second, when the average speed
is being displayed, clears the average
speed to zero (---).

5-34
Instrument cluster
OQXI049123OQXI049123
Elapsed time (if equipped)
This mode indicates the total time
traveled since the last driving time reset.
Even if the vehicle is not in motion,
the driving time keeps going while the
engine is running.
The meter’s working range is from
00:00~99:59.
Pressing the RESET button for more than
1 second, when the driving time is being
displayed, clears the driving time to zero
(00:00).
Service reminder
OBI3040012OBI3040012
This mode displays the service interval
(mileage).
Digital Speedometer
OBI3040013OBI3040013
This message shows the speed of the
vehicle (km/h, MPH).

5-36
Instrument cluster
„„Type AType A
OBI3040019OBI3040019
„„Type BType B
To change the trip mode, toggle the
“
, ” switch on the steering wheel.
Fuel economy
OAC3069039TUOAC3069039TU
Average Fuel Economy (1)
• The average fuel economy is
calculated by the total driving distance
and fuel consumption since the last
average fuel economy reset.
• The average fuel economy can be
reset both manually and automatically.Manual reset
To clear the average fuel economy
manually, press the [OK] button on the
steering wheel for more than 1 second
when the average fuel economy is
displayed.
Automatic reset
To automatically reset the average fuel
economy after refueling, select the “Fuel
Econ. Reset” mode in the User Settings
menu on the LCD display.
- After ignition: The average fuel
economy will reset automatically
whenever it has passed 4 hours after
turning OFF the engine.
- After refueling: The average fuel
economy will reset automatically
when driving speed exceeds 1 km/h,
after adding 6 liters (1.6 gallons) of fuel
or more.
i Information
The average fuel economy may be
inaccurate, when the vehicle drives
shorter than 300 meters (0.19 miles) after
turning ON the Engine Start/Stop button.
Instant Fuel Economy (2)
• This mode displays the instant fuel
economy during the last few seconds
when the vehicle speed is more than
10 km/h (6.2 mph).

5-37
05
Accumulated Info display
OAC3069041TUOAC3069041TU
This display shows the accumulated trip
distance (1), the average fuel economy
(2), and the total driving time (3).The information is accumulated starting
from the last reset.
To manually reset the information, press
and hold the OK button when viewing
the Accumulated driving info. The trip
distance, the average fuel economy,
and total driving time will reset
simultaneously.
The accumulated driving information will
continue to be counted while the engine
is still running (for example, when the
vehicle is in traffic or stopped at a stop
light).
i Information
The vehicle must be driven for a
minimum of 300 meters (0.19 miles) since
the last ignition key cycle before the
average fuel economy will be recalculated.

5-38
Instrument cluster
Drive Info display
OAC3069040TUOAC3069040TU
This display shows the trip distance (1),
the average fuel economy (2), and the
total driving time (3).
The information is combined for each
ignition cycle. However, when the
engine has been OFF for 4 hours or
longer the Drive Info screen will reset.
To manually reset the information, press
and hold the OK button when viewing
the Drive Info. The trip distance, the
average fuel economy, and total driving
time will reset simultaneously.
The driving information will continue
to be counted while the engine is still
running (for example, when the vehicle
is in traffic or stopped at a stop light.)
i Information
The vehicle must be driven for a
minimum of 300 meters (0.19 miles) since
the last ignition key cycle before the
average fuel economy will be recalculated.