Chapter 7 HYUNDAI I20 2023 User Guide

4-16
Instrument cluster
Exhaust System (GPF)
Warning Light
(Petrol Engine,
if equipped)
7KLVZDUQLQJOLJKWLOOXPLQDWHV

[This warning light illuminates, when
accumulated soot reaches a certain
amount.

[When this warning light illuminates, it
may turn off after driving the vehicle
at more than 50 mph (80 km/h) for
about 30 minutes (above 3rd gear with
1500 ~ 4000 engine RPM).
If this warning light blinks in spite
of the procedure (at this time LCD
warning message will be displayed),
we recommend that you have the
GPF system checked by a HYUNDAI
authorised repairer.
NOTICE
If you continue to drive with the GPF
warning light blinking for a long time,
the GPF system can be damaged and
fuel consumption can worsen.
Electronic Stability
Control (ESC) indicator
light
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[When you set the ignition switch or
the Engine Start/Stop button to the
ON position.
- The Electronic Stability Control
indicator light illuminates for about 3
seconds and then goes off.

[Whenever there is a malfunction with
ESC system.
If this occurs, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.
7KLVLQGLFDWRUOLJKWEOLQNV

[Whilst the ESC is operating.
For more details, refer to “Electronic
Stability Control (ESC)” section in
chapter 6.
Electronic Stability
Control (ESC) OFF
Indicator Light
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[When you set the ignition switch or
the Engine Start/Stop button to the
ON position.
- The ESC OFF indicator light illuminates
for approximately 3 seconds and then
goes off.

[When you deactivate the ESC system
by pressing the ESC OFF button.
For more details, refer to “Electronic
Stability Control (ESC)” section in
chapter 6.

4-17
04
ECS SPORT Indicator
Light (if equipped)(6&
63257
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[When ESC SPORT is activated.
For more details, refer to “Electronic
Stability Control” in chapter 6.
AUTO STOP indicator
light (if equipped)
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV
This indicator light illuminates:
When the engine enters the Idle Stop
mode of ISG (Idle Stop and Go) system.
7KLVLQGLFDWRUOLJKWEOLQNV
When the engine automatically starts,
the AUTO STOP indicator on the cluster
will blink for 5 seconds.
For more details, refer to "ISG (Idle Stop
and Go) system" section in chapter 6.
i Information
:KHQWKHHQJLQHDXWRPDWLFDOO\VWDUWVE\
WKH,6*V\VWHPVRPHZDUQLQJOLJKWV$%6
(6&(6&2))(36RU3DUNLQJEUDNH
ZDUQLQJOLJKWPD\WXUQRQIRUDIHZ
VHFRQGV
7KLVKDSSHQVEHFDXVHRIORZEDWWHU\
YROWDJH,WGRHVQRWPHDQWKHV\VWHPKDV
PDOIXQFWLRQHG
Immobiliser indicator
light (without smart key)
(if equipped)
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[When the vehicle detects the
immobiliser in the key with the ignition
switch in the ON position.
- At this time, you can start the engine.
- The indicator light goes off after
starting the engine.
7KLVLQGLFDWRUOLJKWEOLQNV

[When there is a malfunction with the
immobiliser system.
In this case, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.

4-19
04
High Beam Assist
indicator light (if
equipped)
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV
When the high-beam is on with the light
switch in the AUTO position.
If your vehicle detects oncoming or
preceding vehicles, High Beam Assist
will switch the high beam to low beam
automatically.
For more details, refer to “High Beam
Assist (HBA)” section in chapter 5.
Light ON indicator light
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV
When the tail lights is on.
Front fog indicator light
(if equipped)
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV
When the front fog lights are on.
Rear fog indicator light
(if equipped)
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV
When the rear fog lights are on.
Forward Safety warning
light (if equipped)
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[When you set the ignition switch or
Engine Start/Stop button to the ON
position.
- The Forward Safety warning light
illuminates for approximately 3
seconds and then goes off.

[Whenever there is a malfunction with
Forward Collision-Avoidance Assist.
If this occurs, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.
For more details, refer to “Forward
Collision-Avoidance Assist (FCA)”
section in chapter 7.
Lane Safety indicator
light (if equipped)
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[[Green] When the function operating
conditions are satisfied.

[[White] The function operating
conditions are not satisfied.

[[Yellow] Whenever there is a
malfunction with Lane Keeping Assist.
If this occurs, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.
For more details, refer to “Lane Keeping
Assist (LKA)” section in chapter 7.

4-20
Instrument cluster
Cruise Indicator Light
(if equipped)
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[When Cruise Control is enabled.
For more details, refer to "Cruise
Control (CC)" in chapter 7.
SPORT Mode Indicator
Light (if equipped)
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[When you select "SPORT" mode as
drive mode.
For more details, refer to "Drive Mode
Integrated Control System" in chapter
6.
SMART Mode Indicator
Light (if equipped)
60$57
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[When you select ''SMART" mode as
drive mode.
For more details, refer to "Drive Mode
Integrated Control System'' in chapter
6.
ECO Mode Indicator
Light (If equipped)
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[When you select "ECO" mode as drive
mode.
For more details, refer to "Drive Mode
Integrated Control System" in chapter
6.
CUSTOM Mode Indicator
Light (If equipped)&86720
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[When you select "CUSTOM" mode as
drive mode.
For more details, refer to "Drive Mode
Integrated Control System" in chapter
6.

4-23
04
Lights mode
OIK047163L
This indicator displays which exterior
light is selected using the lighting
control.
Wiper mode
OCN7040039L
This indicator displays which wiper
speed is selected using the wiper
control.
Low pressure
ONX4E040019
This warning message is displayed if the
tyre pressure is low. The corresponding
tyre on the vehicle will be illuminated.
For more details, refer to “Tyre Pressure
Monitoring System (TPMS)” section in
chapter 8.
Heated Steering Wheel turned off
(if equipped)
This message illuminates if the heated
steering wheel will turn off automatically
approximately 30 minutes after the
heated steering wheel is turned on.
For more details, refer to “Heated
Steering Wheel” in chapter 5.
Low fuel
This warning message is displayed if the
fuel tank is almost out of fuel.
When this message is displayed, the low
fuel level warning light in the cluster will
come on.
It is recommended to look for the
nearest fuelling station and refuel as
soon as possible.

4-24
Instrument cluster
Low engine oil (if equipped)
This warning message is displayed when
the engine oil level should be checked.
If this warning message is displayed,
check the engine oil level as soon as
possible and add engine oil as required.
Slowly pour the recommended oil little
by little into a funnel.
Use only the specified engine oil. (Refer
to "Recommended lubricants and
capacities" section in chapter 2.)
Do not overfill the engine oil. Make sure
the oil level is not above F (Full) mark on
the dipstick.
NOTICE
If the message is displayed
continuously after adding the engine
oil and travelling approximately 31~
62 mile (50~100 km) after the engine
warms up, we recommend that the
system be checked by a HYUNDAI
authorised repairer.
Engine has overheated
(if equipped)
This warning message is displayed
when the engine coolant temperature
is above 120°C (248°F). This means that
the engine is overheated and may be
damaged.
If your vehicle is overheated, refer to
“Overheating” section in chapter 8.
Check headlight (if equipped)
This warning message is displayed if the
headlamps are not operating properly.
In addition, if a specific lamp(turn signal
lamp etc.) is not operating properly, the
warning message according to a specific
lamp (turn signal lamp etc.) is displayed.
A corresponding bulb may need to be
replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.
Check brake light (if equipped)
This warning message is displayed if the
stop lamps are not operating properly. A
lamp may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.
Check Active Air Flap system (if
equipped)
This message is displayed in the
following situations:
- There is a malfunction with the
actuator flap
- There is a malfunction with the
actuator air flap controller
- The air flap does not open
When all of the above conditions are
fixed, the warning will disappear.

4-26
Instrument cluster
LCD display modes
Modes Symbol Explanation
Trip
ComputerThis mode displays driving information such as the tripmeter,
fuel economy, etc.
For more details, refer to "Trip Computer" in this chapter.
Turn By
Turn (TBT)
This mode displays the state of the navigation.
Driving
Assist
- Smart Cruise Control
- Drive Attention Warning
- Intelligent Speed Limit Warning
User
Settings
In this mode, you can change settings of the doors, lamps,
etc.
Warning
- This mode displays warning messages related to the
lamp malfunction, etc.
- Tyre pressure information
The information provided may differ depending on which functions are applicable
to your vehicle.

4-27
04
Trip computer mode
OIK047124N
The trip computer mode displays
information related to vehicle driving
parameters including fuel economy,
tripmeter information and vehicle speed.
For more details, refer to "Trip
Computer" in this chapter.
Turn By Turn (TBT) group
OIK047151N
This group displays the state of the
navigation.
Driving Assist mode
OBC3070041
6&&,6/$
This mode displays the state of Smart
Cruise Control, Intelligent Speed Limit
Assist.
For more details, refer to each system
information Section in chaptet 7.
OBC3070068
'ULYHU$WWHQWLRQ:DUQLQJ
LIHTXLSSHG
This group displays information related
to Driver Attention Warning.
For more details, refer to "Driver
Attention Warning (DAW)" in chapter 7.

4-28
Instrument cluster
Master warning
OTM050218L
This warning light informs the driver the
following situations.
- Forward Collision-Avoidance Assist
malfunction (if equipped)
- Forward Collision-Avoidance Assist
radar blocked (if equipped)
- Blind-Spot Collision Warning
malfunction (if equipped)
- Blind-Spot Collision Warning radar
blocked (if equipped)
- Lamp malfunction (if equipped)
- High Beam Assist malfunction
(if equipped)
- Smart Cruise Control malfunction
(if equipped)
- Tyre Pressure Monitoring System
malfunction
The Master Warning Light illuminates
if one or more of the above warning
situations occur.
At this time, a Master Warning icon (
)
will appear beside the User Settings icon
(
), on the LCD display.
If the warning situation is solved, the
master warning light will be turned
off and the Master Warning icon will
disappear.
ONX4E040023
7\UH3UHVVXUH
This mode displays information related
to Tyre Pressure.
For more details, refer to "Tyre Pressure
Monitoring System (TPMS)" in chapter
8.

4-30
Instrument cluster
'ULYHU$VVLVWDQFH
ItemsExplanation
Drive
convenienceAuto highway speed control
To activate or deactivate the Auto highway speed Control.
For more details, refer to the ''Navigation-based Smart Cruise Control
(NSCC)'' in chapter 7.
Speed limitTo adjust the Speed Limit function.

[6SHHGOLPLWWROHUDQFH

[6SHHGOLPLWDVVLVW

[6/:6SHHG/LPLW:DUQLQJ

[2II
For more details, refer to the “Intelligent Speed Limit Assist (ISLA)” in
chapter 7.
Warning timingTo adjust the warning timing of the driver assistance system.

[1RUPDO/DWH
Warning volumeTo adjust the warning timing of the driver assistance system.

[+LJK0HGLXP/RZ2II
DAW (Drive
attention
warning)
[/HDGLQJYHKLFOHGHSDUWXUHDOHUW
To activate or deactivate the Leading vehicle departure alert.

[,QDWWHQWLYHGULYLQJZDUQLQJ
To activate or deactivate the Driver Attention Warning.
For more details, refer to the “Driver Attention Warning (DAW)” in
chapter 7.
Forward safetyTo adjust Forward Collision-Avoidance Assist function.

[$FWLYH$VVLVW

[:DUQLQJ2QO\

[2II
For more details, refer to the "Forward Collision-Avoidance Assist
(FCA)" in chapter 7.
Lane safetyTo adjust the Lane Keeping Assist function.

[/DQH.HHSLQJ$VVLVW

[/DQH'HSDUWXUH:DUQLQJ

[2II
For more details, refer to "Lane Keeping Assist (LKA)" in chapter 7.
Blind-spot
safetyTo activate or deactivate the Blind-Spot View Monitor.

[$FWLYH$VVLVW

[:DUQLQJ2QO\

[2II
For more details, refer to the "Blind-Spot View Moniter (BVM)" in
chapter 7.