warning lights INFINITI EX 2013 Quick Reference Guide

2
new system features
Blind Spot Warning (BSW) System (if so equipped)
The control switch is located on the left side of the
instrument panel.

The system automatically turns on when the engine
is started and the indicator light on the switch

01
illuminates.


The BS w indicator lights
02 , located next to the
outside mirrors, will activate when the BS w system
detects a vehicle in the detection zone.

If the turn signal is activated in the direction of a
detected vehicle, a chime sounds twice and the BS w
indicator light will flash.

To cancel the system, push the control switch and the
warning systems ON indicator will turn off.
For more information, refer to the “Instruments and controls (section 2)” and
the “Starting and driving (section 5)” of your Owner’s Manual.
01
02

4
first drive features
INFINITI Intelligent Key™ System
The INFINITI Intelligent Key™ System allows you to lock or
unlock your vehicle, open your liftgate and start the engine.
NOTE: It is important to make sure the Intelligent Key is
with you (that is, in your pocket or purse).

The operating range of the Intelligent Key is within
31.5 in (80 cm) from each request switch.

To lock the vehicle, push either door handle request
switch

01 or the liftgate request switch
02 or press
the

button
03 on the keyfob.

To unlock the vehicle, perform one of the following
procedures:
• Push either door handle request switch

01 or the
liftgate request switch
02 ; the corresponding door will unlock.
Push the door handle request switch
01 or the liftgate request
switch
02 again within 1 minute; all other doors will unlock, or
• Press the

button
04 on the keyfob to unlock the driver’s side

door. Press the

button again; all other doors will unlock.

The Intelligent Key can also be used to activate the panic alarm by
pressing and holding the

button
05 for more than 1 second. Once

activated, the panic alarm and headlights will stay on for 25 seconds.
INFINITI INTELLIGENT KEY
™ BATTERY DIScHARGE

If the battery in the Intelligent Key is almost discharged,
the guide light

06 of the Intelligent Key port blinks and
the Intelligent Key insertion indicator
07 is displayed
in the dot matrix liquid crystal display.

To start the engine under these circumstances, insert
the Intelligent Key into the key port with the keyring
side facing backward until it latches into place. Then
push the ignition switch to start the engine.

To remove the Intelligent Key from the port, push the
ignition switch to turn the engine off and then pull the
Intelligent Key out of the port.

The Intelligent Key port does not charge the Intelligent
Key battery. If you see the Intelligent Key warning light

08 , replace the battery in the Intelligent Key.
For more information, refer to the “Pre-driving checks and adjustments
(section 3)”, “Starting and driving (section 5)” and the “Maintenance
and do-it yourself (section 8)” of your Owner’s Manual.
01
02
03
04
05
F
E
07
08
06