phone INFINITI FX35 2005 User Guide
Page 793 of 4731
AV-194
INFINITI MOBILE ENTERTAINMENT SYSTEM
Revision: 2005 July 2005 FX
4. CHECK DATA (DVD – LCD) SIGNAL
1. Connect DVD display connector and DVD player connector.
2. Turn ignition switch ACC.
3. Check voltage between DVD display harness connector B192 terminal 13 (GY) and ground.
OK or NG
OK >> Replace DVD display.
NG >> Replace DVD player.
Head Phone Does Not SoundAKS007WR
1. CHECK HEAD PHONE AND SIGNAL
Check the inspection items below to diagnose the malfunction.
Check that the signal is received at the rear seat.
Check that transmission part has any seals or dirt that interrupts
signal.
Check that the head phone battery has run down.
OK or NG
OK >> GO TO 2.
NG >>
Receive signal with head phone at the rear seat.
Remove seal or dirt that is interrupting signal.
If the battery has run down, replace it with new one.
2. CHECK HEAD PHONE
Check that sound is heard with another head phone.
OK or NG
OK >> Replace malfunction head phone.
NG >> GO TO 3.
3. CHECK HARNESS
1. Turn ignition switch OFF.
2. Disconnect DVD player connector and DVD display connector.
3. Check continuity between DVD player harness connector B19 terminal 17 (G), 18 (L), 19 (LG), 20 (Y) and DVD display harness
connector B192 terminal 1 (G), 2 (L), 3, 4 (Y).
4. Check continuity between DVD player harness connector B19 terminal 17 (G), 18 (L), 19 (LG), 20 (Y) and ground.
OK or NG
OK >> GO TO 4.
NG >> Repair harness or connector. 13 (GY)
– Ground : Refer to
AV- 1 8 6 , "
Terminals and
Reference Value for DVD Player" .
SKIB0334E
SKIA5852E
17 (G) – 1 (G) : Continuity should exist.
18 (L) – 2 (L) : Continuity should exist.
19 (LG) – 3 : Continuity should exist.
20 (Y) – 4 (Y) : Continuity should exist.
17 (G), 18 (L), 19 (LG),
20 (Y) – Ground : Continuity should not exist.
SKIA7033E
Page 1419 of 4731
EC-26
[VQ35DE]
PRECAUTIONS
Revision: 2005 July 2005 FX
B1 indicates the bank 1, B2 indicates the bank 2 as shown
in the figure.
Do not operate fuel pump when there is no fuel in lines.
Tighten fuel hose clamps to the specified torque.
Do not depress accelerator pedal when starting.
Immediately after starting, do not rev up engine unneces-
sarily.
Do not rev up engine just prior to shutdown.
When installing C.B. ham radio or a mobile phone, be sure
to observe the following as it may adversely affect elec-
tronic control systems depending on installation location.
–Keep the antenna as far as possible from the electronic
control units.
–Keep the antenna feeder line more than 20 cm (8 in) away
from the harness of electronic controls.
Do not let them run parallel for a long distance.
–Adjust the antenna and feeder line so that the standing-
wave radio can be kept smaller.
–Be sure to ground the radio to vehicle body.
SEC893C
PBIB1569E
SEF709Y
SEF708Y
Page 2111 of 4731
EC-718
[VK45DE]
PRECAUTIONS
Revision: 2005 July 2005 FX
Do not operate fuel pump when there is no fuel in lines.
Tighten fuel hose clamps to the specified torque.
Do not depress accelerator pedal when starting.
Immediately after starting, do not rev up engine unneces-
sarily.
Do not rev up engine just prior to shutdown.
When installing C.B. ham radio or a mobile phone, be sure
to observe the following as it may adversely affect elec-
tronic control systems depending on installation location.
–Keep the antenna as far as possible from the electronic
control units.
–Keep the antenna feeder line more than 20 cm (8 in) away
from the harness of electronic controls.
Do not let them run parallel for a long distance.
–Adjust the antenna and feeder line so that the standing-
wave radio can be kept smaller.
–Be sure to ground the radio to vehicle body.
PBIB1508E
SEF709Y
SEF708Y