start stop button INFINITI QX80 2014 Quick Reference Guide
Page 10 of 28
8
first drive features
INFINITI Intelligent Key System
The INFINITI Intelligent Key system allows you to lock
or unlock your vehicle, open your liftgate and start the
engine. It is important to make sure the Intelligent Key
is with you (that is, in your pocket or purse).
REMOTE ENGINE START*
The remote engine start system must be enabled in
the vehicle settings within the vehicle information display.
The remote engine start operating range is approximately
200 ft (60 m) from the vehicle. The effective operating range
may be shorter due to environmental conditions or obstacles
between you and the vehicle.
For the remote engine start to function, the vehicle must be
in the P (PARK) position with the ignition off, and all the doors
closed and locked.
To start your vehicle remotely:
1.
Press the button
02
2. Within 5 seconds press and hold the remote engine start
button
06 for at least 2 seconds.
The engine will start and the parking lights will turn on.
Automatic climate control will begin heating or cooling the vehicle depe\
nding on the
last used mode.
The engine will run for 10 minutes and then turn off.
Repeat steps 1 and 2 to extend the time for an additional 10 minute peri\
od.
•
After two remote starts the ignition switch must be cycled before the re\
mote start can
be used again.
To start driving depress the brake pedal and push the ignition switch START/STOP button.
To lock the vehicle, push either door handle request switch 01 once or press the button
02 on the key fob.
To unlock the vehicle, perform one of the following procedures:
•
Push either door handle request switch 01 once; the corresponding door will unlock. Push
the door handle request switch
01 again within 1 minute; all other doors will unlock, or
•
Press the button 03 on the key fob to unlock the driver’s side door. Press the button
again; all other doors will unlock.
To open the liftgate, press the button 04 for more than 1 second.
The Intelligent Key can also be used to activate the panic alarm by pres\
sing and holding
the
button 05 for more than 1 second. Once activated, the panic alarm and headlights
will stay on for a period of time.
01
06
02
03
04
05
1591592_14b_Infiniti_QX80_QRG_093013.indd 89/30/13 9:35 AM
Page 15 of 28
13
Outside Mirror Control Switch
Move the control switch 01 right or left to select the
right or left side mirror.
Adjust each mirror to the desired position using the
switch
02.
Move this switch 01 to the center (neutral) position
to prevent accidentally moving the mirror.
POWER FOLDING OUTSIDE MIRRORS
To fold the outside rearview mirrors, push the switch 03 to the
position. To unfold the
outside rearview mirrors, push the switch
03 to the
position. If mirrors are manually operated or bumped, the mirror body can become l\
oose at the
pivot point.
To correct electronic mirror operation, cycle mirrors by pushing the out\
side rearview mirror
folding switch
03 to the
position until completely closed, then push the switch 03 to
the
position until the mirror is completely open.
REVERSE TILT-DOWN FEATURE
When backing up the vehicle, the right or left outside mirrors will turn\
downward automatically
to provide better rear visibility.
1.
Push the ignition switch to the
ON position.
2.
Move the shift lever to the
R (REVERSE) position.
3.
Choose the right or left outside mirror by operating the outside mirror \
control switch.
4.
The outside mirror surfaces move downward.
When one of the following conditions has occurred, the outside mirror su\
rfaces will return
to their original positions.
•
The shift lever is moved to any position other than
R (REVERSE).
•
The outside mirror control switch is set to the center (neutral) posit\
ion.
•
The ignition switch is pushed to the
OFF position.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
Starting/Stopping the Engine
It is important to make sure the INFINITI Intelligent
Key is with you (that is, in your pocket or purse).
Depress the brake pedal.
Press the ignition switch START/STOP button to start
the engine.
TURNING THE ENGINE OFF
Move the shift lever to the P (PARK) position and apply the parking brake.
Press the ignition switch START/STOP button to turn the engine off.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
01
02
03
1591592_14b_Infiniti_QX80_QRG_093013.indd 139/30/13 9:36 AM