airbag disable ISUZU TF SERIES 2004 Workshop Manual

RESTRAINT CONTROL 9A1-5

The SRS control unit displays the trouble codes by
flashing the warning lamp. Each code that is displayed
will consist of a number of flashes which represents the
tens digit, a 1.2 second pause, following by a number of
flashes which represents the ones digit of the code.
Each code is displayed one time before moving on to
the next code. After all of the codes have been
displayed, the entire code sequence will continually by
repeated until ground is removed from terminal 4 of the
DLC connector.


Two special codes exist when reading in the flash code
mode (Flash Code 12 and Flash Code 13). “Flash
Code 12” will always be the first code displayed when
the flash code mode is enable Code 12 is not an
indication of a SRS problem but an indication that the
flash code mode has been enabled. If there are no
active or history codes present, the SRS control unit will
display code 12 until ground is removed from the DLC
connector at terminal 4. “flash Code 13” will be
displayed if history codes are present. To read the
history codes a scan tool must be used.


060R300051
DATA LIST (Tech 2)









DISPLAY on Tech 2 UNIT VALUE
Driver Airbag Loop
Enabled/Disabled
Passenger Airbag Loop
Enabled/Disabled
System Voltage V 12.0
Driver Seat Belt Status
Not Backled/Backled