engine JEEP CHEROKEE 2022 User Guide

:$51,1*

An incorrectly anchored tether strap could
lead to increased head motion and possible
injury to the child. Use only the anchorage
position directly behind the child seat to
secure a child restraint top tether strap.

If your vehicle is equipped with a split rear
seat, make sure the tether strap does not
slip into the opening between the seat-
backs as you remove slack in the strap.WARNING!
Do not leave children or animals inside
parked vehicles in hot weather. Interior
heat build-up may cause serious injury or
death.
It is extremely dangerous to ride in a cargo
area, inside or outside of a vehicle. In a
collision, people riding in these areas are
more likely to be seriously injured or killed.
Do not allow people to ride in any area of
your vehicle that is not equipped with seats
and seat belts.
Be sure everyone in your vehicle is in a seat
and using a seat belt properly.
WARNING!

Exhaust gases can injure or kill. They contain
carbon monoxide (COyfZKLFKLVFRORUOHVVDQG
odorless. Breathing it can make you
unconscious and can eventually poison you.
To avoid breathing (COyfIROORZWKHVHVDIHW\
tips:

Do not run the engine in a closed garage or
in confined areas any longer than needed
to move your vehicle in or out of the area.
If you are required to drive with the trunk/
liftgate/rear doors open, make sure that all
windows are closed and the climate control
BLOWER switch is set at high speed.
DO NOT use the recirculation mode.
If it is necessary to sit in a parked vehicle
with the engine running, adjust your
heating or cooling controls to force outside
air into the vehicle. Set the blower at high
speed.

WARNING!
ALWAYS obey traffic laws and pay attention to
the road. ALWAYS drive safely with your hands
on the steering wheel. You have full
responsibility and assume all risks related to
the use of the features and applications in
this vehicle. Only use the features and
applications when it is safe to do so. Failure
to do so may result in an accident involving
serious injury or death.
CAUTION!
To avoid damage to the mirror during
cleaning, never spray any cleaning solution
directly onto the mirror. Apply the solution
onto a clean cloth and wipe the mirror clean.
WARNING!
When replacing a blown fuse, always use
an appropriate replacement fuse with the
same amp rating as the original fuse. Never
replace a fuse with another fuse of higher
amp rating. Never replace a blown fuse with
metal wires or any other material. Do not
place a fuse inside a circuit breaker cavity
or vice versa. Failure to use proper fuses
may result in serious personal injury, fire
and/or property damage.
Before replacing a fuse, make sure that the
ignition is off and that all the other services
are switched off and/or disengaged.
If the replaced fuse blows again, contact an
authorized dealer.
If a general protection fuse for safety
systems (air bag system, braking systemyf
power unit systems (engine system, trans-
mission systemyfRUVWHHULQJV\VWHPEORZV
contact an authorized dealer.
7

21_KL_OM_EN_USC_t.book Page 331

:$51,1*
Do not attempt to change a tire on the side
of the vehicle close to moving traffic. Pull
far enough off the road to avoid the danger
of being hit when operating the jack or
changing the wheel.
Being under a jacked-up vehicle is
dangerous. The vehicle could slip off the
jack and fall on you. You could be crushed.
Never put any part of your body under a
vehicle that is on a jack. If you need to get
under a raised vehicle, take it to a service
center where it can be raised on a lift.
Never start or run the engine while the
vehicle is on a jack.
WARNING!
Do not attempt to change a tire on the side of
the vehicle close to moving traffic. Pull far
enough off the road to avoid being hit when
operating the jack or changing the wheel.
WARNING! (Continuedyf
7

21_KL_OM_EN_USC_t.book Page 339

:$51,1*
&DUHIXOO\IROORZWKHVHWLUHFKDQJLQJZDUQLQJV
WRKHOSSUHYHQWSHUVRQDOLQMXU\RUGDPDJHWR
\RXUYHKLFOH
Always park on a firm, level surface as far
from the edge of the roadway as possible
before raising the vehicle.
Turn on the Hazard Warning Flashers.
Apply the parking brake firmly and set an
automatic transmission in PARK.
Block the wheel diagonally opposite the
wheel to be raised.
Never start or run the engine with the
vehicle on a jack.
Do not let anyone sit in the vehicle when it
is on a jack.
Do not get under the vehicle when it is on a
jack. If you need to get under a raised
vehicle, take it to a service center where it
can be raised on a lift.
WARNING! (Continuedyf
7

21_KL_OM_EN_USC_t.book Page 341

:$51,1*
)DVWVSLQQLQJWLUHVFDQEHGDQJHURXV)RUFHV
JHQHUDWHGE\H[FHVVLYHZKHHOVSHHGVPD\
FDXVHGDPDJHRUHYHQIDLOXUHRIWKHD[OH
DQGWLUHV$WLUHFRXOGH[SORGHDQGLQMXUH
VRPHRQH'RQRWVSLQ\RXUYHKLFOH
VZKHHOV
IDVWHUWKDQ PSK NPK\fRUIRUORQJHUWKDQVHFRQGVFRQWLQXRXVO\ZLWKRXW
VWRSSLQJZKHQ\RXDUHVWXFNDQGGRQRWOHW
DQ\RQHQHDUDVSLQQLQJZKHHOQRPDWWHU
ZKDWWKHVSHHG
&$87,21
Racing the engine or spinning the wheels
may lead to transmission overheating and
failure. Allow the engine to idle with the
transmission in NEUTRAL for at least
one minute after every five rocking-motion
cycles. This will minimize overheating and
reduce the risk of clutch or transmission
failure during prolonged efforts to free a
stuck vehicle.
When “rocking” a stuck vehicle by shifting
between DRIVE and REVERSE, do not spin
the wheels faster than 15 mph (24 km/hyf or drivetrain damage may result.
Revving the engine or spinning the wheels
too fast may lead to transmission over -
heating and failure. It can also damage the
tires. Do not spin the wheels above 30 mph
(48 km/hyfZKLOHLQJHDUQRWUDQVPLVVLRQ
shifting occurringyf.

SERVICING AND MAINTENANCE
SC\b\fED SERVICING
Your vehicle is equipped with an automatic oil
change indicator system. The oil change
indicator system will remind you that it is time to
take your vehicle in for scheduled maintenance.
Based on engine operation conditions, the oil
change indicator message will illuminate.
This means that service is required for your
vehicle. Operating conditions such as frequent
short-trips, trailer tow, or extremely hot or cold
ambient temperatures will influence when the
“Oil Change Required” message is displayed.
Severe operating conditions can cause the
change oil message to illuminate as early as
3,500 miles (5,600 kmyfVLQFHODVWUHVHW+DYH
your vehicle serviced as soon as possible,
within the next 500 miles (805 kmyf.An authorized dealer will reset the oil change
indicator message after completing the
scheduled oil change. If a scheduled oil change
is performed by someone other than an
authorized dealer, the message can be reset
by referring to the steps described under
Instrument Cluster Display Ú
page 89.
NOTE:
Under no circumstances should oil change
intervals exceed 10,000 miles (16,000 kmyf
12 months or 350 hours of engine run time,
whichever comes first. The 350 hours of engine
run or idle time is generally only a concern for
fleet customers. Severe Duty All Models
Vehicles that are operated in a dusty and
off-road environment, or predominately at idle
or very low engine RPM are known as Severe
Duty vehicles. It is recommended that you
change engine oil at 4,000 miles (6,500 kmyfRU
350 hours of engine run time.
At Every Fuel Stop:
Check engine oil level.
Check windshield washer fluid level.
Check tire pressure and look for unusual
wear or damage. Rotate tires at the first sign
of irregular wear, even if it occurs before the
oil indicator system turns on.
Check the fluid levels of the coolant reservoir
and brake master cylinder; fill as needed.
Check function of all interior and exterior
lights.
8

21_KL_OM_EN_USC_t.book Page 363

WARNING!

The air induction system (air cleaner, hoses,
etc.yfFDQSURYLGHDPHDVXUHRISURWHFWLRQLQWKH
case of engine backfire. Do not remove the air
induction system (air cleaner, hoses, etc.yf
unless such removal is necessary for repair or
maintenance. Make sure that no one is near
the engine compartment before starting the
vehicle with the air induction system (air
cleaner, hoses, etc.yfUHPRYHG)DLOXUHWRGRVR
can result in serious personal injury.

1 — Clean Air Hose Clamp
2 — Screws
1 — Screws
2 — Electrical Connector
3 — Clean Air Hose Clamp
8

21_KL_OM_EN_USC_t.book Page 373

:$51,1*

You or others can be badly burned by hot
engine coolant (antifreezeyfRUVWHDPIURP\RXU
radiator. If you see or hear steam coming from
under the hood, do not open the hood until the
radiator has had time to cool. Never open a
cooling system pressure cap when the radiator
or coolant bottle is hot.
WARNING! (Continuedyf

:$51,1*
Do not open hot engine cooling system.
Never add engine coolant (antifreezeyfZKHQ
the engine is overheated. Do not loosen or
remove the cap to cool an overheated
engine. Heat causes pressure to build up in
the cooling system. To prevent scalding or
injury, do not remove the pressure cap
while the system is hot or under pressure.
Do not use a pressure cap other than the
one specified for your vehicle. Personal
injury or engine damage may result.

TEC\b 
\f SPECIFICATIONS
VE\b \fE IDENTIFICATION NUMBER
The Vehicle Identification Number (VINyfLVIRXQG
on the left front corner of the instrument panel.
The VIN is visible from outside of the vehicle
through the windshield.
Vehicle Identification Number

NOTE:
It is illegal to remove or alter the VIN.
BRAKE SYSTEM
Your vehicle is equipped with dual hydraulic
brake systems. If either of the two hydraulic
systems loses normal capability, the remaining
system will still function. However, there will be
some loss of overall braking effectiveness.
You may notice increased pedal travel during
application, greater pedal force required to slow
or stop, and potential activation of the Brake
Warning Light.
In the event power assist is lost for any reason
(i.e., repeated brake applications with the
engine OFFyfWKHEUDNHVZLOOVWLOOIXQFWLRQ
However, the effort required to brake the
vehicle will be much greater than that
required with the power system operating.
W\b\f AND TIRE TORQUE SPECIFICATIONS
Proper lug nut/bolt torque is very important to
ensure that the wheel is properly mounted to
the vehicle. Any time a wheel has been removed
and reinstalled on the vehicle, the lug nuts/
bolts should be torqued using a properly
calibrated torque wrench using a six sided (hexyf
deep wall socket.
TORQUE SPECIFICATIONS
**Use only authorized dealer recommended
lug nuts/bolts and clean or remove any dirt or
oil before tightening.
Lug Nut/Bolt
Torque **Lug Nut/
Bolt SizeLug Nut/Bolt
Socket Size
100 Ft-Lbs
(135 N·myf M12 x 1.25 19 mm
9

21_KL_OM_EN_USC_t.book Page 411