engine JEEP CHEROKEE TRAILHAWK 2020 User Guide

:$51,1*
&DUHIXOO\IROORZWKHVHWLUHFKDQJLQJZDUQLQJV
WRKHOSSUHYHQWSHUVRQDOLQMXU\RUGDPDJHWR
\RXUYHKLFOH
Always park on a firm, level surface as far
from the edge of the roadway as possible
before raising the vehicle.
Turn on the Hazard Warning Flashers.
Apply the parking brake firmly and set an
automatic transmission in PARK.
Chock the wheel diagonally opposite the
wheel to be raised.
Never start or run the engine with the
vehicle on a jack.
Do not let anyone sit in the vehicle when it
is on a jack.
Do not get under the vehicle when it is on a
jack. If you need to get under a raised
vehicle, take it to a service center where it
can be raised on a lift.
WARNING! (Continuedyf
6

20_KL_OM_EN_USC_t.book Page 295

:$51,1*
)DVWVSLQQLQJWLUHVFDQEHGDQJHURXV)RUFHV
JHQHUDWHGE\H[FHVVLYHZKHHOVSHHGVPD\
FDXVHGDPDJHRUHYHQIDLOXUHRIWKHD[OH
DQGWLUHV$WLUHFRXOGH[SORGHDQGLQMXUH
VRPHRQH'RQRWVSLQ\RXUYHKLFOH
VZKHHOV
IDVWHUWKDQ PSK NPK\fRUIRUORQJHUWKDQVHFRQGVFRQWLQXRXVO\ZLWKRXW
VWRSSLQJZKHQ\RXDUHVWXFNDQGGRQRWOHW
DQ\RQHQHDUDVSLQQLQJZKHHOQRPDWWHU
ZKDWWKHVSHHG
&$87,21
Racing the engine or spinning the wheels
may lead to transmission overheating and
failure. Allow the engine to idle with the
transmission in NEUTRAL for at least one
minute after every five rocking-motion
cycles. This will minimize overheating and
reduce the risk of clutch or transmission
failure during prolonged efforts to free a
stuck vehicle.
When “rocking” a stuck vehicle by shifting
between DRIVE and REVERSE, do not spin
the wheels faster than 15 mph (24 km/hyf or drivetrain damage may result.
Revving the engine or spinning the wheels
too fast may lead to transmission over -
heating and failure. It can also damage the
tires. Do not spin the wheels above 30 mph
(48 km/hyfZKLOHLQJHDUQRWUDQVPLVVLRQ
shifting occurringyf.

SERVICING AND MAINTENANCE
SC\b\fED SERVICING
Your vehicle is equipped with an automatic oil
change indicator system. The oil change
indicator system will remind you that it is time to
take your vehicle in for scheduled maintenance.
Based on engine operation conditions, the oil
change indicator message will illuminate. This
means that service is required for your vehicle.
Operating conditions such as frequent
short-trips, trailer tow, or extremely hot or cold
ambient temperatures will influence when the
“Oil Change Required” message is displayed.
Severe Operating Conditions can cause the
change oil message to illuminate as early as 3,
500 miles (5,600 kmyfVLQFHODVWUHVHW+DYH your vehicle serviced as soon as possible,
within the next 500 miles (805 kmyf. An authorized dealer will reset the oil change
indicator message after completing the
scheduled oil change. If a scheduled oil change
is performed by someone other than an
authorized dealer, the message can be reset by
referring to the steps described under
“Instrument Cluster Display” in “Getting to
Know Your Instrument Panel” for further
information.
NOTE:
Under no circumstances should oil change
intervals exceed 10,000 miles (16,000 kmyf
12 months or 350 hours of engine run time,
whichever comes first. The 350 hours of engine
run or idle time is generally only a concern for
fleet customers.
Severe Duty All Models
Change Engine Oil at 4,000 miles (6,500 kmyfRU
350 hours of engine run time if the vehicle is
operated in a dusty and off road environment or
is operated predominately at idle or only very
low engine RPM. This type of vehicle use is
considered Severe Duty.
At Every Fuel Stop:
Check engine oil level.
Check windshield washer fluid level.
Check tire pressure and look for unusual
wear or damage. Rotate tires at the first sign
of irregular wear, even if it occurs before the
oil indicator system turns on.
Check the fluid levels of the coolant reservoir
and brake master cylinder, fill as needed.
Check function of all interior and exterior
lights.
7

20_KL_OM_EN_USC_t.book Page 315

:$51,1*
Do not open hot engine cooling system.
Never add engine coolant (antifreezeyfZKHQ
the engine is overheated. Do not loosen or
remove the cap to cool an overheated
engine. Heat causes pressure to build up in
the cooling system. To prevent scalding or
injury, do not remove the pressure cap
while the system is hot or under pressure.
Do not use a pressure cap other than the
one specified for your vehicle. Personal
injury or engine damage may result.