turn signal JEEP COMMANDER 2006 1.G User Guide

INSTRUMENT CLUSTER DESCRIPTION
1. Speedometer
Indicates vehicle speed.
2. Brake Warning Light
The BRAKE warning light will come on when
the ignition is first turned on, and stay on
briefly as a bulb check. If the bulb does not
come on during starting, have the bulb re-
paired promptly. If the light stays on longer, it may be an
indication that the parking brake has not been released.
If the light remains on when the parking brake is off, it
indicates a possible brake hydraulic system malfunction
or low fluid level. In this case, the light will remain on
until the cause is corrected. If a brake malfunction is
indicated, immediate repair is necessary and continued
operation of the vehicle in this condition is dangerous.3. Turn Signal Indicator Light
The arrow will flash with the exterior turn signal
when the turn signal lever is operated.
If the vehicle electronics sense that the vehicle has
traveled about one mile with the turn signals on, a chime
will sound to alert you to turn the signals off. If either
indicator flashes at a rapid rate, check for a defective
outside light bulb.
4. High Beam Indicator Light
Indicates that headlights are on high beam.
5. Malfunction Indicator Light
This light is part of an onboard diagnostic system
called OBD II that monitors engine and auto-
matic transmission control systems. The light will
illuminate when the key is in the ON position before
178 UNDERSTANDING YOUR INSTRUMENT PANEL

ELECTRONIC VEHICLE INFORMATION CENTER
— IF EQUIPPED
The electronic vehicle information center (EVIC) located
in the instrument cluster, when the appropriate condi-
tions exist, will display the following messages and
symbols. Some of the messages are accompanied by a
chime.
•TURN SIGNAL ON
•PERFORM SERVICE
•KEY NOT PROGRAMMED — DAMAGED KEY
•KEY NOT PROGRAMMED — INVALID KEY
•KEY NOT PROGRAMMED — EXCEEDED KEY PRO-
GRAM LIMIT
•PROGRAMMING ACTIVE — NEW KEY PRO-
GRAMMED
•SERVICE SECURITY KEY
•INVALID KEY — TRY ALTERNATE KEY
•DRIVER/PASSENGER DOOR OPEN (with graphic)
•LEFT/RIGHT REAR DOOR OPEN (with graphic)
•X DOORS OPEN (with graphic)
•LIFTGATE OPEN (with graphic)
186 UNDERSTANDING YOUR INSTRUMENT PANEL

memory set position using the door mounted switch.
Pressing the STEP button when in this display will select
“Yes” or “No.”
Sound Horn With Lock?
When this feature is selected a short horn sound will
occur when the remote keyless entry “Lock” button is
pressed. This feature may be selected with or without the
flash lights on lock/unlock feature. Pressing the STEP
button when in this display will select “Yes” or “No.”
Flash Lights With Lock?
When this feature is selected, the front and rear turn
signals will flash when the doors are locked or unlocked
using the remote keyless entry transmitter. This feature
may be selected with or without the sound horn on lock
feature selected. Pressing the STEP button when in this
display will select “Yes” or “No.”
Headlamp Delay
When this feature is selected the driver can choose, when
exiting the vehicle, to have the headlamps remain on for
30, 60, or 90 seconds, or not remain on. Pressing the STEP
button when in this display will select 30, 60, 90, or OFF.
Illuminated Approach?
When this feature is selected the driver can choose, when
entering the vehicle, to have the headlamps come on for
30, 60, or 90 seconds, or not come on at all. Pressing the
STEP button when in this display will select 30, 60, 90, or
OFF.
Auto Headlamp Low/High Beams? (Available with
SmartBeam Only)
When this feature is selected and the headlight switch
has been moved to the A (Auto) position, the headlights
will automatically switch from high to low beams when
approaching a vehicle. Pressing the STEP button when in
UNDERSTANDING YOUR INSTRUMENT PANEL 191
4

To set the variance: Turn the ignition ON and set the
display to “Compass/Temperature.” Press the C/T but-
ton for approximately 5 seconds. The last variance zone
number will be displayed. Press and hold the STEP
button for 1 second to select the new variance zone and
press the RESET button to resume normal operation.
RADIO GENERAL INFORMATION
Radio Broadcast Signals
Your new radio will provide excellent reception under
most operating conditions. Like any system, however, car
radios have performance limitations, due to mobile op-
eration and natural phenomena, which might lead you to
believe your sound system is malfunctioning. To help
you understand and save you concern about these “ap-
parent” malfunctions, you must understand a point or
two about the transmission and reception of radio sig-
nals.
UNDERSTANDING YOUR INSTRUMENT PANEL 199
4

Two Types of Signals
There are two basic types of radio signals... AM or
Amplitude Modulation, in which the transmitted sound
causes the amplitude, or height, of the radio waves to
vary... and FM or Frequency Modulation, in which the
frequency of the wave is varied to carry the sound.
Electrical Disturbances
Radio waves may pick up electrical disturbances during
transmission. They mainly affect the wave amplitude,
and thus remain a part of the AM reception. They
interfere very little with the frequency variations that
carry the FM signal.
AM Reception
AM sound is based on wave amplitude, so AM reception
can be disrupted by such things as lightning, power lines
and neon signs.
FM Reception
Because FM transmission is based on frequency varia-
tions, interference that consists of amplitude variations
can be filtered out, leaving the reception relatively clear,
which is the major feature of FM radio.
NOTE:On vehicles so equipped the radio, steering
wheel radio controls and 6 disc CD/DVD changer will
remain active for up to 45 seconds after the ignition
switch has been turned off. Opening a vehicle front door
will cancel this feature.
SALES CODE RAQ – AM/FM/CD (6-DISC) RADIO
WITH OPTIONAL SATELLITE RADIO, HANDS
FREE PHONE, AND VEHICLE ENTERTAINMENT
SYSTEMS (VES) CAPABILITIES
NOTE:The radio sales code is located on the lower right
side of your radio faceplate.
200 UNDERSTANDING YOUR INSTRUMENT PANEL

An electronically actuated trailer brake controller is
required when towing a trailer with electronically
actuated brakes. When towing a trailer equipped with
a hydraulic surge actuated brake system, an electronic
brake controller is not required.
Trailer brakes are recommended for trailers over 1,000
lbs (454 kg) and required for trailers in excess of 2,000
lbs (907 kg).
CAUTION!
If the trailer weighs more than 1,000 lbs (454 kg)
loaded, it should have its own brakes and they
should be of adequate capacity. Failure to do this
could lead to accelerated brake lining wear, higher
brake pedal effort, and longer stopping distances.
WARNING!
Do not connect trailer brakes to your vehicle’s hy-
draulic brake lines. It can overload your brake sys-
tem and cause it to fail. You might not have brakes
when you need them and could have an accident.
Towing any trailer will increase your stopping dis-
tance. When towing you should allow for additional
space between your vehicle and the vehicle in front
of you. Failure to do so could result in an accident.
Towing Requirements — Trailer Lights & Wiring
Whenever you pull a trailer, regardless of the trailer size,
stop lights and turn signals on the trailer are required for
motoring safety.
The Trailer Tow Package may includea4and7pin
wiring harness. Use a factory approved trailer harness
and connector.
320 STARTING AND OPERATING

HAZARD WARNING FLASHERS
Your vehicle’s hazard warning flasher is an emergency
warning system. When you activate it, all front and rear
directional signals will flash intermittently. Use it when
your vehicle is disabled on or near the road. It warns
other drivers to steer clear of you and your vehicle. This
is an emergency warning system, not to be used when the
vehicle is in motion.
To activate the warning flasher, push down on the button
on top of the steering column until it latches. To turn the
warning flasher off, push down again to unlatch the
button.
NOTE:With extended use, the flasher may run down
your battery.
Hazard Warning Switch
330 WHAT TO DO IN EMERGENCIES

Block Heater......................... 255
Break-In Recommendations................ 68
Compartment......................... 346
Cooling ............................. 365
Exhaust Gas Caution.................. 69,308
Fails to Start.......................... 254
Flooded, Starting...................... 254
Fuel Requirements..................305,388
Jump Starting......................... 338
Oil ..............................352,388
Oil Change Interval.................... 352
Oil Disposal.......................... 355
OilFilter ............................ 355
Oil Filter Disposal...................... 355
Oil Selection.......................... 388
Overheating.......................... 331
Starting............................. 253
Temperature Gauge..................... 182
Engine Oil Viscosity...................... 354Engine Oil Viscosity Chart................. 354
Enhanced Accident Response Feature.......... 55
Entry System, Illuminated.................. 18
Event Data Recorder...................... 56
Exhaust Gas Caution................... 69,308
Exhaust System......................... 364
Extender, Seat Belt........................ 41
ExteriorFinishCare ...................... 377
Filters
Air Cleaner.......................... 358
Engine Oil........................... 355
FinishCare ............................ 377
Flashers.............................. 330
Hazard Warning....................... 330
Turn Signal.......................... 178
Flipper Glass, Liftgate..................... 28
Flooded Engine Starting................... 254
Fluid Capacities......................... 388
424 INDEX

Dimmer Switch, Headlight.............122,126
Electronic Stability Program (ESP)
Indicator........................140,180,183
Electronic Throttle Control Warning......... 184
Fog .............................126,185
Four-Wheel Drive Indicator............... 183
Fuses............................... 381
Hazard Warning Flasher................. 330
Headlight Switch...................... 122
Headlights On With Wipers............... 123
High Beam Indicator.................... 178
Illuminated Entry....................... 18
Instrument Cluster..................122,125
Interior..........................120,125
Lights On Reminder.................... 125
Low Fuel............................ 185
LowTire ............................ 181
Malfunction Indicator (Check Engine)........ 178
Oil Pressure.......................... 180Passing............................. 126
Reading............................. 121
Seat Belt Reminder..................... 183
Security Alarm (Theft Alarm).............. 180
Service Engine Soon (Malfunction Indicator) . . . 178
SmartBeams.......................... 124
Tire Pressure Monitoring (TPMS)........... 181
Tow/Haul Indicator.................... 183
Traction Control....................140,180
Turn Signal........................122,126
VanityMirror .......................... 82
Voltage............................. 185
Load Floor, Cargo....................... 166
Loading Vehicle
Tires ............................... 285
Locks................................. 18
Automatic Door........................ 20
Child Protection........................ 19
Door................................ 18
428 INDEX

Reminder............................ 183
Shoulder Belt Anchorage.................. 37
Seats................................. 105
Adjustment.......................... 105
Cleaning............................ 379
Easy Entry........................... 118
Fold and Tumble Rear................... 109
Head Restraints....................... 107
Heated............................. 108
Lumbar Support....................... 106
Memory............................. 114
Power.............................. 108
Rear Folding.......................109,113
Reclining ............................ 106
Seatback Release....................... 113
Security Against Theft..................... 18
Security Alarm (Theft Alarm)............. 25,180
Selection of Oil......................... 353
Sentry Key (Immobilizer)................... 15Sentry Key Programming................... 17
Sentry Key Replacement................... 16
Service Assistance....................... 412
Service Contract......................... 414
Service Engine Soon Light (Malfunction Indicator) . 178
Service Manuals........................ 416
Setting the Clock..................202,216,223
Shifting
Automatic Transmission................. 256
Shoulder Belts........................... 33
Signals, Turn........................126,178
Skylights, Command View................. 161
SmartBeams........................... 124
Snow Chains (Tire Chains)................. 303
Snow Plow............................ 328
Spare Tire............................. 333
Spark Plugs............................ 356
Specifications
Fuel (Gasoline)........................ 305
INDEX 433
10