JEEP COMPASS 2010 1.G Owners Manual

Cavity CartridgeFuseMini-
Fuse Description
16 15 Amp
Lt BlueIGN Run/Acc Dome
Lamp/Sunroof/Rear
Wiper Motor/ACC
Inverter
17 10 Amp
RedIOD Feed Mod-Wcm
18 40 Amp Green ASD Relay Contact
PWR Feed
19 20 Amp
YellowPWR Amp 1 & Amp
2 Feed
20 15 Amp
Lt BlueIOD Feed Radio
21 10 Amp
RedIOD Feed Intrus
Mod/Siren –
If Equipped
22 10 Amp
RedIGN RUN Heat/AC/
Compass SensorCavity Cartridge
FuseMini-
Fuse Description
23 15 Amp
Lt BlueENG ASD Relay
Feed 3
24 15 Amp
Lt BluePower Sunroof Feed
25 10 Amp
RedHeated Mirror –
If Equipped
26 15 Amp
Lt BlueENG ASD Relay Feed
2
27 10 Amp
RedIGN RUN Only ORC
Feed
28 10 Amp
RedIGN RUN ORC/OCM
Feed
29 Hot Car
(No Fuse Required)
30 20 Amp
YellowHeated Seat –
If Equipped
410 MAINTAINING YOUR VEHICLE

Cavity CartridgeFuseMini-
Fuse Description
31 10 Amp
RedHeadlamp Washer
Relay Control –
If Equipped
32 30 Amp Pink ENG ASD Control
Feed 1
33 10 Amp
RedABS MOD/J1962
Conn/PCM
34 30 Amp Pink ABS Valve Feed
35 40 Amp Green ABS Pump Feed
36 30 Amp Pink Headlamp/Washer
Control/Smart
Glass – If Equipped
37 25 Amp
NaturalDiesel Fuel
Heater – If EquippedCAUTION!
•When installing the IPM cover, it is important to
ensure the cover is properly positioned and fully
latched. Failure to do so may allow water to get
into the IPM, and possibly result in an electrical
system failure.
•When replacing a blown fuse, it is important to
use only a fuse having the correct amperage rating.
The use of a fuse with a rating other than indicated
may result in a dangerous electrical system over-
load. If a properly rated fuse continues to blow, it
indicates a problem in the circuit that must be
corrected.
VEHICLE STORAGE
If you will not be using your vehicle for more than
21 days, you may want to take steps to preserve your
battery.
7
MAINTAINING YOUR VEHICLE 411

•Disengage the mini-fuse in the Power Distribution
Center labeled IOD (Ignition Off-Draw).
•Disconnect the negative cable from the battery.
REPLACEMENT BULBS
All the inside bulbs are brass or glass wedge base.
Aluminum base bulbs are not approved and should not
be used for replacement.
LIGHT BULBS – Interior Bulb Number
Front Header Lamp...................... T578
Center Dome Lamp ...................... T578
Rear Cargo Lamp/Flashlight .............8–A35LFLIGHTS BULBS – Exterior
Bulb No.
Low Beam/High Beam Headlamp ............ H13
Front Park/Turn Signal/Side Marker Lamp . . . 3757KA
Front Fog Lamp ...................... PSX24W
Center High Mounted Stop Lamp
(CHMSL) ...................... LED Assembly
Rear Tail/Stop Lamp ..................... 3157
Rear Turn Lamp ............... 3157AK or 3157A
Backup Lamp ..................... W16W (921)
License Lamp .......................... W5W
Off-Road Lamp .......................... H3
412 MAINTAINING YOUR VEHICLE

BULB REPLACEMENT
Headlamps
1. Raise the hood and locate the connector behind the
headlamp.2. Reach into the engine compartment and pull the red
lock out at the green connector.
7
MAINTAINING YOUR VEHICLE 413

3. Remove green connector from back of bulb by pulling
straight back.4. Twist the bulb to the left.
414 MAINTAINING YOUR VEHICLE

5. Pull bulb outward from assembly.NOTE:These are halogen bulbs. Take care not to touch
the bulb with your fingers. Body oils from your fingers
could cause excessive heat buildup which reduces bulb
life.
Fog Lamps
1. Access lamp through the lower fascia cutout.
2. Remove electrical connector from bulb.
3. Remove bulb from housing.
7
MAINTAINING YOUR VEHICLE 415

Tail Lamp, Rear Turn Signal and Backup Lamp
1. Remove the two push-pins from the taillamp housing.2. Grasp the taillamp and pull firmly to disengage the
lamp from the aperture panel.
3. Twist and remove socket from lamp.
416 MAINTAINING YOUR VEHICLE

4. Remove bulb from socket and replace.License Lamps
1. Use a screw driver to gently pry against the side of the
snap tab to remove the lamp from the liftgate.
7
MAINTAINING YOUR VEHICLE 417

2. Rotate the socket 1/4 turn counterclockwise. 3. Pull bulb from socket.
418 MAINTAINING YOUR VEHICLE

Center High-Mounted Stoplamp
Light is an LED assembly. See your authorized dealer for
replacement.
Off-Road Lamp
1. Remove the three screws attaching the lens to the
housing.
7
MAINTAINING YOUR VEHICLE 419