JEEP GRAND CHEROKEE LIMITED 2021 Owners Manual

W$5N,N*
5LGLQg tKe bUakeV FaQ OeaG to bUake IaLOXUe
aQG SoVVLbO\ a FoOOLVLoQ. 'ULYLQg ZLtK \oXU Ioot
UeVtLQg oU ULGLQg oQ tKe bUake SeGaO FaQ UeVXOt
LQ abQoUPaOO\ KLgK bUake tePSeUatXUeV
e[FeVVLYe OLQLQg ZeaU aQG SoVVLbOe bUake
GaPage. <oX ZoXOG Qot KaYe \oXU IXOO bUakLQg
FaSaFLt\ LQ aQ ePeUgeQF\.8

21_WK_OM_EN_USC_t.book Page 349

W$5N,N*
Use only FCA recommended brake fluid
Úpage 391. Using the wrong type of brake
fluid can severely damage your brake
system and/or impair its performance. The
proper type of brake fluid for your vehicle is
also identified on the original factory
installed hydraulic master cylinder reser -
voir.
WARNING! (Continuedyf

C$U7,ON
UVLQg a tUaQVPLVVLoQ IOXLG otKeU tKaQ )C$
UeFoPPeQGeG IOXLG Pa\ FaXVe GeteULoUatLoQ
LQ tUaQVPLVVLoQ VKLIt TXaOLt\ aQGoU toUTXe
FoQYeUteU VKXGGeU Úpage 391.
CAUTION!
Do not overtighten the plugs as it could
damage them and cause them to leak.
CAUTION!
Do not overtighten the plugs as it could
damage them and cause them to leak.
8

21_WK_OM_EN_USC_t.book Page 351

W$5N,N*
When replacing a blown fuse, always use
an appropriate replacement fuse with the
same amp rating as the original fuse. Never
replace a fuse with another fuse of higher
amp rating. Never replace a blown fuse with
metal wires or any other material. Do not
place a fuse inside a circuit breaker cavity
or vice versa. Failure to use proper fuses
may result in serious personal injury, fire
and/or property damage.
Before replacing a fuse, make sure that the
ignition is off and that all the other services
are switched off and/or disengaged.
If the replaced fuse blows again, contact an
authorized dealer.
WARNING! (Continuedyf

CaYLt\CaUtULGge )XVe MLFUo )XVe 'eVFULStLoQ
)0360 $PS <eOOoZ

8

21_WK_OM_EN_USC_t.book Page 355

C$U7,ON
When installing the power distribution center cover, it is important to ensure the cover is properly positioned and fully latched. Failure to do so may
allow water to get into the power distribution center and possibly result in an electrical system failure.
When replacing a blown fuse, it is important to use only a fuse having the correct amperage rating. The use of a fuse with a rating other than indi-
cated may result in a dangerous electrical system overload. If a properly rated fuse continues to blow, it indicates a problem in the circuit that must
be corrected.
8

21_WK_OM_EN_USC_t.book Page 357