JEEP LIBERTY 2006 Workshop Manual
Page 51 of 1696
Page 52 of 1696
3
Page 53 of 1696
Page 54 of 1696
The auxiliary lights mounted on the off road light
bar should be illuminated during OFF-ROAD USE
ONLY. Having them illuminated on public streets,
highways, roads, etc. may be illegal in your state/
province. Your state/province may also require aux-
iliary lights be covered when operating your vehicle
on the public streets, highways, roads, etc. Further,
illuminating these lights with the supplied covers
installed could cause permanent damage to the light
bar. Before using these auxiliary lights, contact your
State or Provincial Authorities for proper operation
and use of these lights.
Light Bar
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 119
3
Page 55 of 1696
Page 56 of 1696
Avoid trapping anyone in the vehicle in a collision.
Remember that the rear doors can only be opened
from the outside when the child protection locks are
engaged.
2
Page 57 of 1696
Four Button Transmitter
22 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Page 58 of 1696
2
Page 59 of 1696
NOTE:The horn chirp can be enabled or disabled
(within 23–50 feet (7–15 meters) of the vehicle) by the
following procedure:
1. Press and hold the Lockbutton on the transmitter.
2. Continue to hold the Lockbutton, wait at least 4 but
no longer than 10 seconds, then press the Panicbutton.
3. Release both buttons.
4. Repeating steps 1–3 will restore original transmitter
operation.
To Unlatch the Swing Gate Flip-Up Window
Press the “Rear Release” button twice to unlatch the
swing gate flip-up window.
WARNING!
To avoid injury stand back when opening. Glass will
automatically rise.
NOTE: The transmitter can be programmed to unlatch
the flip-up window immediately upon activation of the
“Rear Release” button (without pressing and holding)
(within 23–50 feet (7–15 meters) of the vehicle) by per-
forming the following procedure:
1. Press and hold the “Unlock” button on the transmitter.
2. Continue to hold the “Unlock” button, wait at least 4
but no longer than 10 seconds, then press the “Rear
Release” button.
3. Release both buttons.
4. Repeating steps 1–3 will restore original transmitter
operation.
NOTE: Unlatching the flip-up window will unlock the
swing gate. After closing the flip-up window, press the
“Lock” button on the transmitter to lock the swing gate.
24 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Page 60 of 1696
2