brake light JEEP WAGONEER 2021 Owners Manual

Page 15 of 428

W$5N,N*
$Q\ PoGLILFatLoQV oU aOteUatLoQV to tKLV YeKLFOe FoXOG VeULoXVO\ aIIeFt LtV
UoaGZoUtKLQeVV aQG VaIet\ aQG Pa\ OeaG to a FoOOLVLoQ UeVXOtLQg LQ VeULoXV
LQMXU\ oU GeatK.
5eG WaUQLQg /LgKtV
$LU %ag WaUQLQg /LgKt Úpage 117
Brake Warning Light Úpage 117
Battery Charge Warning Light Úpage 118
Door Open Warning Light
Úpage 118
Drowsiness Detected Warning Light Úpage 118
Electric Power Steering (EPSyf)DXOW:DUQLQJ/LJKt Úpage 118
Electronic Throttle Control (ETCyf:DUQLQJ/LJKt Úpage 118
Engine Coolant Temperature Warning Light Úpage 119
Hood Open Warning Light Úpage 119
Liftgate Open Warning Light Úpage 119
Night Vision Animal Detected Warning Light Úpage 119
Red Warning Lights
1

22_WS_OM_EN_USC_t.book Page 13

Page 16 of 428

<eOOoZ WaUQLQg /LgKtV
$QtL/oFk %Uake S\VteP $%S\f:DUQLQJ/LJKt Úpage 120
Electronic Park Brake Warning Light Úpage 120
Electronic Stability Control (ESCyf$FWLYH:DUQLQJ/LJKt Úpage 120
Electronic Stability Control (ESCyf2)):DUQLQJ/LJKt Úpage 121
Service Active Lane Management Warning Light Úpage 121
Active Lane Management Warning Light Úpage 121
Low Fuel Warning Light Úpage 121
Low Washer Fluid Warning Light Úpage 121

Page 135 of 428

W$5N,N*
Never use the PARK position as a substitute
for the parking brake. Always apply the
parking brake fully when parked to guard
against vehicle movement and possible injury
or damage.
When exiting the vehicle, always turn the igni-
tion off, secure the key fob, and lock your
vehicle.
WARNING!CAUTION!
If the Brake System Warning Light remains on
with the parking brake released, a brake system
malfunction is indicated. Have the brake system
serviced by an authorized dealer immediately.
WARNING!
Driving the vehicle with the parking brake
engaged, or repeated use of the parking brake
to slow the vehicle, may cause serious damage
to the brake system. Be sure the parking brake
is fully disengaged before driving; failure to do
so can lead to brake failure and a collision.
4

22_WS_OM_EN_USC_t.book Page 133

Page 343 of 428

SERVICING AND MAINTENANCE
SC\b\fED SERVICING
Your vehicle is equipped with an automatic oil
change indicator system. The oil change indicator
system will remind you that it is time to take your
vehicle in for scheduled maintenance.
Based on engine operation conditions, the oil
change indicator message will illuminate. This
means that service is required for your vehicle.
Operating conditions such as frequent short-trips,
trailer tow, extremely hot or cold ambient
temperatures, and extended idling will influence
when the “Oil Change Required” message is
displayed. Have your vehicle serviced as soon as
possible, within the next 500 miles (805 kmyf.An authorized dealer will reset the oil change
indicator message after completing the scheduled
oil change or for engine oil life reset procedure
Ú
page 110.
NOTE:Under no circumstances should oil change
intervals exceed 10,000 miles (16,000 kmyfRU
12 months, whichever comes first. The engine
controller also monitors the number of hours of
engine run time, and will illuminate the oil change
indicator after 350 hours (which is not likely to be
exceeded except for certain fleet customers with
extended engine idling periodsyf. Once A Month Or Before A Long Trip:
Check engine oil level
Check windshield washer fluid level
Check the tire inflation pressures and look for
unusual wear or damage
Check the fluid levels of the coolant reservoir,
brake master cylinder and fill as needed.
Check function of all interior and exterior lights
8

22_WS_OM_EN_USC_t.book Page 341

Page 405 of 428

TEC\b \f SPECIFICATIONS
VE\b \fE IDENTIFICATION NUMBER (VIN)
The VIN is found on a label located on the left front
corner of the instrument panel pad, visible from
outside of the vehicle through the windshield.
Windshield VIN Label Location

NOTE:It is illegal to remove or alter the VIN.
BRAKE SYSTEM
Your vehicle is equipped with dual hydraulic brake
systems. If either of the two hydraulic systems lose
normal capability, the remaining system will still
function. However, there will be some loss of
overall braking effectiveness. You may notice
increased pedal travel during application, greater
pedal force required to slow or stop, and potential
activation of the Brake Warning Light.
In the event power assist is lost for any reason the
brakes will still function. However, the effort
required to brake the vehicle will be much greater
than that required with the power system
operating.
W\b\f AND TIRE TORQUE SPECIFICATIONS
Proper lug nut/bolt torque is very important to
ensure that the wheel is properly mounted to the
vehicle. Any time a wheel has been removed and
reinstalled on the vehicle, the lug nuts/bolts
should be torqued using a properly calibrated
torque wrench using a six sided (hexyfGHHSZDOO
socket.
TORQUE SPECIFICATIONS
**Use only authorized dealer recommended lug
nuts/bolts and clean or remove any dirt or oil
before tightening.
Inspect the wheel mounting surface prior to
mounting the tire and remove any corrosion or
loose particles.
Wheel Mounting Surface

Lug Nut/Bolt
Torque **Lug Nut/
Bolt SizeLug Nut/Bolt
Socket Size
130 ft-lb
(176 N·myf M14 x 1.50 22 mm
9

22_WS_OM_EN_USC_t.book Page 403