wiring JEEP WRANGLER 2008 Owners Manual
Page 29 of 466
2. Push down to ensure the half door window is fully
seated.
Front Door Removal
1. Remove the hinge pin screws from the upper and
lower outside hinges (using a #T50 Torxhead driver).2. Unplug the wiring harness connector under instru-
ment panel.
Page 31 of 466
3. Remove the trim access door from the bottom of
B-pillar.
4. Unplug the wiring harness connector.5. Unhook the door strap from the body hook.
6. With the door open, lift the door to clear hinge pins
from their hinges, and remove door.
To reinstall the door(s), perform the previous steps in the
opposite order.
Page 131 of 466
6. Locate the wiring harness on the left rear inside corner
of the vehicle.
7. Disconnect the rear window washer hose and install
the tethered cap.