light JEEP WRANGLER 2022 User Guide

Page 189 of 464

:$51,1*
Never have any smoking materials lit in or
near the vehicle when the fuel door is open
or the tank is being filled.
Never add fuel when the engine is running.
This is in violation of most state and federal
fire regulations and may cause the
“Malfunction Indicator Light” to turn on.
A fire may result if fuel is pumped into a
portable container that is inside of a
vehicle. You could be burned. Always place
fuel containers on the ground while filling.
CAUTION!
Damage to the fuel system or emission
control system could result from using an
improper fuel filler cap. A poorly fitting cap
could let impurities into the fuel system.
Also, a poorly fitting aftermarket cap can
cause the “Malfunction Indicator Light
(MILyf

Page 214 of 464

6HWWLQJ1DPH'HVFULSWLRQ
'LVSOD\0RGH7KLVVHWWLQJZLOODOORZ\RXWRVHWWKHEULJKWQHVVPDQXDOO\RUKDYHWKHV\V
-
tem set it automatically. The “Auto” setting has the system automatically
adjust the display brightness. The “Manual” setting will allow the user to
adjust the brightness of the display.
Display Brightness With Headlights ON/Brightness This setting will allow you to set the brightness when the headlights are
on. To access this setting, Display Mode must be set to Manual. The “+”
setting will increase the brightness; the “-” will decrease the brightness.

Page 320 of 464

:$51,1*
If the PAD Indicator Light remains illumi-
nated for an adult passenger, have an
authorized dealer service the air bag
system immediately. Failure to do so may
cause serious injury or death. If the PAD
Indicator Light is illuminated with the words
"PASSENGER AIR BAG OFF," the Passenger
Advanced Front Air Bag will not deploy in
the event of a collision.
Never place a rear-facing child restraint in
front of an air bag. A deploying passenger
front air bag can cause death or serious
injury to a child 12 years or younger,
including a child in a rear-facing child
restraint.

Page 323 of 464

:$51,1*
Ignoring the Air Bag Warning Light in your
instrument panel could mean you won’t
have the air bags to protect you in a colli-
sion. If the light does not come on as a bulb
check when the ignition is first turned on,
stays on after you start the vehicle, or if it
comes on as you drive, have an authorized
dealer service the air bag system immedi -
ately.
Placing an object on the floor under the
front passenger seat may prevent the OCS
from working properly, which may result in
serious injury or death in a collision. Do not
place any objects on the floor under the
front passenger seat.
WARNING! (Continuedyf
6

21_JL_OM_EN_USC_t.book Page 321

Page 324 of 464

:$51,1*
Unapproved modifications or service proce-
dures to the passenger seat assembly, its
related components, seat cover, or cushion
may inadvertently change the air bag
deployment in case of a frontal collision.
This could result in death or serious injury
to the front passenger if the vehicle is
involved in a collision. A modified vehicle
may not comply with required Federal
Motor Vehicle Safety Standards (FMVSSyf
and/or Canadian Motor Vehicle Safety
Standards (CMVSSyf.
If it is necessary to modify the air bag
system for persons with disabilities,
contact an authorized dealer.
WARNING!
Do not drill, cut, or tamper with the knee
impact bolsters in any way.
Do not mount any accessories to the knee
impact bolsters such as alarm lights,
stereos, citizen band radios, etc.
WARNING!
Do not use accessory seat covers or place
objects between you and the Side Air Bags;
the performance could be adversely affected
and/or objects could be pushed into you,
causing serious injury.

Page 344 of 464

:$51,1*
$QLPSURSHUO\DWWDFKHGGDPDJHGIROGHGRU
VWDFNHGIORRUPDWRUGDPDJHGIORRUPDWIDV-
teners may cause your floor mat to interfere
with the accelerator, brake, or clutch pedals
and cause a loss of vehicle control. To pre -
vent SERIOUS INJURY or DEATH:
ALWAYS securely attach your floor mat
using the floor mat fasteners. DO NOT
install your floor mat upside down or turn
your floor mat over. Lightly pull to confirm
mat is secured using the floor mat
fasteners on a regular basis.
ALWAYS REMOVE THE EXISTING FLOOR
MAT FROM THE VEHICLE before
installing any other floor mat. NEVER install
or stack an additional floor mat on top of an
existing floor mat.
ONLY install floor mats designed to fit your
vehicle. NEVER install a floor mat that
cannot be properly attached and secured to
your vehicle. If a floor mat needs to be
replaced, only use a FCA approved floor
mat for the specific make, model, and year
of your vehicle.
WARNING! (ContinuedyfWARN,N* (Continuedyf

Page 433 of 464

TEC\b \f SPECIFICATIONS
VE\b \fE IDENTIFICATION NUMBER
The Vehicle Identification Number (VINyfLVIRXQG
on the left front corner of the A-pillar, visible
from outside of the vehicle through the
windshield.
Vehicle Identification Number

NOTE:
It is illegal to remove or alter the VIN plate.
BRAKE SYSTEM
Your vehicle is equipped with dual hydraulic
brake systems. If either of the two hydraulic
systems loses normal capability, the remaining
system will still function. However, there will be some loss of overall braking effectiveness. You
may notice increased pedal travel during
application, greater pedal force required to slow
or stop, and potential activation of the Brake
Warning Light.
In the event power assist is lost for any reason
(i.e., repeated brake applications with the
engine offyfWKHEUDNHVZLOOVWLOOIXQFWLRQ
However, the effort required to brake the
vehicle will be much greater than that required
with the power system operating.
W\b\f AND TIRE TORQUE SPECIFICATIONS
Proper lug nut/bolt torque is very important to
ensure that the wheel is properly mounted to
the vehicle. Any time a wheel has been removed
and reinstalled on the vehicle, the lug nuts/
bolts should be torqued using a properly
calibrated torque wrench using a six sided (hexyf
deep wall socket.
TORQUE SPECIFICATIONS
**Use only authorized dealer recommended lug nuts/
bolts and clean or remove any dirt or oil before tightening.
Inspect the wheel mounting surface prior to
mounting the tire and remove any corrosion or
loose particles.
Spare Tire Torque Specifications
**Use only authorized dealer recommended lug nuts/
bolts and clean or remove any dirt or oil before tightening.
Lug Nut/Bolt
Torque **Lug Nut/
Bolt Size Lug Nut/Bolt
Socket Size
130 Ft-Lbs (176 N·myf M14 x 1.50 22 mm
Lug Nut/Bolt Torque **Lug Nut/
Bolt Size Lug Nut/Bolt
Socket Size
59 Ft-Lbs (80 N·myf M14 x 1.50 22 mm
9

21_JL_OM_EN_USC_t.book Page 431

Page 435 of 464

&$87,21
'2127XVH(JDVROLQHFRQWDLQLQJPHWKD-
nol, or gasoline containing more than 15yb
ethanol (E-15yf8VHRIWKHVHEOHQGVPD\
result in starting and drivability problems,
damage critical fuel system components,
cause emissions to exceed the applicable
standard, and/or cause the Malfunction Indi-
cator Light to illuminate. Please observe
pump labels as they should clearly communi -
cate if a fuel contains greater than 15ybHWKa -
nol (E-15yf.
9

21_JL_OM_EN_USC_t.book Page 433

Page 437 of 464

:$51,1*
'RQRWXVHDOFRKRORUJDVROLQHDVDIXHO
EOHQGLQJDJHQW7KH\FDQEHXQVWDEOHXQGHU
FHUWDLQFRQGLWLRQVDQGKD]DUGRXVRUH[SOR-
sive when mixed with diesel fuel.
CAUTION!
If the “Water in Fuel Indicator Light” remains
on, DO NOT START engine before you drain
the water from the fuel filter(syfWRDYRLG
engine damage Ú page 375.
9

21_JL_OM_EN_USC_t.book Page 435

Page:   < prev 1-10 11-20