JEEP WRANGLER 4XE 2022 Owners Manual





:$51,1*

Exhaust gases can injure or kill. They contain
Carbon Monoxide (COyfZKLFKLVFRORUOHVVDQG
odorless. Breathing it can make you unconscious
and can eventually poison you
Ú
page 346.

A hot exhaust system can start a fire if you park
over materials that can burn. Such materials
might be grass or leaves coming into contact
with your exhaust system. Do not park or operate
your vehicle in areas where your exhaust system
can contact anything that can burn.

CAUTION!
The catalytic converter requires the use of
unleaded fuel only. Leaded gasoline will
destroy the effectiveness of the catalyst as an
emissions control device and may seriously
reduce engine performance and cause
serious damage to the engine.
Damage to the catalytic converter can result if
your vehicle is not kept in proper operating
condition. In the event of engine malfunction,
particularly involving engine misfire or other
apparent loss of performance, have your
vehicle serviced promptly. Continued opera -
tion of your vehicle with a severe malfunction
could cause the converter to overheat,
resulting in possible damage to the converter
and vehicle.

:$51,1*
You or others can be badly burned by hot
engine coolant (antifreezeyfRUVWHDPIURP\RXU
radiator. If you see or hear steam coming from
under the hood, do not open the hood until the
radiator has had time to cool. Never open a
cooling system pressure cap when the radi-
ator or coolant bottle is hot.
Keep hands, tools, clothing, and jewelry away
from the radiator cooling fan when the hood is
raised. The fan starts automatically and may
start at any time, whether the engine is
running or not.
When working near the radiator cooling fan,
disconnect the fan motor lead or turn the igni -
tion to the OFF mode. The fan is temperature
controlled and can start at any time the igni -
tion is in the ON mode.
8

22_JL_OM_EN_USC_t.book Page 393

:$51,1*
Do not open hot engine cooling system. Never
add engine coolant (antifreezeyfZKHQWKH
engine is overheated. Do not loosen or
remove the cap to cool an overheated engine.
Heat causes pressure to build up in the
cooling system. To prevent scalding or injury,
do not remove the pressure cap while the
system is hot or under pressure.
Do not use a pressure cap other than the one
specified for your vehicle. Personal injury or
engine damage may result.

:$51,1*
Do not open hot engine cooling system. Never
add engine coolant (antifreezeyfZKHQWKH
engine is overheated. Do not loosen or
remove the cap to cool an overheated engine.
Heat causes pressure to build up in the
cooling system. To prevent scalding or injury,
do not remove the pressure cap while the
system is hot or under pressure.
Do not use a pressure cap other than the one
specified for your vehicle. Personal injury or
engine damage may result.
8

22_JL_OM_EN_USC_t.book Page 395

:$51,1*
5LGLQJWKHEUDNHVFDQOHDGWREUDNHIDLOXUHDQG
SRVVLEO\DFROOLVLRQ'ULYLQJZLWK\RXUIRRWUHVWLQJ
RUULGLQJRQWKHEUDNHSHGDOFDQUHVXOWLQ
DEQRUPDOO\KLJKEUDNHWHPSHUDWXUHVH[FHVVLYH
OLQLQJZHDUDQGSRVVLEOHEUDNHGDPDJH<RX
ZRXOGQRWKDYH\RXUIXOOEUDNLQJFDSDFLW\LQDQ
HPHUJHQF\
:$51,1*
Use only the manufacturer recommended
brake fluid Úpage 452. Using the wrong type
of brake fluid can severely damage your brake
system and/or impair its performance. The
proper type of brake fluid for your vehicle is
also identified on the original factory installed
hydraulic master cylinder reservoir.
To avoid contamination from foreign matter or
moisture, use only new brake fluid or fluid that
has been in a tightly closed container. Keep
the master cylinder reservoir cap secured at
all times. Brake fluid in an open container
absorbs moisture from the air resulting in a
lower boiling point. This may cause it to boil
unexpectedly during hard or prolonged
braking, resulting in sudden brake failure. This
could result in a collision.
Overfilling the brake fluid reservoir can result
in spilling brake fluid on hot engine parts,
causing the brake fluid to catch fire. Brake
fluid can also damage painted and vinyl
surfaces, care should be taken to avoid its
contact with these surfaces.

:$51,1*


&$87,21
,IDWUDQVPLVVLRQIOXLGOHDNRFFXUVYLVLWDQ
DXWKRUL]HGGHDOHULPPHGLDWHO\6HYHUH
WUDQVPLVVLRQGDPDJHPD\RFFXU$QDXWKRUL]HG
GHDOHUKDVWKHSURSHUWRROVWRDGMXVWWKHIOXLG
OHYHODFFXUDWHO\
&$87,21
8VLQJDWUDQVPLVVLRQIOXLGRWKHUWKDQWKH
PDQXIDFWXUHUUHFRPPHQGHGIOXLGPD\FDXVH
GHWHULRUDWLRQLQWUDQVPLVVLRQVKLIWTXDOLW\DQGRU
WRUTXHFRQYHUWHUVKXGGHUÚpage 452.

:$51,1*
When replacing a blown fuse, always use an
appropriate replacement fuse with the same
amp rating as the original fuse. Never replace
a fuse with another fuse of higher amp rating.
The use of a fuse with a rating other than indi-
cated may result in a dangerous electrical
system overload. If a properly rated fuse
continues to blow, it indicates a problem in the
circuit that must be corrected. Never replace a
blown fuse with metal wires or any other mate -
rial. Failure to use proper fuses may result in
serious personal injury, fire and/or property
damage.
Before replacing a fuse, make sure that the
ignition is off and that all the other services
are switched off and/or disengaged.
If the replaced fuse blows again, contact an
authorized dealer.
If a general protection fuse for safety systems
(air bag system, braking systemyfSRZHUXQLW
systems (engine system, gearbox systemyfRU
steering system blows, contact an authorized
dealer.
1 — Fuse Element
2 — Blade Fuse with a good/functional
fuse element
3 — Blade fuse with a bad/not functional
fuse element (blown fuseyf
CAUTION!
When installing the power distribution center
cover, it is important to ensure the cover is
properly positioned and fully latched. Failure to
do so may allow water to get into the power
distribution center and possibly result in an
electrical system failure.
8

22_JL_OM_EN_USC_t.book Page 399