wheel size JEEP WRANGLER RUBICON 2020 Owners Manual

Page 352 of 488

:$51,1*

Do not use a tire, wheel size, load rating, or
speed rating other than that specified for
your vehicle. Some combinations of unap-
proved tires and wheels may change suspen -
sion dimensions and performance
characteristics, resulting in changes to
steering, handling, and braking of your
vehicle. This can cause unpredictable
handling and stress to steering and suspen -
sion components. You could lose control and
have a collision resulting in serious injury or
death. Use only the tire and wheel sizes with
load ratings approved for your vehicle.
WARNING! (Continued\f

Page 355 of 488

Dark Vapor Chrome, Black Satin Chrome, or
Low Gloss Clear Coat WheelsTire Chains and Traction Devices
Use of traction devices require sufficient
tire-to-body clearance. Follow these
recommendations to guard against damage.
Traction device must be of proper size for the
tire, as recommended by the traction device
manufacturer.
Install on rear tires only.
All OE equipped tire and wheel sizes are
chainable with an Autosock traction device.
See
Autosock.com for the recommended
part or model number for your OE equipped
tire size.
The use of S-class snow chains is permitted
with the use of 245/75R17 tires on size
17 x 7.5 ET44.45 wheels.
CAUTION!
If your vehicle is equipped with these
specialty wheels, DO NOT USE wheel
cleaners, abrasives, or polishing compounds.
They will permanently damage this finish and
such damage is not covered by the New
Vehicle Limited Warranty. HAND WASH ONLY
USING MILD SOAP AND WATER WITH A SOFT
CLOTH. Used on a regular basis; this is all that
is required to maintain this finish.
WARNING!

Using tires of different size and type (M+S,
SnowyfEHWZHHQIURQWDQGUHDUD[OHVFDQFDXVH
unpredictable handling. You could lose control
and have a collision.

7

20_JL_OM_EN_USC_t.book Page 353

Page 369 of 488

TEC\b \f SPECIFICATIONS
VE\b \fE IDENTIFICATION NUMBER
The Vehicle Identification Number (VINyfLVIRXQG
on the left front corner of the A pillar, visible
from outside of the vehicle through the
windshield.
Vehicle Identification Number

NOTE:
It is illegal to remove or alter the VIN plate.
BRAKE SYSTEM
Your vehicle is equipped with dual hydraulic
brake systems. If either of the two hydraulic
systems loses normal capability, the remaining
system will still function. However, there will
be some loss of overall braking effectiveness.
You may notice increased pedal travel during
application, greater pedal force required to slow
or stop, and potential activation of the Brake
Warning Light.

In the event power assist is lost for any reason
(i.e., repeated brake applications with the engine
offyfWKHEUDNHVZLOOVWLOOIXQFWLRQ+RZHYHUWKH
effort required to brake the vehicle will be much
greater than that required with the power system
operating.

W\b\f AND TIRE TORQUE SPECIFICATIONS
Proper lug nut/bolt torque is very important to
ensure that the wheel is properly mounted to
the vehicle. Any time a wheel has been removed
and reinstalled on the vehicle, the lug nuts/
bolts should be torqued using a properly
calibrated torque wrench using a high quality
six sided (hexyfGHHSZDOOVRFNHW.
Torque Specifications
**Use only authorized dealer recommended
lug nuts/bolts and clean or remove any dirt or
oil before tightening.
Inspect the wheel mounting surface prior to
mounting the tire and remove any corrosion or
loose particles.
Lug Nut/Bolt
Torque **Lug Nut/
Bolt SizeLug Nut/Bolt
Socket Size
130 Ft-Lbs
(176 N·myf M14 x 1.50 22 mm
8

20_JL_OM_EN_USC_t.book Page 367