JEEP WRANGLER UNLIMITED SPORT 2016 Owners Manual

Rear Hard Top Installation
NOTE:If the door frames are installed from soft top usage,
they must be removed prior to installation of the hard top.
1. Inspect the hard top seals for damage and replace if necessary.
2. Install the hard top using the same steps for removal in reverse order.
Make sure that the hard top is sitting flush with the body
at the sides and check to ensure that there is a uniform gap
between the lift glass and hard top.
NOTE: •The Torx fasteners that attach the hard top to the body
should be torqued to 88 in lb +/- 22 in lb (10 N·m +/-
2.5 N·m).
• It is not necessary to pinch connection when reinstall-
ing washer hose. Push on until click is heard.
DOOR FRAME

Door Frame Removal
1. Unscrew and remove the door frame attachment knobs(two per door).

WARNING!
•Do not drive your vehicle on public roads with the
door frame(s) removed as you will lose the protection
that they can provide. This procedure is furnished
for use during off-road operation only.
• Do not drive your vehicle on public roads with the
doors removed as you will lose the protection that
they can provide. This procedure is furnished for use
during off-road operation only.
Door Frame Installation — Two-Door Models — If
Equipped
1. Unfold door frame and unscrew thumbscrews.
2. Set the door frame pin into the hole on top of the body side, behind the door opening.
3. After the door frame pin has been set into the body side hole, carefully set the front of the door frame into the
rubber seal at the top of the windshield.

9. Tighten the front knob, then the rear most knob, andthen the middle knob. Repeat this procedure for the
other side.
SOFT TOP — TWO-DOOR MODELS
Please visit http://www.jeep.com/en/wrangler-rooftop-
instructions/ for instructional videos.