stop start KIA SELTOS 2021 Navigation System Quick Reference Guide

3
ÜSystem handling
Do NOT apply excessive force to the system.
•When you apply excessive pressure to the screen, the LCD panel or touch
panel may get damaged.
To clean the screen or button panel, first turn off the vehicle
and then use a dry, soft cloth to wipe it.
•Do not wipe using a rough or hard cloth, chemical fiber, organic solvent (e.g.
alcohol, benzene, thinner), or air freshener. The panel surface may become
scratched or damaged due to a chemical reaction.
When you install an air freshener on the air conditioner vent,
the surface may be deformed due to leakage.
A
A
If you experience any problems with the system, contact your
place of purchase or dealer.
Safety Precautions
Be sure to keep the following instructions. Otherwise, it may
cause minor injury or system damage.
ÜOperation
Use the system with the vehicle started.
•When you use the system for a long time with the vehicle stopped, it may\

cause battery discharge.
Do NOT arbitrarily install an unauthorized aftermarket
product in your vehicle.
•Using unapproved products may cause an error while using the system.
•System errors caused by installing unapproved products are not covered
under the warranty.

5
ÜSystem handling
Do NOT apply excessive force to the system.
 When you apply excessive pressure to the screen, the LCD panel or touch
panel may get damaged.
To clean the screen or button panel, first turn off the vehicle
and then use a dry, soft cloth to wipe it.
Do not wipe using a rough or hard cloth, chemical fiber, organic solvent (e.g.
alcohol, benzene, thinner), or air freshener. The panel surface may become
scratched or damaged due to a chemical reaction.
When you install an air freshener on the air conditioner vent,
the surface may be deformed due to leakage.
A
A
If you experience any problems with the system, contact your
place of purchase or dealer.
Be sure to keep the following instructions. Otherwise, it may
cause minor injury or system damage.
ÜOperation
Use the system with the vehicle started.
 When you use the system for a long time with the vehicle stopped, it may
cause battery discharge.
Do NOT arbitrarily install an unauthorized aftermarket
product in your vehicle.
Using unapproved products may cause an error while using the system.
System errors caused by installing unapproved products are not covered
under the warranty.
Safety Precautions

2-21
Seeing notifications (if equipped)
You can view UVO notifications including the navigation and map
update information.A
A
Subscribe to UVO to check the function.
> See “Subscribing to
the service.”
1 On the All Menus screen, press Notifications.
2 Select to view the item.
ca
b
a Returns to the previous step.
b View the list of received notifications. Select from the list
to view details.
A
A
Important notifications are marked with
next to
the title.
A
A
You cannot display notification details while driving.
Stop the vehicle first to view notifications.
Seeing the driving information
(if equipped)
You can analyze the driving patterns by checking the driving
information such as driving time, distance, idle time, and vehicle
speed distribution. Use this information to ensure safe and
economical driving.
A
A
This function is available only when your vehicle is stationary
with the vehicle started.
1 On the All Menus screen, press Driving Info.
2 Check the driving information of your vehicle.
A
A
To see the latest information, press .
AATo access the online user’s manual on the driving information
screen, press Menu >
User's Manual on Web (QR Code) and
then scan the displayed QR code.

4-4
Playing the previous file
You can play the previous file during playback in the USB device.
Perform any of the following methods:
On the USB music playback screen, press within 3
seconds during playback.
 On the control panel, press the [
SEEK] button within 3
seconds during playback.
A
A
To play the previous music during playback, press
twice
or pressing the [
SEEK] button on the control panel twice
after 3 seconds from the start of the playback.
A
A
You can also run the function by using the Move lever/button
on the steering wheel.
A
A
On the control panel, turn the [TUNE/FILE] knob to search for
a music file and press the knob within 5 seconds to play it.
A
A
When there is no input for 5 seconds, the search stops and
the system displays the information of the current file.
Fast forward
By using the fast forward function, you can listen to music in the
USB device from the desired point during playback.
Perform any of the following methods:
On the USB music playback screen, press and hold .
On the control panel, press and hold the [
TRACK ] button.
A
A
You can also run the function by using the Move lever/button
on the steering wheel.
Resuming playback of the current music
You can play the current music in the USB device from the
beginning.
Perform any of the following methods:
On the USB music playback screen, press after 3 seconds
during playback.
 On the control panel, press the [
SEEK] button after 3
seconds during playback.
A
A
You can also run the function by using the Move lever/button
on the steering wheel.

5-5
A
A
Navigation service may not be provided correctly under the
following conditions:

When the vehicle drives on a straight road continuously,
the system may guide you to drive straight. It is not a
malfunction.

Guidance may not be followed immediately after the
vehicle makes a turn at an intersection or drives through an
intersection.

The system may guide you to make a U-turn in a prohibited
area.

The system may guide you to a traffic-blocked road (e.g. no-
entry road or road under construction).

The system may guide you to a road away from the
destination when there is no road to the destination or
there are only narrow roads on the way.

Guidance may not be proper when the vehicle is off the
route.

Guidance may not match the actual distance on an
overpass or underpass due to the difference of the start
point.

When you are driving at high speeds, route recalculations
may take longer.
A
A
Because the navigation system is used for information
purposes only, Kia does not assume responsibility of the
accuracy of the information.
A
A
When the traffic information is not received, the status icon
appears at the top of the map screen.

HD Radio: The system is using the HD radio data. If no
traffic information is available, the status icon (
)
will be
displayed instead.

The vehicle is driving in a rugged mountain area or on a
steep curve road.

The vehicle is entering a public road after making a turn
through the turntable in an underground parking lot or
multi-story parking lot.

The vehicle stops and starts repeatedly or moves slowly in
front of an intersection.

The system reboots after the vehicle battery has been
recharged or replaced.

The vehicle is driving on a slippery road due to heavy snow,
etc.

The tires have been replaced recently or spare tires (or
studless tires) are used.

Improper-sized tires are used or the pressure of each tire is
different.

The replaced tire is worn out or the studless tires have been
used for over two seasons.

A roof carrier is installed on the vehicle.

On a highway. continued driving causes the system to
perform map matching or apply the updated GPS data.

7-8
CommandFunction
Cancel Route Stop the navigation guidance and
cancel your current destination.
Destination
Information View information on the distance and
time to your current destination.
Route Options Find another route.
Show Route View the entire route on the map.
A
A
When you use a command starting with "Find," the system
searches for locations within the state or province where your
vehicle is currently located. To search for locations in another
state or province, say the state or province name first and
then say the location you want.
A
A
Some commands, such as "Cancel Route " or "Show Route,"
are available only when a destination is set.Command Function
Previous Searches You can select a destination from the
list of destinations that have recently
been searched for. Say the number of
the location you want.
Traffic Information Access the traffic information screen.
Go Home Set the location saved to the Home
shortcut button in your address book
as your destination.
Go to Work Set the location saved to the Work
shortcut button in your address book
as your destination.
Change Home You can change the location saved as
your home.
Change Work You can change the location saved as
your work.
Pause Route Pause the navigation guidance.
Resume Route Resume the navigation guidance.
Turn Guidance On Unmute the navigation guidance.
Turn Guidance Off Mute the navigation guidance.

7-19
a Returns to the previous step.
b Displays the list of recorded voice memos.
c Starts or pauses the recording.
d Stops recording.
e The list of menu items appears.
Delete: Can delete a voice memo.
Save to USB Device: Can record a voice memo to a USB
storage device. Check that the USB device is compatible.
>
See “USB storage devices.”
Storage Information: Can see the file size of recorded
voice memos.
User's Manual on Web (QR Code): Displays the QR code
that provides access to the online user manual for the
system.
Split Screen: Can turn on or off the split screen mode.
Voice Memo
You can use the microphone on the vehicle to record and play
voice memos.
Using the voice memos
On the All Menus screen, press Voice Memo.
Voice memo screen
ae
cdb

7-20
Playing a voice memo
You can select and play a recorded voice memo.
From the list of Voice Memos, press the desired voice
memo.
Recording a voice memo
1 On the Voice Memo screen, press .
It starts recording a voice memo.
2 When recording is finished, press on the
screen or press the End Call button on the
steering wheel.
The voice memo is automatically saved.
A
A
To temporarily stop recording, press
.
A
A
When recording starts, the other audio functions are muted
or playback is paused.
A
A
When you make or receive a call while recording, the
recording is paused.
A
A
When you make an emergency call or you are connected to
an emergency call after airbag deployment, the recording is
stopped and the recorded voice memo is automatically saved.

9-31
Border Crossing Information
You can set whether or not to display the border crossing
information on the screen.
Show Route Overview While Stopped.
You can set to display the route overview from the start point to
the destination when the vehicle is stationary.
Alerts
You can set to activate drive assist features when needed for
safety.
ÝWarning
Be sure to check the road conditions while driving, because the
camera information may get changed occasionally after a map
update to the latest version. Relying solely on the driving assist
system may cause violation of traffic rules and regulations,
resulting in an accident.
Camera Alert Distance
You can set when to receive alerts against and voice descriptions
about traffic enforcement cameras.
Camera Alerts with Navigation Muted: You can set traffic
enforcement camera alerts or warning sounds for safe driving
when the navigation is muted.

None: No guidance is provided when the navigation is
muted.

Use Beeps Only: Guidance is provided only with warning
sound.

Use Voice Prompts with Beeps: Guidance is provided
with warning sound and voice.
 Camera Alert Distance Depending on the Vehicle Speed:
The time when to get alerts for traffic enforcement cameras is
automatically set depending on the driving speed.

Camera Alert Distance (Local Roads)
: It is activated when
Camera Alert Distance Depending on the Vehicle Speed
is turned off. The time when to get guidance for traffic
enforcement cameras on general roads can be selected.

Camera Alert Distance (Highway): It is activated when
Camera Alert Distance Depending on the Vehicle Speed
is turned off. The time when to get guidance for traffic
enforcement cameras on highways can be selected.

10-2
Solutions
Before reporting a malfunctioning system, refer to the following table and see if you can identify and fix the problem. If the problem persists
or you are unable to locate your specific need, contact your place of purchase or dealer.
Sound and display
SymptomPossible cause Solution
A blank screen appears and
sound is not audible. The system is turned off.

Check that the start switch is in “ACC” or “ON.”
Press the Power button on the control panel to turn on the
system.
Sound volume is too low. Turn the Volume knob on the control panel to adjust the volume.
Sound is muted. Press the Mute button on the steering wheel to unmute.
Sound is audible from only one
side of the speakers. Sound is imbalanced.
On the All Menus screen, press Setup >
Sound >
Sound Tuning
and adjust the sound outputs for the left and right speakers.
The sound is cut off or noise is
heard. Vibration occurs in the system.
When the system vibrates, the sound may be cut off or noise may
occur. This is not a system failure. The system is restored as soon as
the vibration stops.