buttons KIA SORENTO 2015 Features and Functions Guide

25ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFET Y WARNINGS *IF EQUIPPED
SEATING
Driver Position Memory System*
To store a seating position into memory, first place the gear shifter into P (Park) while the ignition switch is on Then:
1 Adjust the driver’s seat and outside rearview mirror
2 Press the SET button A on the control panel System will beep once
3 Press one of the memory buttons B within 5 seconds The system will beep twice when memory has been stored
1
SET 2
Seat Warmers/Ventilated Seats*
Press button once for high setting (3 LEDs
lit) Press button twice for medium setting
(2 LEDs lit) Press button a third time for low
setting (1 LED lit) and again to turn OFF
Seat Warmers – Press right side of button
once for high setting (3 LEDs lit) Press
button twice for medium setting (2 LEDs lit)
Press a third time for low setting (1 LED lit)
and again to turn OFF
Ventilated Seats – Press left side of button
once for high setting (3 LEDs lit) Press twice
for medium setting (2 LEDs lit) Press a third
time for low setting (1 LED lit) and again to
t u r n O F F
Seat Warmers only*Seat Warmers/Ventilated Seats*
Warming (Yellow LED)Ventilating (Blue LED)
• With the seat warmer switch in the ON position, the heating system in the seat turns OFF or ON automatically depending on the seat temperature
• System turns OFF when ignition is cycled To turn system ON, press the seat warmer switch
QUICK TIPS
A
B
Hig hM ed iu m Lo wH ig h Med iu m Lo wH ig h Med iu m Lo wH ig hM ed iu m Lo w
Seat Warmers and Ventilated Seats Video To view a video on your mobile device, snap this QR Code or visit the listed website
Refer to page 2 for more information
QR Code
w w w. KuTechVideos .com/xm13/2015
(Located on Center Panel)(Located on Center Panel)
Hig hM ed iu m Lo wH ig h Med iu m Lo wH ig hM ed iu m Lo wH ig h Med iu m Lo w
H ig h Med iu m Lo wH ig h Med iu m Lo wH ig h Med iu m Lo wH ig h Med iu m Lo w

30
•
• You can reprogram a single HomeLink ® button by repeating Step 2
• Erasing programmed buttons will delete all trained transmitters
QUICK TIPS
The Auto-Dimming Rearview Mirror is designed to help
reduce glare from a vehicle’s headlights located in the
rear and also connect up to three electronic transmitters
in one location
To turn automatic dimming ON or OFF, press button F
HomeLink® with Auto-Dimming
Rearview Mirror*
How to Sync Transmitter with HomeLink®*
Erasing programmed buttons:
A HomeLink® button
B HomeLink® button
C Indicator light
D HomeLink® button
E Glare detection sensor
F Automatic dimming ON/OFF
G Compass control button
If programming for the first time, begin with Step 1
(repeating this step will delete all information)
To program non-rolling and rolling code garage door
openers and other devices:
1 Press and hold the left A and center D buttons
simultaneously until the indicator light C begins to
flash (to reprogram buttons, skip this step)
2 Press and hold the desired button A B D and hold
the button on the transmitter while it is approximately
1 to 3 inches away from the mirror The HomeLink®
Indicator light C will flash rapidly once the frequency
signal has been successfully programmed
To finish programming rolling code garage door openers,
complete these steps:
3 Locate the “learn” or “smart ” button on the garage
door’s motor head unit Press and release the button
and complete Step 4 within 30 seconds
4 Firmly press and release the programmed HomeLink®
button up to three times
Press and hold the left A and center D buttons
simultaneously for approximately 20 seconds,
and then release both buttons within 30 seconds
Operating HomeLink®:
Press one of the programmed HomeLink® buttons REMINDER: Mirror indicator light C will illuminate when automatic dimming is ON
If your garage door opener was manufactured in 2011 or later, and you’re unable to program your vehicle’s HomeLink® system, you may need to purchase a HomeLink® Repeater Kit. For more information, go to www.HomeLink.com or call (800) 355-3515 .
ABCDEFG
SORENTO FEATURES & FUNCTIONS GUIDE
*IF EQUIPPED
OTHER KEY FEATURES