light KIA STONIC 2018 Repair Manual

WIPERS AND WASHERS
'SPOU3FBS
JG
FRVJQQFE

¥
5ZQF
" ¥
5ZQF
"
¥
5ZQF
# ¥
5ZQF
$ ¥
5ZQF
#¥
5ZQF
$A: Wiper speed control (front)
1. 2/HI – High wiper speed
2. 1/LO – Low wiper speed
3. ---/INT – Intermittent wipe
AUTO *
– Automatic control wipe
4. O/OFF – Off5.
/1X – Single wipe
B: Intermittent control wipe time ad‐justment
C: Wash with brief wipes (front) *
D: Rear wiper/washer control
*
6. 2 – Continuous wipe
7. 1/ON – Intermittent wipe
8. O/OFF – Off
E: Wash with brief wipes (rear)
Windshield wipers (front)
Operates as follows when the ignition
switch is turned ON. 1. 2/HI : Fast wiper speed
2. 1/LO :Normal wiper speed
3. ---/INT : Wiper operates intermit‐ tently at the same wiping intervals.
Use this mode in light rain or mist.
To vary the speed setting, turn the
speed control knob.
* : if equipped
Features of your vehicle
4-90

INTERIOR LIGHT
CAUTION
Do not use the interior lights for ex‐tended periods when the engine isnot running.It may cause battery discharge.
WARNING
Do not use the interior lights whendriving in the dark. Accidents couldhappen because the view may beobscured by interior lights.
Map lamp
¥
5ZQF
"
¥
5ZQF
#
• (1) : Press the lamps to turn thefront map lamps on and off. •
(2):
- The map lamp and room lamp comes on when a door is opened.
The lamps go out after approxi‐
mately 30 seconds.
- The map lamp and room lamp comes on for approximately 30
seconds when doors are unlocked
with a transmitter or smart key as
long as the doors are not opened.
- The map lamp and room lamp will stay on for approximately 20 mi‐
nutes if a door is opened with the
ignition switch in the ACC or
LOCK/OFF position.
- The map lamp and room lamp will stay on continuously if the door is
opened with the ignition switch inthe ON position.
- The map lamp and room lamp will go out immediately if the ignition
switch is changed to the ON posi‐
tion or all doors are locked.
- To turn off the DOOR mode, press the DOOR button (2) once again
(not pressed).

4-95
4
Features of your vehicle

NOTICE
The DOOR mode and ROOM mode
can not be selected at a time.
Front Map Lamp:
• Type A(3): Press this switch to turn the
front map lamps on.
(4): Press this switch to turn the
front map lamps off.
• Type B
(3): Press this switch to turn the
front map lamps on and off.
Room lamp
•: The light stays on at all times.
Luggage room lamp (if
equipped)
The luggage room lamp comes on when
the trunk (tailgate) is opened.
CAUTION
The luggage room lamp comes on aslong as the trunk (tailgate) opens. Toprevent unnecessary charging sys‐tem drain, close the trunk (tailgate)
(Continued)
(Continued)
securely after using the luggageroom.
Vanity mirror lamp (if equipped)
Push the switch to turn the light on or
off.
: The lamp will turn on if this but‐
ton is pressed.
: The lamp will turn off if this button
is pressed.
Features of your vehicle
4-96

Air conditioning (A/C)
Press the A/C button to turn the air
conditioning system on (indicator light will illuminate). Press the button again
to turn the air conditioning system off.
System operation
Ventilation
1. Set the mode to the position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
Heating
1. Set the mode to the position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
5. If dehumidified heating is desired, turn the air conditioning system (if
equipped) on.
• If the windshield fogs up, set the mode to the
or position.
Operation Tips
• To keep dust or unpleasant fumes from entering the vehicle through the
ventilation system, temporarily set the air intake control to the recircula‐
ted air position. Be sure to return the
control to the fresh air position when
the irritation has passed to keep
fresh air in the vehicle. This will help the driver to stay alert and comfort‐
able. • Air for the heating/cooling system is
drawn in through the grilles just
ahead of the windshield. Care should
be taken that these are not blocked by leaves, snow, ice or other obstruc‐
tions.
• To prevent interior fog on the wind‐ shield, set the air intake control to
the fresh air position and fan speed to the desired position, turn on the
air conditioning system, and adjust
the temperature control to the de‐
sired temperature.
Air conditioning
Kia Air Conditioning Systems are filled
with environmentally friendly refriger‐
ant *
.
1. Start the engine. Push the air con‐ ditioning button.
2. Set the mode to the
position.
* Your vehicle is filled with R-134a or
R-1234yf according to the regula‐tion in your country at the time of
producing. You can find out which air
conditioning refrigerant is applied
your vehicle at the label inside of en‐
gine room. Refer to L

3. Set the air intake control to theoutside air or recirculated air posi‐
tion.
4. Adjust the fan speed control and temperature control to maintain
maximum comfort.
CAUTION
•The refrigerant system should on‐ly be serviced by trained and certi‐fied technicians to insure properand safe operation.
•The refrigerant system should beserviced in a well-ventilated place.
•The air conditioning evaporator(cooling coil) shall never be re‐paired or replaced with one re‐moved from a used or salvagedvehicle and new replacement MACevaporators shall be certified (andlabeled) as meeting SAE StandardJ2842.
NOTICE
•When using the air conditioning
system, monitor the temperature
gauge closely while driving up hills
or in heavy traffic when outside
temperatures are high. Air condi‐
tioning system operation may
cause engine overheating. Contin‐
ue to use the blower fan but turn
the air conditioning system off if
the temperature gauge indicates
engine overheating.
•When opening the windows in hu‐
mid weather air conditioning may
create water droplets inside the
vehicle. Since excessive water
droplets may cause damage to
electrical equipment, air condition‐
ing should only be used with the
windows closed.
Air conditioning system operation tips
• If the vehicle has been parked in di‐ rect sunlight during hot weather,
open the windows for a short time to let the hot air inside the vehicle es‐
cape. • To help reduce moisture inside of the
windows on rainy or humid days, de‐
crease the humidity inside the vehicle
by operating the air conditioning sys‐ tem.
• During air conditioning system opera‐ tion, you may occasionally notice a
slight change in engine speed as the
air conditioning compressor cycles.
This is a normal system operation characteristic.
• Use the air conditioning system every month only for a few minutes to en‐
sure maximum system performance.
• When using the air conditioning sys‐ tem, you may notice clear waterdripping (or even puddling) on the
ground under the passenger side of
the vehicle. This is a normal system
operation characteristic.
• Operating the air conditioning system in the recirculated air position pro‐vides maximum cooling, however,
continual operation in this mode may
cause the air inside the vehicle to be‐
come stale.
• During cooling operation, you may oc‐ casionally notice a misty air flow be‐
cause of rapid cooling and humid air
intake. This is a normal system oper‐
ation characteristic.

4-105
4
Features of your vehicle

(Continued)
senger compartment may become
stale.
In addition, prolonged use of the air
conditioning with the recirculated air
position selected will result in exces‐
sively dry air in the passenger com‐
partment.
WARNING
•Continued climate control systemoperation in the recirculated airposition may allow humidity to in‐crease inside the vehicle whichmay fog the glass and obscure vis‐ibility.
•Do not sleep in a vehicle with theair conditioning or heating systemon. It may cause serious harm ordeath due to a drop in the oxygenlevel and/or body temperature.
(Continued)
(Continued)
•Continued climate control systemoperation in the recirculated airposition can cause drowsiness orsleepiness, and loss of vehicle con‐trol. Set the air intake control tothe outside (fresh) air position asmuch as possible while driving.
Fan speed control
The fan speed can be set to the desired
speed by operating the fan speed con‐ trol knob.
The higher the fan speed is, the more
air is delivered. Pressing the OFF button turns off the
fan.
Air conditioning (A/C)
Press the A/C button to turn the air
conditioning system on (indicator light will illuminate).
Press the button again to turn the air
conditioning system off.

4-113
4
Features of your vehicle

3. Set the air intake control to theoutside air or recirculated air posi‐
tion.
4. Adjust the fan speed control and temperature control to maintain
maximum comfort.
CAUTION
•The refrigerant system should on‐ly be serviced by trained and certi‐fied technicians to insure properand safe operation.
•The refrigerant system should beserviced in a well-ventilated place.
•The air conditioning evaporator(cooling coil) shall never be re‐paired or replaced with one re‐moved from a used or salvagedvehicle and new replacement MACevaporators shall be certified (andlabeled) as meeting SAE StandardJ2842.
NOTICE
•When using the air conditioning
system, monitor the temperature
gauge closely while driving up hills
or in heavy traffic when outside
temperatures are high. Air condi‐
tioning system operation may
cause engine overheating. Contin‐
ue to use the blower fan but turn
the air conditioning system off if
the temperature gauge indicates
engine overheating.
•When opening the windows in hu‐
mid weather air conditioning may
create water droplets inside the
vehicle. Since excessive water
droplets may cause damage to
electrical equipment, air condition‐
ing should only be used with the
windows closed.
Air conditioning system operation tips
• If the vehicle has been parked in di‐ rect sunlight during hot weather,
open the windows for a short time to let the hot air inside the vehicle es‐
cape. • To help reduce moisture inside of the
windows on rainy or humid days, de‐
crease the humidity inside the vehicle
by operating the air conditioning sys‐ tem.
• During air conditioning system opera‐ tion, you may occasionally notice a
slight change in engine speed as the
air conditioning compressor cycles.
This is a normal system operation characteristic.
• Use the air conditioning system every month only for a few minutes to en‐
sure maximum system performance.
• When using the air conditioning sys‐ tem, you may notice clear waterdripping (or even puddling) on the
ground under the passenger side of
the vehicle. This is a normal system
operation characteristic.
• Operating the air conditioning system in the recirculated air position pro‐vides maximum cooling, however,
continual operation in this mode may
cause the air inside the vehicle to be‐
come stale.
• During cooling operation, you may oc‐ casionally notice a misty air flow be‐
cause of rapid cooling and humid air
intake. This is a normal system oper‐
ation characteristic.

4-115
4
Features of your vehicle

1. Turn the ignition switch to the ONposition.
2. Turn the mode selection knob to the defrost position (
).
3. Push the air intake control button at least 5 times within 3 seconds.
The indicator light in the air intake con‐
trol button will blink 3 times. It indi‐ cates that the defogging logic is can‐
celed or returned to the programmed
status.
If the battery has been discharged or disconnected, it resets to the defog
logic status.
Automatic climate control system
(if equipped)
1. Turn the ignition switch to the ON position.
2. Select the defrost position pressing defrost button (
).
3. While holding the air conditioning button (A/C) pressed, press the air
intake control button at least 5
times within 3 seconds.
The A/C display blinks 3 times. It indi‐ cates that the defogging logic is can‐
celed or returned to the programmed
status.
If the battery has been discharged or disconnected, it is reset to the defog
logic status.
Auto defogging system (Only for
automatic climate control system,
if equipped)
Auto defogging reduces the possibility
of fogging up the inside of the wind‐ shield by automatically sensing the
moisture of inside the windshield and
air flow toward the windshield can in‐ crease.
The auto defogging system operates
when the AUTO mode is on.
For Europe
If your vehicle is equipped with the auto
defogging system, it is automatically
activated when the conditions are met.
Features of your vehicle
4-120

STORAGE COMPARTMENTS
These compartments can be used to store small items required by the driver
or passengers.
CAUTION
•To avoid possible theft, do notleave valuables in the storagecompartments.
•Always keep the storage compart‐ment covers closed while driving.Do not attempt to place so manyitems in the storage compartmentthat the storage compartmentcover cannot close securely.
WARNING
nFlammable materials
Do not store cigarette lighters, pro‐pane cylinders, or other flammable/explosive materials in the vehicle.These items may catch fire and/orexplode if the vehicle is exposed tohot temperatures for extended peri‐ods.
Center console storage (if
equipped)
These compartments can be used to
store small items required by the driver or front passenger.
To open the center console storage pull
up the lever .
Glove box
To open the glove box, pull the handle
and the glove box will automatically open. Close the glove box after use.
WARNING
To reduce the risk of injury in an ac‐cident or sudden stop, always keepthe glove box door closed while driv‐ing.
Features of your vehicle
4-122

INTERIOR FEATURES
Cigarette lighter (if equipped)
For the cigarette lighter to work, the
ignition switch must be in the ACC posi‐ tion or the ON position.
To use the cigarette lighter, push it all
the way into its socket. When the ele‐
ment has heated, the lighter will pop out to the L