start stop button LAMBORGHINI GALLARDO 2009 Workshop Manual

Page 1274 of 1659

2
L714 09 15 00
Fig.2
A - +
%
® Automobili Lamborghini S.p.A.7KHLQIRUPDWLRQDQGSURFHGXUHVSXEOLVKHGEHORZDUHVWULFWO\FRQ¿GHQWLDODQGH[FOXVLYHO\IRUWKH/DPERUJKLQL'HDOHU1HWZRUNDQG$XWKRUL]HG6HUYLFH3RLQWV$OOFRS\ULJKWVDUHSURSHUW\RI$XWRPRELOL
/DPERUJKLQL6S$EDVHGRQFRS\ULJKWODZ$OORIWKH3')FKDSWHUVLQWKH:(%ZRUNVKRSPDQXDOVGHVFULEHGEHORZDUHEDVHGRQLQIRUPDWLRQDYDLODEOHDWWKHWLPHRISXEOLFDWLRQ7KHFRPSDQ\UHVHUYHV
WKH ULJKW WR PDNH XSGDWHV DQG PRGL¿FDWLRQV 7KH IROORZLQJ DUH SURKLELWHG UHSULQWLQJ UHSURGXFWLRQIRUZDUGLQJ WR XQDXWKRUL]HG SHRSOH DQGRU WKLUG SDUWLHV DQG WUDQVODWLRQ LQFOXGLQJ SDUWLDO ZLWKRXW
ZULWWHQDXWKRUL]DWLRQIURP$XWRPRELOL/DPERUJKLQL6S$
&RQQHFWWKHSRVLWLYHSROHVWRWKHSRVLWLYHFDEOH UHG  •Secure one end to the positive pole  of the dead battery ( A-Fig.2).
• Secure the other end to the positive pole  of the supply battery ( %)LJ).
&RQQHFWWKHQHJDWLYHSROHVWRWKHQHJDWLYHFDEOH EODFN  • Secure one end to the negative pole  of the supply battery ( %)LJ).
• Secure the other end to the negative pole  of the supply battery ( A-Fig.2).
Starting the engine • Start the engine of the car that is supplying the current and let it idle.
• Start the engine of the car with the dead battery.
1RWH
The battery’s low voltage could require resynchronization of the ignition key before starting. In this case, turn the key to ON and hold the LOCK/UNLOCK buttons down for approximately 30 seconds.
• If the engine does not start immediately, stop starting after 10 seconds and repeat after approximately 30
seconds.
• Leave the engine on and remove the cables in the opposite order described previously (remove the ground
FRQQHFWLRQ¿UVWDQGWKHQWKHSRVLWLYH 
• Carry out the following operations:Resynchronization of second remote control Resynchronization of steering angle Resynchronization of power window zero position

Page 1483 of 1659

47
L714 10 90 00
® Automobili Lamborghini S.p.A.7KHLQIRUPDWLRQDQGSURFHGXUHVSXEOLVKHGEHORZDUHVWULFWO\FRQ¿GHQWLDODQGH[FOXVLYHO\IRUWKH/DPERUJKLQL'HDOHU1HWZRUNDQG$XWKRUL]HG6HUYLFH3RLQWV$OOFRS\ULJKWVDUHSURSHUW\RI$XWRPRELOL
/DPERUJKLQL6S$EDVHGRQFRS\ULJKWODZ$OORIWKH3')FKDSWHUVLQWKH:(%ZRUNVKRSPDQXDOVGHVFULEHGEHORZDUHEDVHGRQLQIRUPDWLRQDYDLODEOHDWWKHWLPHRISXEOLFDWLRQ7KHFRPSDQ\UHVHUYHV
WKH ULJKW WR PDNH XSGDWHV DQG PRGL¿FDWLRQV 7KH IROORZLQJ DUH SURKLELWHG UHSULQWLQJ UHSURGXFWLRQIRUZDUGLQJ WR XQDXWKRUL]HG SHRSOH DQGRU WKLUG SDUWLHV DQG WUDQVODWLRQ LQFOXGLQJ SDUWLDO ZLWKRXW
ZULWWHQDXWKRUL]DWLRQIURP$XWRPRELOL/DPERUJKLQL6S$
6SHHGDGMXVWPHQWV\VWHP *5$ GLVSOD\LQ0DVWHURQO\
Real speed
Y¿OBZSwitch positions193Theoretical speed
Y]LHOBZ Switch positions194
[km/h]
min: 0
max: 250 0 Stop light switch
B_bl
1 Brake pedal switch B_br
2 Clutch switch
%BNXSSO
3 GRA released B_fgrtet
4 ACC-SG available
B_acc
5 Main switch touched &:**)*5+
6 GRA status for CAN CAN Statgra(0
7 GRA status for CAN
CAN Statgra(1\ min: 0
max: 250
0 GRA on (CAN)
B_fgrhsc
1 Set (GRA on) B_fgratc
2 Delay B_fgrtdc
3 Acceleration B_fgrtuc
4 Setting B_fgrsec
5 Pickup B_fgrwac
6 Free
7 GRA on S_fgrhs
*HDUER[VWDWXV
Engine speed QPRW LoadUOGear notch (automatic gearshift)
JDQJL Converter clutch
%BZNDXI%BZN%BZNU
[1/min] [%] [0-7] Text
min: 500
max: 7200 min: 7
max: 100P,N = 0
Gear = 1-6
R = 7 clutch on
clutch off
clutch adj. ERROR
Reduction of emissions
3XUJHFKHFNVKRUWWULSGLVSOD\LQ0DVWHURQO\
- Function 04(default setting)
- Start the short trip with the “Activation” button
- Wait until ³7(9RN´LVGLVSOD\HGLQ¿HOG
Purge percentage opening
(pulsing rate) WDWHRXW Mean oxygen sensor
variator value
LNDNGLIIBZ Idle speed regulator, diagnosis value for
enabled diagnosis
UPVWHYXIBZ Result195
[%] [%] [%] Text
min: 0
max: 100 Test ON
Test OFF
TEV ok
TEV not ok