Key lock Lancia Delta 2009 Owner handbook (in English)

6GETTING TO KNOW YOUR CAR
DASHBOARD
The presence and position of controls, instruments and gauges may vary according to different versions.
1. Air vent for side windows - 2. Adjustable air vent - 3. Exterior lighting control lever - 4. Instrument panel - 5.
Windscreen wiper/rearscreen wiper/trip computer control lever - 6. Adjustable air vents - 7. Hazard warning lights -
8. Passenger front air bag - 9. Glove compartment - 10. Dashboard controls - 11. Climate controls - 12. Ignition key
and ignition device - 13. Driver front air bag - 14. Driver front knee air bag (where provided) - 15. Steering lock lever
- 16. Fuse box access flap - 17. Bonnet opening lever.
fig. 1L0E0001m

10GETTING TO KNOW YOUR CAR
If the warning light xturns on when the car
is travelling (together with the message on the
display on certain versions) stop the engine
immediately and contact a Lancia Dealership.
Brake pad wear (amber)
The warning light (or symbol on the display)
lights up when the front brake pads show signs
of wear; under these circumstances have them re-
placed as soon as possible. The display will show the ded-
icated message.
d
Airbag failure (red)
This warning light comes on when the ignition
key is turned to MAR, but it should go off af-
ter a few seconds. The warning light stays on,
glowing steadily, if there is a failure in the air bag sys-
tem. The display will show a dedicated message.
¬
If, when the key is turned to MAR, the ¬
warning light does not come on or if it stays
on with the vehicle in motion (together with
the message on the display) there could be a fail-
ure in the safety systems; under these circumstances
the air bags or pretensioners may not be triggered
in the event of an impact or, more rarely, they could
be triggered accidentally. Contact Lancia Dealer-
ship to have the system checked immediately.
EBD failure (red)
If warning lightsxand are lit up at the same
time with the engine running, this indicates an
EBD system failure or that the system is not
available. Early locking of the rear wheels may
occur in the event of violent braking, causing
the car to swerve.
Drive very carefully to a Lancia Dealership to have
the system inspected. The display will show a dedicated
message.
x
>
WARNING Because the vehicle is equipped with a wear
detection system only for the front brake pads, when these
are replaced the rear brake pads should also be checked
for wear.

16GETTING TO KNOW YOUR CAR
Go to a Lancia Dealership as soon as possi-
ble if warning light Ueither does not light up
when the key is turned to MAR or if while
travelling the warning light comes on either steady
or blinking (on some versions along with a message
on the display). The operation of the warning light
Umay be checked by the traffic police using spe-
cific devices. Follow the laws in force in the coun-
try where you are driving.
Advanced ESP system (amber)
This warning light comes on when the ignition
key is turned to MAR, but it should go off after
a few seconds. If the warning light does not go off
or stays on together with the LED on the ASR button when
travelling, contact a Lancia Dealership. On certain versions
a dedicated message is displayed. If the warning light
flashes when driving, this indicates that the Advanced ESP
system has cut in.
á
Hill holder system failure (amber)
The áwarning light turns on to indicate a Hill
holder system failure. In this case, contact a
Lancia Dealership as soon as possible. Alter-
natively, on some versions the *symbol is
lit up on the display.
The display will show a dedicated message.
á
*
Glow plug preheating
This warning light comes on when the key is
turned to MAR. It will go out as soon as the glow
plugs have reached a predetermined temperature.
Start the engine as soon as the warning light goes out.
IMPORTANT At high outdoor temperatures the warning
light stays on for an extremely short time.
m
To switch the warning light off, carry out the following
initialization procedure:
turn the ignition key to the ON position;
turn the steering wheel fully both clockwise and anti-
clockwise (to move from the position with the wheels
straight);
turn the ignition key to the OFF position and then turn
it back ON.
If the
áwarning light does not go out after a few
seconds, seek assistance from a Lancia Dealership.

28GETTING TO KNOW YOUR CAR
First page (Display of information on the initial
screen) (where provided)
This function allows you to choose the information you
would like to see on the main screen. You can choose to
display the date or the turbo charger turbocharging pres-
sure.
Proceed as follows:
– briefly press SET: “Initial page” will appear on the dis-
play;
– briefly press SET once again to show the display options:
“Date” and “Engine info”;
– press + or – to select the information you wish to see
on the main page of the display;
– briefly press SET to go back to the menu screen or hold
the button down to go back to the standard screen with-
out storing the new settings.
When the key is turned to MAR and the initial check stage
is over, the display will show the information selected via
the “initial page” menu function.See radio (Repeat audio information)
With this function the display repeats information rele-
vant to the sound system.
– Radio: tuned radio station frequency or RDS message,
automatic tuning activation or AutoSTore;
– audio CD, MP3 CD: track number;
– CD Changer: CD number and track number.
To activate (On) or to deactivate (Off) sound system in-
fo displaying proceed as follows:
– press SET briefly: (On) or (Off) will flash on the display
(according to previous setting);
– press
Õor Ôto change the setting;
– briefly press SET to go back to the menu screen or hold
the button down to go back to the standard screen with-
out storing the new settings.
Autoclose (Automatic door lock operation with car
running)
When activated (On), this function automatically locks
the doors when the car speed exceeds 20 km/h.
Proceed as follows to switch this function on or off:
– briefly press SET to display a submenu;
– briefly press SET: (On) or (Off) will flash on the display
(according to previous setting);
– press
Õor Ôto change the setting;

GETTING TO KNOW YOUR CAR37
1
THE LANCIA CODE SYSTEM
This is an electrical engine locking system which increases
protection against an attempted theft of the car. It is auto-
matically activated when the ignition key is extracted.
Each key contains an electronic device which modulates
the signal emitted during ignition by an antenna built in-
to the ignition device. This signal is the ‘password’ which
changes at each ignition and which the control unit uses
to recognise the key and allow ignition.
OPERATION
Each time the car is started by turning the ignition key
to MAR, the Lancia CODE system control unit sends an
acknowledgement code to the engine control unit to de-
activate the inhibitor.
The code is sent only if the control unit of the Lancia
CODE system has acknowledged the code received from
the key.
Each time the ignition key is turned to STOP, the Lancia
CODE system deactivates the functions of the electronic
engine control unit.
If the code is not recognised correctly during ignition, the
Ywarning light (or symbol in the display) comes on.In this case turn the key to STOP and then to MAR; if
the lock persists try again with the spare set of keys. Con-
tact a Lancia Dealership if you still cannot start the en-
gine.
IMPORTANT Each key has its own code which must be
stored by the system control unit. To have new keys mem-
orised (up to a maximum number of eight keys), contact
a Lancia Dealership and be ready to present all the keys
you have at present, the CODE card, a personal identity
document and the car ownership documents. The codes
of any keys not presented during the memorising proce-
dure will be deleted. This is to prevent lost or stolen keys
from starting the engine.
Ywarning light (or symbol in the display) lit up
during driving
If the Ywarning light (or symbol in the display)
comes on, this means that the system is running a self-
diagnosis test (caused, for example, by a voltage drop).
If the Ywarning light (or symbol in the display) remains
on, contact a Lancia dealership.
The electronic components inside the key may
be damaged if the key is submitted to sharp
knocks.

38GETTING TO KNOW YOUR CAR
THE KEYS
CODE CARD (available on request for
versions/markets where provided)
A CODE card fig. 9 is provided together with the vehicle
keys. This should be presented to a Lancia Dealership
should you require any duplicate keys.
IMPORTANT In order to ensure complete efficiency of the
electronic devices inside the keys, they should never be ex-
posed to direct sunlight.MECHANICAL KEY (where provided)
The key is provided with a metal insert A-fig. 10, which
operates:
the ignition switch;
the door locks;
fig. 9L0E0102mfig. 10L0E0103m
The ignition key and the CODE card must be
handed over to the new owner when selling
the car.

GETTING TO KNOW YOUR CAR39
1
fig. 11L0E0104m
KEY WITH REMOTE CONTROL fig. 11
The key is provided with a metal insert A, which operates:
the ignition switch
the door locks
To open/close the metal insert, press button B.
Button
Ëremotely releases the doors locks.
In this case the timed lighting of interior courtesy lights
and double flashing of direction indicators (for ver-
sions/markets where provided) takes place.
Press button
Ëfor longer than 2 seconds: to open the win-
dows.
Button
Áremotely locks the doors.In this case the interior courtesy lights go out and the di-
rection indicators flash once.
Press button
Áfor longer than 2 seconds: to close the win-
dows.
If one or more door are open, the doors will not be locked.
Button
Rcan be used to open the tailgate remotely.
Tailgate opening is indicated by the double flashing of the
direction indicators; tailgate closing by single flashing (on-
ly with the alarm switched on, where provided).
Button B opens power-assisted opening of metal insert
A.
To reinsert the metal insert into the grip, hold down but-
ton B and turn the insert in the direction shown by the ar-
row until you hear it click into place. Then release but-
ton B.
If the button for locking doors Áis acciden-
tally pressed from the inside, only the doors
opened for getting out of the car are released; the
tailgate remains locked. To realign the system the
locking/unlocking buttons
Á/Ëmust be pressed once
again.

40GETTING TO KNOW YOUR CAR
Press button B-fig. 11 only when the key is
far away from you, particularly from your
eyes and other objects that may be damaged
(e.g. clothing). Do not leave the key unattended, be-
cause someone, a child especially, may accidental-
ly press the button while handling the key.
Requesting additional remote controls
The system acknowledges up to 8 remote controls. Should
a new remote control be necessary, contact a Lancia Deal-
ership and be ready to present the CODE card, a person-
al identity document and the car’s ownership documents.
Replacing the battery of the key with remote
control fig. 12
Battery replacement:
press button A and bring the metal insert B to the
“open” position;
turn screw C to :using a small point screwdriver;
take out the battery case D and replace the battery E,
respecting its polarity;
refit the battery case D inside the key and lock it by
turning the screw C to Á.
fig. 12L0E0105m
Used batteries are harmful to the environ-
ment. They should be disposed of as specified
by law in special containers or taken to a
Lancia Dealership, which will take care of their dis-
posal.

42GETTING TO KNOW YOUR CAR
IMPORTANT The engine inhibitor function is guaranteed
by the Lancia CODE, which is automatically activated
when the ignition key is extracted from the starter de-
vice.
SWITCHING ON THE ALARM
With the doors and bonnet closed and the ignition key
either turned to STOP or removed, point the key with the
remote control towards the vehicle and press and release
button
Á.
Excluding some versions for specific markets, the system
produces an acoustic warning (beep) and enables door
locking.
Before the alarm is enabled, a self-diagnosis test is run:
if a fault is detected, the system emits another sound warn-
ing and a message is shown on the display, (see “Instru-
ment panel warning lights”).
In this case switch off the alarm by pressing
Ë, check that
all the doors, bonnet and tailgate are closed correctly; then
switch the alarm back on by pressing
Á.
If a door or the bonnet is not correctly closed, it will be ex-
cluded from the testing by the alarm system.
If the alarm produces an acoustic signal even when the
doors, bonnet and tailgate are correctly closed, a failure
has occurred in system operation. Contact a Lancia Deal-
ership.IMPORTANT Centrally locking the doors using the met-
al insert on the key does not activate the alarm.
IMPORTANT Originally, the alarm is configured in com-
pliance with the regulations existing in the different coun-
tries.
SWITCHING OFF THE ALARM
Press button
Ëon the key with the remote control.
The following operations are performed (excluding some
versions for specific markets):
the direction indicators flash twice;
two brief acoustic signals are emitted (“BEEP”);
the doors are unlocked.
IMPORTANT If the central door locking system is re-
leased using the metal insert of the key, the alarm is not
disabled.

GETTING TO KNOW YOUR CAR43
1
VOLUME SENSING/ANTI-TILT PROTECTION
To guarantee the correct operation of the protection, close
the side windows and sunroof completely (where provid-
ed).
If necessary this function can be excluded (e.g. when leav-
ing pets on board) by pressing button A-fig. 14, located
on the front courtesy light, before activating the alarm.
When the function is disabled, this is indicated by the LED
on the button flashing for several seconds. Any disabling
of the volume sensing/anti-tilt protection must be repeat-
ed each time the instrument panel is switched off.
BREAK IN ATTEMPT INDICATION
Any break in attempt is indicated by the
Ywarning light
(or symbol in the display) lighting up, together with a mes-
sage shown on the display (see “Instrument panel warn-
ing lights”).DISABLING THE ALARM
To permanently disable the alarm (e.g. during a lengthy
period of idleness), simply lock the vehicle by turning the
metal insert of the key with remote control in the lock.
IMPORTANT If the battery of the key with the remote
control goes flat or the system fails, the alarm can be
switched off by placing the key in the ignition switch and
turning it to MAR.
fig. 14L0E0153m