engine Lancia Delta 2015 Owner handbook (in English)

252MAINTENANCE AND CARE
BODYWORK
PROTECTION AGAINST ATMOSPHERIC AGENTS
The main causes of corrosion are the following:
❍atmospheric pollution;
❍ salty air and humidity (coastal areas, or hot humid cli-
mates);
❍ seasonal environmental conditions.
The abrasive action of wind-borne atmospheric dust and
sand, as well as mud and gravel raised by other cars is
also not to be underestimated.
On your car, Lancia has implemented the best manufac-
turing technologies to effectively protect the bodywork
against corrosion. These include:
❍
paint products and systems which give the car a spe-
cial resistance to corrosion and abrasion;
❍ use of galvanised (or pre-treated) steel sheets with high
resistance to corrosion;
❍ spraying the underbody, engine compartment, wheel
arch internal parts and other elements with highly pro-
tective wax-based products;
❍ spraying protective plastic materials in the most ex-
posed areas: underdoor, inner wing parts, edges, etc.;
❍ using “open” boxed sections to prevent condensation
and pockets of moisture from causing rust inside.
BODY AND UNDERBODY WARRANTY
Your car is covered by warranty against perforation due
to rust of any original element of the structure or body-
work.
For the general terms of this warranty, refer to the War-
ranty Booklet.
233-256 Delta GB 1ed 03/04/14 13:28 Pagina 252

MAINTENANCE AND CARE255
Windows
Use specific detergents and clean cloths to prevent scratch-
ing or altering the transparency.
IMPORTANT Wipe the inside surface of the rear window
gently with a cloth in the direction of the filaments to avoid
damaging the heater coils.
Engine compartment
At the end of each winter, thoroughly wash the engine
compartment, taking care to avoid spraying the water jet
directly onto the electronic control units and the relay/fuse
box on the left side of the engine compartment (driving
direction). Have this operation performed at a specialised
workshop.
IMPORTANT The washing should take place with the en-
gine cold and the ignition key in the STOP position. After
the washing operation, make sure that the various protec-
tions (e.g. rubber caps and guards) have not been removed
or damaged.Front headlights
Use a soft cloth soaked in water and detergent for wash-
ing cars.
IMPORTANT Never use aromatic substances (e.g. petrol)
or ketones (e.g. acetone) for cleaning the plastic lenses of
the front headlights.
IMPORTANT When cleaning the car with a pressure wash-
er, keep the water jet at least 20 cm away from the head-
lights.
233-256 Delta GB 1ed 03/04/14 13:28 Pagina 255

6
TECHNICAL SPECIFICATIONS257
Identification data ........................................................... 258
Engine codes - bodywork versions .................................... 260
Engine ........................................................................\
.... 261
Fuel supply syst em .......................................................... 262
Transmission ................................................................... 262
Brakes ........................................................................\
..... 263
Suspension ...................................................................... 263
Steering .......................................................................\
... 263
Wheels ........................................................................\
.... 264
Dimensions ..................................................................... 269
Performance ................................................................... 270
Weights .......................................................................\
.... 271
Capacities .......................................................................\
272
Fluids and lubr icants ...................................................... 273
Fuel consumpt ion ........................................................... 275
CO
2emissions ................................................................. 276
257-280 Delta GB 1ed 02/09/13 09.37 Pagina 257

258TECHNICAL SPECIFICATIONS
IDENTIFICATION DATA
The vehicle identification details are, fig. 1:
1 V.I.N. plate (located in the engine compartment, to theside of the right shock absorber upper mounting);
2 Bodyshell marking (located on the passenger compart- ment floor, next to the passenger side front seat);
3 Bodywork paint identification plate (located on the in- side of the tailgate);
4 Engine marking (located on the left rear section, gear- box side). V.I.N. PLATE fig. 2
This plate is fitted to the engine compartment front cross-
member and contains the following data:
B Type-approval number.
C Vehicle type identification code.
D Chassis number.
E Maximum authorised weight of vehicle fully laden.
F Maximum authorised weight of vehicle fully laden plus
trailer.
G Maximum authorised weight on first axle (front).
H Maximum authorised weight on second axle (rear).
I Engine type.
L Bodywork version code.
M Spare parts number.
N Correct value of smoke coefficient (for diesel engines)
fig. 1L0E0116mfig. 2L0E0117m
257-280 Delta GB 1ed 02/09/13 09.37 Pagina 258

TECHNICAL SPECIFICATIONS259
6
CHASSIS MARKING fig. 3
This is printed on the passenger compartment floor, next
to the front right seat. Slide flap A forward to access.
The marking includes:
❍vehicle type (ZAR 844000)
❍ chassis number BODYWORK PAINT IDENTIFICATION
PLATE fig. 4
This plate is applied inside the bonnet and shows the fol-
lowing data:
A Paint manufacturer.
B Colour name.
C Lancia colour code.
D Respray and touch-up colour code.
ENGINE MARKING
Engine marking is stamped on the cylinder block and in-
cludes the model and the chassis serial number.
fig. 3L0E0118mfig. 4L0E0119m
257-280 Delta GB 1ed 02/09/13 09.37 Pagina 259

844A3000
198A2000844AXP1A 13B
844AXP1A 13C (*)
844AXC1A 02L
844AXC1A 02M (*)
260TECHNICAL SPECIFICATIONS
ENGINE CODES - BODYWORK VERSIONS
VERSIONS ENGINE CODEBODYWORK VERSION
1.6 Multijet 105 HP
1.6 Multijet 120 HP
(*) Versions where 18” tyres may be fitted
257-280 Delta GB 1ed 02/09/13 09.37 Pagina 260

844A3000Diesel
4 in line
79.5 × 80.5 1598
16.5
± 0.4
77
105
4000
300 31
1500
Diesel fuel for
motor vehicles
(EN590 specification)
198A2000
Diesel
4 in line
79.5 × 80.5 1598
16.5
± 0.4
88
120
4000
300 31
1500
Diesel fuel for
motor vehicles
(EN590 specification)
TECHNICAL SPECIFICATIONS261
6
ENGINE
GENERAL INFORMATION 1.6 Multijet 105 HP1.6 Multijet 120 HP
Type code
Cycle
Number and arrangement of cylinders
Piston bore and stroke mm
Total displacement cm3
Compression ratio
Max. power (EC) kW
HP
corresponding speedrpm
Max. torque (EC) Nm
kgm
corresponding speed rpm
Fuel
257-280 Delta GB 1ed 02/09/13 09.37 Pagina 261

58–
8/10 –
7.1 –
4.3 3.6
4.9 4.1
1.87 1.7
–0 .8
6–
CAPACITIES
272TECHNICAL SPECIFICATIONS
(▲) When the vehicle is used in particularly harsh climate conditions, we recommend using a mixture of 60% PARAFLU UPand
40% distilled water.
Diesel fuel for motor vehicles
(EN590 specification)
Mixture of demineralised water
and PARAFLU
UPin 50-50 proportion ( ▲)
SELENIA WR FORWARD
TUTELA TRANSMISSION GEARFORCE
TUTELA TOP 4
Water and fluid mixture
TUTELA PROFESSIONAL SC 35
1.6 MultiJet 105/120 HP Prescribed fuels
and original lubricants
litres kg
Fuel tank:
including a reserve of:
Engine cooling system:
Engine sump:
Engine sump and filter:
Gearbox/differential
casing:
Hydraulic brake circuit
with ABS:
Windscreen/rear window
washer fluid reservoir:
257-280 Delta GB 1ed 02/09/13 09.37 Pagina 272

TECHNICAL SPECIFICATIONS273
6
In case of emergency, if lubricants with the prescribed specifications are not available, products with the minimum indicated ACEA
performance can be used for topping up; in this case optimal performance\
of the engine is not guaranteed.
FLUIDS AND LUBRICANTS
Your car is equipped with an engine oil that has been thoroughly developed and tested in order to meet the requirements
of the Scheduled Servicing Plan. Constant use of the prescribed lubricants guarantees the fuel consumption and emis-
sion specifications. Lubricant quality is crucial for engine operation a\
nd duration.
PRODUCT SPECIFICATIONS
Usage Fluid and lubricant specifications Genuine fluids and Replacement
for a correct use of the car lubricantsinterval
Lubricant for
diesel engines
Synthetic based lubricant SAE 0W-30 grade.
FIAT 9.55535-DS1, ACEA C2 classification.SELENIA WR FORWARD
Contractual Technical
Reference No. F842.F13As per the
Scheduled
Servicing Plan
The use of products with specifications other than those indicated above\
could cause damage to the
engine not covered by the warranty.
257-280 Delta GB 1ed 02/09/13 09.37 Pagina 273

Gearboxes and
differentials
CV joints
differential side
CV joints
wheel side
Hydraulic brakes and
hydraulic clutch controls
windscreen/rear window
washer/wiper
Cooling circuits
Percentage of use:
50% water
50% PARAFLU
UP(❑)
To be mixed with diesel
(25 cc per 10 litres)
To be used undiluted or
diluted in windscreen/rear
window washer/wiper
systems
TUTELA TRANSMISSIONGEARFORCE
Contractual Technical
Reference No. F002.F10
TUTELA STAR 700
Contractual Technical
Reference No. F701.C07
TUTELA ALL STAR
Contractual Technical
Reference No. F702.G07
TUTELA TOP 4
Contractual Technical
Reference No. F001.A93
PARAFLU
UP(●)
Contractual Technical
Reference No. F101.M01
TUTELA DIESEL ARTContractual Technical
Reference No. F601.L06
TUTELA
PROFESSIONAL SC 35
Contractual Technical
Reference No. F201.D02
SAE 75W grade synthetic base lubricant.
FIAT 9.55550-MZ6 classification
Grease for constant velocity joints with low friction
coefficient. NL.GI. 0-1 consistency.
FIAT 9.55580 classification
Molybdenum disulphide grease, for use at
high operating temperatures. NL.GI. 1-2 consistency
FIAT 9.55580 classification
Synthetic fluid for brake and clutch systems.
It exceeds the specifications: FMVSS no. 116 DOT 4,
ISO 4925, SAE J 1704. FIAT 9.55597 classification
Red protective agent with antifreeze action, based on
inhibited monoethylene glycol with organic formula.
Exceeds CUNA NC 956-16, ASTM D 3306 specifications.
Additive for diesel fuel, protecting Diesel engines.
Mixture of spirits and surfactants.
Exceeds CUNA NC 956-11 specifications. FIAT 9.55522 classification
274TECHNICAL SPECIFICATIONS
Brake fluid
Protective
agent
for radiators
Diesel
fuel additive
Windscreen
and rear
window
washer fluid
(●) IMPORTANT Do not top up or mix using fluids with different specifications.
(
❑) When the vehicle is used in particularly harsh climate conditions, we recommend using a mixture of 60% PARAFLUUPand
40% demineralised water.
Lubricants
and greases
for drive
transmission
Usage Fluid and lubricant specifications Fluids and lubricants Applicationsfor a correct use of the car genuine
257-280 Delta GB 1ed 02/09/13 09.37 Pagina 274