lock Lexus ES300 1997 In Case Of An Emergency: In Case Of An Emergency

161
SECTION 4
IN CASE OF AN EMERGENCY
If your engine stalls while driving 162
If your vehicle will not start 162
If your vehicle overheats 165
If you have a flat tire 166
If your vehicle needs to be towed 172
If you cannot shift automatic transmission
selector lever 177
If you lose your keys or lock yourself out 178

IN CASE OF AN EMERGENCY
168
To remove the spare tire:

Loosen the nut and remove it.
Remove the spare tire cover.
Loosen the bolt and remove it.
When storing the spare tire, place it with the outer side of the
wheel facing up. Then bolt the tire in place and install the
spare tire cocver to prevent thetire from flying forward during
a collision or sudden braking.3. Block the wheel diaganally opposite the flat tire to
keep the vehicle from reolling when it is jacked up.
When blocking the wheel, place a wheel block in front of the
front wheels or behind the rear wheels.

IN CASE OF AN EMERGENCY
169
4. Loosen all the wheel nuts.
Always loosen the wheel nuts before raising the vehicle.
Turn the nuts counterclockwise to loosen them. To get
maximum leverage, fit the wrench to the nut so that the
handle is on the right side, as shown above. Grab the wrench
near the end of the handle and pull up on the handle. Be
careful that the wrench does not slip off the nut.
Do not remove the nuts yet ± just unscrew them about
one±half turn.5. Position the jack at the jack points as shown.
Make sure the jack is positioned on a level and solid surface.
6. After making sure no one is in the vehicle, raise it
high enough so that the spare tire can be installed.
Allow for the fact that you need more ground clearance when
putting on the spare tire than when removing the flat tire.

IN CASE OF AN EMERGENCY
170To raise the vehicle, insert the jack handle into the jack (it is
a loose fit) and turn it clockwise. As the jack touches the
vehicle and begins to lift, double±check that it is properly
positioned.
CAUTION!
Never get under the vehicle when it is supported by
the jack alone.
7. Remove the wheel nuts and remove the flat tire.
Lift the flat tire straight off and put it aside.
Before putting on the wheel, remove any corrosion on the
mounting surfaces with a wire brush or such. Installation of
wheels without good metal±to±metal contact at the
mounting surface can cause wheel nuts to loosen and
eventually cause a wheel to come off while driving.

IN CASE OF AN EMERGENCY
171
8. Reinstall all wheel nuts finger tight.
Align the holes in the wheel with the bolts. Then lift up the
wheel and get at least the top bolt started through its hole.
Wiggle the tire and press it back over the other bolts.
Reinstall the wheel nuts and tighten them as much as you
can by hand. Press the tire back and see if you can tighten
them more.9. Lower the vehicle completely and tighten the wheel
nuts.
Turn the jack handle counterclockwise to lower the vehicle.
Use only the wheel nut wrench to tighten the nuts. Do not use
other tools or any additional leverage other than your hands,
such as a hammer, pipe or your foot. Make sure the wrench
is securely engaged over the nut.
Tighten each nut a little at a time in order shown. Repeat the
process until all the nuts are tight.
CAUTION!
When lowering the vehicle, make sure all portions
of your body and all other persons around will not
be injured as the vehicle is lowered to the ground.
As soon as possible after changing wheels, have
the wheels nuts tightened by torque wrench at
103 N´m (10.5 kgf´m, 76 ft´lbf.).

IN CASE OF AN EMERGENCY
177
IF YOU CANNOT SHIFT
AUTOMATIC TRANSMISSION
SELECTOR LEVER
If you cannot shift the selector lever out of ªPº position
to other positions even though the brake pedal is
depressed, use the shift lock override button as
follows:

Turn the ignition key to ªLOCK.º Make sure the parking
brake is applied.
Pry up the cover with a flat±bladed screwdriver or
equivalent.
Insert the screwdriver or equivalent into the hole to push
down the shift lock override button. You can shift out of
ªPº position only while pushing the button.
Shift into ªNº position.
Insert the cover. Start the engine. For your safety, keep
the brake pedal depressed.
Be sure to have the system checked by your Lexus dealer
as soon as possible.

IN CASE OF AN EMERGENCY
178
IF YOU LOSE YOUR KEYS OR LOCK
YOURSELF OUT
If you need a replacement key, contact your Lexus
dealer.
See the suggestions given in ªKeysº on page 8.
If your keys are locked in the vehicle and you cannot get a
duplicate, many Lexus dealers can assist you. If you must
break a window to get in, we suggest breaking the smallest
side window because it is the least expensive to replace. Be
extremely cautious to avoid cuts from the glass.