engine coolant Lexus ES300 1997 Service Procedures And Specifications: Engine
Page 1 of 10
195
SECTION 6 ± 2
SERVICE PROCEDURES AND
SPECIFICATIONS
Engine
Specifications 196
Fuel 198
Facts about engine oil consumption 199
Used engine oil 201
Checking the engine oil level 201
Checking the engine coolant level 204
Page 3 of 10
ENGINE
197 ±COOLING SYSTEM
Capacity 9.2 L (9.7 qt., 8.2 Imp.qt.)
Coolant type Ethylene ± glycol coolant (Do not use alcohol type.)
±FUEL
Fuel type Only UNLEADED
Research octane number 91 (Octane Rating 87) or higher
±IGNITION SYSTEM
Spark plug ±Make NIPPONDENSO PK20TR11
NGK BKR6EKPB11
±Gap 1.1 mm (0.043 in.)
±ELECTRICAL SYSTEM
Battery ± Maintenance type battery
Specific gravity reading at 205C (685F): 1.260 Fully charged
1.160 Half charged
1.060 Discharged
Charging rates Quick charge 15A max.
Slow charge 5A max.
± Non±maintenance battery
Open voltage at 205C (685F): 12.7V Fully charged
12.3V Half charged
11.9V Discharged
[Voltage that is checked 20 minutes after the key is
removed with all the lights turned off]
Charging rates 5A max.
Page 10 of 10
ENGINE
204
CHECKING THE ENGINE COOLANT
LEVEL
Resevior cap Upper lineLower line
Park the vehicle at a level spot and look at the
see±through coolant reservoir when the engine is cool.
The coolant level is satisfactory if it is above the upper
and lower lines on the tank. If the level is low, add
ethylene±glycol type coolant.
The coolant level in the reservoir will vary with the engine
coolant temperature. However, if the level is on or below the
lower line, add coolant to bring the level to the upper line.
Use only ethylene±glycol type coolant. For information on
ethylene±glycol coolant, see also ªEngine coolant selectionº
described below.
If the coolant level drops within a short time after
replenishing, there may be a leak in the system. Visually
check the radiator, hoses, radiator cap, drain cock and water
pump.If you can find no leak, have your Lexus dealer test the cap
pressure and check for leaks in the cooling system.
CAUTION!
To prevent burning yourself, do not remove the
radiator cap when the engine is hot.
Engine coolant selection
Your coolant must contain ethylene±glycol antifreeze. In
addition to preventing freezing and subsequent damage to
the engine, this will also prevent corrosion. Further
supplemental inhibitors or additives are neither needed nor
recommended.
Read the antifreeze container for information on freeze
protection. Follow the manufacturer's directions for how
much to mix with water. The total capacity of the cooling
system is given on page 197. We recommend 50% solution
be used for your Lexus, or a sufficient quantity to provide
protection to about ±355C (±315F).
NOTICE
Do not use alcohol type antifreeze or plain water alone.