lock LEXUS ES300 2005 Repair Manual

E50573
I22117
Condition : Periodically cools and then fails to cool
- HEATER & AIR CONDITIONERREFRIGERANT
55-3
2618 Author
: Date
:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
2. INSPECT REFRIGERANT PRESSURE WITH MAN-
IFOLD GAUGE SET
(a) This is a method in witch the trouble is located by using
a manifold gauge set. Read the manifold gauge pressure
when the these conditions are established.
Test conditions:

Temperature at the air inlet with the switch set
at RECIRC is 30 - 35 °C (86 - 95 °F)

Engine running at 1,500 rpm

Blower speed control switch at ºHIº position

Temperature control dial at ºCOOLº position

A/C switch ON

Fully open doors
(1) Normally functioning refrigeration system.
Gauge reading:
Low pressure side:
0.15 - 0.25 MPa (1.5 - 2.5 kgf/cm
2)
High pressure side:
1.37 - 1.57 MPa (14 - 16 kgf/cm
2)
(2) Moisture present in refrigeration system.
SymptomProbable causeDiagnosisRemedy
During operation, pressure on low
pressure side sometimes become
a vacuum and sometime normal
Moisture in refrigerating system
freezes at expansion valve orifice
causing a temporary stop of cycle,
however, when it melts, normal
state is restored.
Drier in oversaturected state

Moisture in refrigerating system
freezes at expansion valve orifice
and blocks circulation of refriger-
ant(1) Replace condenser
(2) Remove moisture in cycle by
repeatedly evacuating air
(3) Supply proper amount of new
refrigerant

550DB-02
I03839
Push
SSTPull
Release
Lever
I06919
Screw
Driver Disconnect the
tube using hand
I31522
- HEATER & AIR CONDITIONERAIR CONDITIONING RADIATOR ASSY
55-17
2632 Author
: Date
:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
OVERHAUL
HINT:
COMPONENTS: See page 55-15
1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM (See page 55-8)
SST 07110-58060 (07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070,
07117-88080)
2. DISCONNECT COOLER REFRIGERANT SUCTION
HOSE NO.1
(a) Install SST to piping clamp.
SST 09870-00015
HINT:
Confirm the direction of the piping clamp claw and SST using
the illustration showing on the caution label.
(b) Push down SST and release the clamp lock.
NOTICE:
Be careful not to deform the tube, when pushing SST.
(c) Pull SST slightly and push the release lever, then remove
the piping clamp with SST.
(d) Disconnect the cooler refrigerant suction hose No. 1.
NOTICE:

Do not use tools like screwdriver to remove the tube.

Cap the open fittings immediately to keep moisture or
dirt out of the system.
3. DISCONNECT COOLER REFRIGERANT LIQUID PIPE A
SST 09870-00025
HINT:
Disconnect cooler refrigerant liquid pipe A in the same way as the cooler refrigerant suction hose No. 1.
4. DISCONNECT HEATER OUTLET WATER HOSE
(a) Using pliers, grip the claws of clip and slide the clip and
disconnect the heater outlet water hose.

I31636
I31637
I31497
55-18
- HEATER & AIR CONDITIONERAIR CONDITIONING RADIATOR ASSY
2633 Author
: Date
:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
5. DISCONNECT HEATER INLET WATER HOSE
HINT:
Disconnect in the same way as the heater outlet water hose.
6. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSY (See page 71-1 1)
HINT:
Refer to the instructions for removal of the instrument panel safety pad sub-assy.
7. REMOVE AIR DUCT REAR NO.1
(a) Remove the 2 screws, bolt and nut.
(b) Remove the air duct rear No. 1.
8. REMOVE AIR DUCT REAR NO.2
(a) Remove the 2 screws, bolt and nut.
(b) Remove the air duct rear No. 2.
9. REMOVE CONSOLE BOX DUCT NO.1
(a) Remove the clip and console box duct No. 1.
10. DISCONNECT FLOOR SHIFT PARKING LOCK CABLE ASSY
11. REMOVE WINDSHIELD WIPER RELAY ASSY
12. REMOVE HEADLAMP LEVELING ECU ASSY

I31766
I315812 Clamps
I31501
I31502
I317682 Clamps
- HEATER & AIR CONDITIONERAIR CONDITIONING RADIATOR ASSY
55-19
2634 Author
: Date
:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
13. REMOVE INSTRUMENT PANEL BRACE SUB-ASSY
NO.1
(a) Remove the bolt and earth wire.
(b) Release the 2 clamps.
(c) Remove the bolt and screw.
(d) Remove the nut and instrument panel brace sub-assy
No. 1.
14. REMOVE INSTRUMENT FINISH PANEL RETAINER
LOWER
(a) Remove the 2 bolts and instrument finish retainer lower.
15. REMOVE INSTRUMENT PANEL BRACE SUB-ASSY
NO.2
(a) Remove the 2 clamps, nut and passenger side junction
block.

I31767
I31504
I31499
I31500
I31505
55-20
- HEATER & AIR CONDITIONERAIR CONDITIONING RADIATOR ASSY
2635 Author
: Date
:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
(b) Remove the 2 bolts and 2 earth wires.
(c) Remove the 2 nuts, bolt and instrument panel brace sub-
assy No. 2.
16. REMOVE HEATER TO FOOT DUCT NO.3
(a) Remove the clip and heater to foot duct No. 3.
17. REMOVE HEATER TO FOOT DUCT NO.1
(a) Remove the clip and heater to foot duct No. 1.
18. DISCONNECT STEERING COLUMN ASSY
(a) Remove the 3 nuts and driver side junction block.

I31577
I315062 Clamps
I3176910 Clamps
- HEATER & AIR CONDITIONERAIR CONDITIONING RADIATOR ASSY
55-21
2636 Author
: Date
:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
(b) Remove the 2 nuts and steering side connector block.
(c) Release the 2 clamps.
(d) Remove the 3 bolts, disconnect the steering column assy.
19. REMOVE INSTRUMENT PANEL REINFORCEMENT
(a) Disconnect the 10 clamps and the wire harness.

I31577
I31505
I31504
I31767
I317682 Clamps 55-30
- HEATER & AIR CONDITIONERAIR CONDITIONING RADIATOR ASSY
2645 Author
: Date
:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
(c) Install the steering side connector block with the 2 nuts.
(d) Install the driver side junction block with the 3 nuts.
Torque: 8.4 NVm (85 kgfVcm, 73 in.Vlbf)
38. INSTALL INSTRUMENT PANEL BRACE SUB-ASSY
NO.2
(a) Install the instrument panel brace sub-assy No. 2 with the
2 nuts and bolt.
(b) Install the 2 earth wires with the 2 bolts.
Torque: 8.4 NVm (85 kgfVcm, 73 in.Vlbf)
(c) Install the passenger side junction block with the nut and
2 clamps.
Torque: 8.4 NVm (85 kgfVcm, 73 in.Vlbf)

550DH-02
I31635
Radiator Support Upper
O-ring

Cooler Condenser Assy
Cooler Dryer
Filter
Cap
9.8 (100, 85 in.Vlbf)
Non-reusable parts Compressor oil ND-OIL 8 or equivalent
9.8 (100, 85 in.Vlbf)
O-ring
5.4 (55, 47 in.Vlbf)
O-ring

12 (125, 9)


Air Cleaner Inlet No. 1
Air Cleaner Inlet Assy
NVm (kgfVcm, ftVlbf): Specified torque
Radiator Lower Air Deflector
Hood Lock Release Lever
Protector
55-44
- HEATER & AIR CONDITIONERCOOLER CONDENSER ASSY
2659 Author
: Date
:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
COMPONENTS

0103B-07
Z11554
Seal Lock Adhesive 01-4
- INTRODUCTIONREPAIR INSTRUCTION FOR AUTOMATIC
TRANSAXLE REPAIR MANUAL
4 Author
: Date
:
U151E, U151F A/T REPAIR MANUAL (RM1021U)
REPAIR INSTRUCTION FOR AUTOMATIC TRANSAXLE
REPAIR MANUAL
PRECAUTION
1. BASIC REPAIR HINT
(a) PRECOATED PARTS
(1) Precoated parts are bolts, nuts, etc. that are coated
with a seal lock adhesive at the factory.
(2) If a precoated part is retightened, loosened or
caused to move in any way, it must be recoated with
the specified adhesive.
(3) When reusing precoated parts, clean off the old
adhesive and dry with compressed air. Then apply
the specified seal lock adhesive to the bolt, nut or
threads.
NOTICE:
Do the torque checking with the lower limit value of the torque tolerance.
(4) Depending on the seal lock agent to apply, there may be a case where it is necessary to leave
it for a specified time until it hardens.
(b) GASKETS
When necessary, use a sealer on gaskets to prevent leaks.
(c) BOLTS, NUTS AND SCREWS
Carefully observe all specifications for bolt tightening torques. Always use a torque wrench.

0305L-1 1
03-8
- SERVICE SPECIFICATIONSAUTOMATIC TRANSMISSION / TRANSAXLE
24 Author
: Date
:
U151E, U151F A/T REPAIR MANUAL (RM1021U)
TORQUE SPECIFICATION
Part TightenedNVmkgfVcmftVlbf
Differential gear lube apply tube x Transaxle housing9.810087 in.Vlbf
Front planetary gear lock nut210-3502141-3569155-258
Brake apply tube clamp x Transaxle case5.45548 in.Vlbf
Transaxle case No. 1 plug x Transaxle rear cover7.47565 in.Vlbf
Transaxle rear cover x Transaxle case Bolt A
Other bolt19
25190
25014
18
Pawl shaft clamp x Transaxle case9.810087 in.Vlbf
Oil pump assy x Transaxle case2222616
Transaxle housing x Transaxle case Bolt A
Bolt B
Bolt C
Bolt D25
33
29
22255
337
295
22618
24
21
16
Automatic transmission case plug x Transaxle housing7.47565 in.Vlbf
Automatic transmission case plug x Transaxle case7.47565 in.Vlbf
Parking lock pawl bracket x Transaxle case2020515
Manual detent spring x Transaxle case Bolt A
Bolt B20
12205
12015
9
Transmission wire x Transaxle housing5.45548 in.Vlbf
Transmission valve body x Transaxle case1111 08
ATF temperature sensor clamp x Transmission valve body6.66758 inVlbf
Valve body oil strainer assy x Transmission valve body1111 08
Automatic transaxle oil pan sub-assy x Transaxle case7.88069 in.Vlbf
Drain plug x Automatic transaxle oil pan sub-assy4950036
Speed sensor x Transaxle case1111 58
Oil cooler tube union x Transaxle case Union
Elbow27
27276
27620
20
Park/neutral start switch x nut6.97061 in.Vlbf
Park/neutral start switch x Bolt5.45548 in.Vlbf
Park/neutral start switch x Control shaft lever131309
Speedometer driven hole cover sub-assy x Transaxle case6.97061
Oil pump body x Stator shaft assy9.810087 in.Vlbf
Line pressure control solenoid assy x Transmission valve body assy6.66758 in.Vlbf
Shift solenoid valve SL1x Transmission valve body assy6.66758 in.Vlbf
Shift solenoid valve SL2x Transmission valve body assy10.811 08
Shift solenoid valve SL3x Transmission valve body assy6.66758 in.Vlbf
Shift solenoid valve S4x Transmission valve body assy10.811 08
Shift solenoid valve DSL x Transmission valve body assy10.811 08
Front differential case x Front differential ring gear95.197070