engine Lexus GS250 2014 Owner's Manual

Page 627 of 688

6277-2. Steps to take in an emergency
7
When trouble arises
GS350_250_OM_OM30E16E_(EE)
CAUTION
■When inspecting under the hood of your vehicle
Observe the following precautions.
Failure to do so may result in serious injury such as burns.
●If steam is seen coming from under the hood, do not open the hood until the
steam has subsided. The engine compartment may be very hot.
●Keep hands and clothing (especially a tie, a scarf or a muffler) away from the fans
and belts. Failure to do so may cause the hands or clothing to be caught, resulting
in serious injury.
NOTICE
■When adding engine coolant
Add coolant slowly after the engine has cooled down sufficiently. Adding cool
coolant to a hot engine too quickly can cause damage to the engine.
■To prevent damage to the cooling system
Observe the following precautions:
●Avoid contaminating the coolant with foreign matter (such as sand or dust etc.).
●Do not use any coolant additives.
●Do not loosen the coolant inlet cap or the
coolant reservoir cap while the engine and
radiator are hot.
High temperature steam or coolant could
spray out.
GS350_250_OM_OM30E16E_(EE).book Page 627 Tuesday, July 8, 2014 7:11 PM

Page 628 of 688

6287-2. Steps to take in an emergency
GS350_250_OM_OM30E16E_(EE)
If the vehicle becomes stuck
Stop the engine. Set the parking brake and shift the shift lever to P.
Remove the mud, snow or sand from around the rear wheels.
Place wood, stones or some other material under the rear wheels to
help provide traction.
Restart the engine.
Shift the shift lever to D or R and release the parking brake. Then, while
exercising caution, depress the accelerator pedal.
■When it is difficult to free the vehicle
Carry out the following procedures if the tires spin or the vehicle
becomes stuck in mu d, dirt or snow:
Press to turn off TRC. ( →P. 3 2 2 )
1
2
3
4
5
GS350_250_OM_OM30E16E_(EE).book Page 628 Tuesday, July 8, 201 4 7:11 PM

Page 633 of 688

633
8
8-1. Specifications
Vehicle specifications
GS350_250_OM_OM30E16E_(EE)
■Vehicle identification number
The vehicle identification number (VIN) is the legal identifier for your
vehicle. This is the primary identification number for your Lexus. It is
used in registering the ownership of your vehicle.
This number is stamped on the top left of the instrument panel and in
the engine compartment.
This number is also on the manu-
facturer’s label.
■Engine number
The engine number is stamped
on the engine block as shown.
Vehicle identification
GS350_250_OM_OM30E16E_(EE).book Page 633 Tuesday, July 8, 201
4 7:11 PM

Page 634 of 688

6348-1. Specifications
GS350_250_OM_OM30E16E_(EE)
Engine
GS250GS350
Model4GR-FSE2GR-FSE
Ty p e6-cylinder V type, 4-cycle, gasoline
Bore and stroke83.0 × 77.0 mm
(3.27 × 3.03 in.)94.0 × 83.0 mm
(3.70 × 3.27 in.)
Displacement2500 cm3 (152.6 cu.in.)3456 cm3 (210.9 cu.in.)
Valve clearanceAutomatic adjustmentDrive belt tension
Fuel
Fuel type
EU area:
Unleaded gasoline conforming to European stan-
dard EN228 only
Except EU area:
Unleaded gasoline only
Research Octane Num-
ber95 or higher
Fuel tank capacity
(Reference)66 L (17.4 gal., 14.5 Imp.gal.)
GS350_250_OM_OM30E16E_(EE).book Page 634 Tuesday, July 8, 201 4 7:11 PM

Page 635 of 688

635
8
8-1. Specifications
Vehicle specifications
GS350_250_OM_OM30E16E_(EE)
*: The engine oil capacity is a reference quantity to be used when changing the
engine oil. Warm up and turn off the engine, wait more than 5 minutes, and check
the oil level on the dipstick.
■Engine oil selection (GS250)
XEU area, Nordic countries, Russia, Ukraine, Macedonia, Israel
“Toyota Genuine Motor Oil” is used in your Lexus vehicle. Lexus rec-
ommends the use of approved “Toyota Genuine Motor Oil”. Another
motor oil of matching quality can also be used.
Oil grade:
0W-20, 5W-20, 5W-30 and 10W-30:
API grade SL “Energy-Conserving”, SM “Energy-Conserving” or SN
“Resource-Conserving”; or ILSAC multigrade engine oil
15W-40 and 20W-50:
API grade SL, SM or SN multigrade engine oil
Lubrication system
GS250GS350
Oil capacity
(Drain and refill  reference
*)
With filter6.2 L
(6.6 qt., 5.5 Imp.qt.)6.4 L
(6.8 qt., 5.6 Imp.qt.)
Without filter5.9 L
(6.2 qt., 5.2 Imp.qt.)6.0 L
(6.3 qt., 5.3 Imp.qt.)
GS350_250_OM_OM30E16E_(EE).book Page 635 Tuesday, July 8, 201 4 7:11 PM

Page 636 of 688

6368-1. Specifications
GS350_250_OM_OM30E16E_(EE)
Recommended viscosity (SAE):
SAE 0W-20 is filled into your
Lexus vehicle at manufacturing,
and the best choice for good fuel
economy and good starting in
cold weather.
If SAE 0W-20 oil is not available,
SAE 5W-30 oil may be used.
However, it should be replaced
with SAE 0W-20 at the next oil
change.
If you use SAE 10W-30 or a
higher viscosity engine oil in
extremely low temperatures, the
engine may become difficult to
start, so SAE 0W-20, 5W-20 or
5W-30 engine oil is recom-
mended.
Oil viscosity (0W-20 is explained here as an example):
• The 0W in 0W-20 indicates the characteristic of the oil which allows
cold startability. Oils with a lower value before the W allow for easier
starting of the engine in cold weather.
• The 20 in 0W-20 indicates the viscosity characteristic of the oil when the oil is at high temperature. An oil with a higher viscosity (one
with a higher value) may be better suited if the vehicle is operated at
high speeds, or under extreme load conditions.
Temperature range anticipated
before next oil change Preferred
GS350_250_OM_OM30E16E_(EE).book Page 636 Tuesday, July 8, 201
4 7:11 PM

Page 638 of 688

6388-1. Specifications
GS350_250_OM_OM30E16E_(EE)
XExcept EU area, Nordic countries, Russia, Ukraine, Macedonia,
Israel
“Toyota Genuine Motor Oil” is used in your Lexus vehicle. Lexus rec-
ommends the use of approved “Toyota Genuine Motor Oil”. Another
motor oil of matching quality can also be used.
Oil grade:
5W-30 and 10W-30:
API grade SL “Energy-Conserving”, SM “Energy-Conserving” or SN
“Resource-Conserving”; or ILSAC multigrade engine oil
15W-40 and 20W-50:
API grade SL, SM or SN multigrade engine oil
Recommended viscosity (SAE):
If you use SAE 10W-30 or a
higher viscosity engine oil in
extremely low temperatures, the
engine may become difficult to
start, so SAE 5W-30 engine oil is
recommended.
Oil viscosity (10W-30 is explained here as an example): • The 10W in 10W-30 indicates the characteristic of the oil which allows cold startability. Oils with a lower value before the W allow for
easier starting of the engine in cold weather.
• The 30 in 10W-30 indicates the viscosity characteristic of the oil
when the oil is at high temperature. An oil with a higher viscosity (one
with a higher value) may be better suited if the vehicle is operated at
high speeds, or under extreme load conditions.
Temperature range anticipated
before next oil change
GS350_250_OM_OM30E16E_(EE).book Page 638 Tuesday, July 8, 201 4 7:11 PM

Page 640 of 688

6408-1. Specifications
GS350_250_OM_OM30E16E_(EE)
■Engine oil selection (GS350)
“Toyota Genuine Motor Oil” is used in your Lexus vehicle. Lexus rec-
ommends the use of approved “Toyota Genuine Motor Oil”. Another
motor oil of matching quality can also be used.
Oil grade:
0W-20, 5W-20, 5W-30 and 10W-30:
API grade SL “Energy-Conserving”, SM “Energy-Conserving” or SN
“Resource-Conserving”; or ILSAC multigrade engine oil
15W-40 and 20W-50:
API grade SL, SM or SN multigrade engine oil
Recommended viscosity (SAE):
SAE 0W-20 is filled into your
Lexus vehicle at manufacturing,
and the best choice for good fuel
economy and good starting in
cold weather.
If SAE 0W-20 oil is not available,
SAE 5W-30 oil may be used.
However, it should be replaced
with SAE 0W-20 at the next oil
change.
If you use SAE 10W-30 or a
higher viscosity engine oil in
extremely low temperatures, the
engine may become difficult to
start, so SAE 0W-20, 5W-20 or
5W-30 engine oil is recom-
mended.
Temperature range anticipated
before next oil changePreferred
GS350_250_OM_OM30E16E_(EE).book Page 640 Tuesday, July 8, 201
4 7:11 PM

Page 641 of 688

641
8
8-1. Specifications
Vehicle specifications
GS350_250_OM_OM30E16E_(EE)
Oil viscosity (0W-20 is expla
ined here as an example):
• The 0W in 0W-20 indicates the characteristic of the oil which allows cold startability. Oils with a lower value before the W allow for easier
starting of the engine in cold weather.
• The 20 in 0W-20 indicates the viscosity characteristic of the oil when the oil is at high temperature. An oil with a higher viscosity (one
with a higher value) may be better suited if the vehicle is operated at
high speeds, or under extreme load conditions.
How to read oil container labels:
Either or both API registered marks are added to some oil containers
to help you select the oil you should use. API Service Symbol
Top portion: “API SERVICE SN”
means the oil quality designation by
American Petroleum Institute
(API).
Center portion: “SAE 0W-20”
means the SAE viscosity grade.
Lower portion: “Resource-Con-
serving” means that the oil has fuel-
saving and environmental protec-
tion capabilities.
ILSAC Certification Mark
The International Lubricant Specifi-
cation Advisory Committee
(ILSAC) Certification Mark is dis-
played on the front of the container.
1
2
GS350_250_OM_OM30E16E_(EE).book Page 641 Tuesday, July 8, 201 4 7:11 PM

Page 644 of 688

6448-1. Specifications
GS350_250_OM_OM30E16E_(EE)
Your Lexus vehicle is filled with “Toyota Genuine Differential Gear Oil” at the fac-
tory.
Use Lexus approved “Toyota Genuine Differential Gear Oil” or an equivalent of
matching quality to satisfy the above specification. Please contact any authorized
Lexus dealer or repairer, or another duly qualified and equipped professional for fur-
ther details.
*: Minimum pedal clearance when depressed with a force of 500 N (51.0 kgf,112.4 lbf) while the engine is running.
Front differential (AWD models)
Oil capacity 0.70 L (0.74 qt., 0.62 Imp.qt.)
Oil type and viscosity
Hypoid gear oil API GL-5
Above -18 °C (0 °F): SAE90
Below -18 °C (0 °F): SAE80W or SAE80W-90
Rear differential
Oil capacityGS2501.15 L (1.22 qt., 1.01 Imp.qt.)
GS3501.35 L (1.43 qt., 1.19 Imp.qt.)
Oil type and viscosityToyota Genuine Differential gear oil LT
75W-85 GL-5 or equivalent
Brakes
Pe d a l
clearance
*
2WD115 mm (4.5 in.) Min.
AW D126 mm (5.0 in.) Min.
Pedal free play1.0 — 2.0 mm (0.04 — 0.08 in.)
Fluid typeSAE J1703 or FMVSS No. 116 DOT 3,
SAE J1704 or FMVSS No. 116 DOT 4
Steering
Free playLess than 30 mm (1.2 in.)
GS350_250_OM_OM30E16E_(EE).book Page 644 Tuesday, July 8, 201 4 7:11 PM

Page:   < prev 1-10 ... 151-160 161-170 171-180 181-190 191-200 201-210 211-220 next >