CD player Lexus GX470 2003 Basic Functions / LEXUS 2003 GX470 (OM60A45U) Owner's Guide

AUDIO
245
Compact disc player operation
(a) Playing a compact disc
Using joy stick and the “ENT” button to select the compact
disc mode.
“CD” appears on the display.
The discs set in the player are played continuously, starting
with the last disc you inserted. The disc number of the disc
currently being played, the track number and the time from the
beginning of the program appear on the display.
When play of one disc ends, the first track of the following disc
starts. When play of the final disc ends, play of the first disc
starts again.
The player will skip any empty disc trays. (b) Selecting a desired disc
Searching for a desired disc:
Push the “” and “”
(DISC/CH/PROG) button to select the disc number.
Push the button several times until the desired disc number
appears on the display. When you release the button, the
player will start playing the selected disc from the first track.

AUDIO
246(c) Selecting a desired track
To select a desired track: Push the “” or “”
(TUNE/TRACK) button until the number of the track you want
to listen to appears on the screen. If you want to return to the
beginning of the current track, quickly push the “
”
(TUNE/TRACK) button one time.
“Fast forward” button: Push the “
” (TUNE/TRACK) and
hold it to fast forward the disc. When you release the button,
the compact disc player will resume playing from that position.
“Reverse” button: Push the “
” (TUNE/TRACK) and hold
it to reverse the disc. When you release the button, the
compact disc player will resume playing.
Replacing controller battery
For replacement, use a CR2025 lithium battery or equivalent.
CAUTION
Special care should be taken that small children do not
swallow the removed battery or components.
NOTICE
 When replacing the battery, be care ful not to lose the
components.
 Replace only with the same or equivalent type of
battery recommended by a Lexus dealer.
 Dispose of used batteries according to local
regulations.

AUDIO
248
DVD player operation
The DVD player can play audio CDs, DVD video discs, CD
texts, dtsCDs and video CDs.
For appropriate discs for this player, see “Car audio/video
system operating hints” on page 289.
The DVD player works when the ignition key is in the “ACC” or
“ON” position.
To turn on the DVD player, a disc must be loaded in the player.
To turn off the player, eject the disc.
(a) Inserting the disc
1. Push the center of the rear console box lid.
2. Push this button to open the cover.
3. Pull the lid forward to pen the DVD player.

AUDIO
249
4. Insert a disc with the label side backward and close the
lid.
The player is intended for the use with 12 cm (4.7 in.) discs only.
If the label faces down, the disc cannot be played. In this case,
“DISC CHECK” appears on the screen.
If a disc which is not playable is inserted, “DISC CHECK” will
also appear on the screen. For appropriate discs for this
player, see “Car audio/video system operating hints” on page
289.The indicator light turns on while the disc is loaded.
CAUTION
To reduce the chance of injury in case of an accident or
a sudden stop, always keep the console box closed
while driving.
NOTICE
Never try to disassemble or oil any part of the DVD
player. Do not insert anything other than a disc into the
slot.
5. Close the cover and console box.

AUDIO
250(b) Ejecting the disc
Pull
the lid forward to open the DVD player. Push the disc
eject button to eject a disc.NOTICE
Do not place anything on the opened cover. It could
damage the cover.

AUDIO
252(d) DVD player operation switches
The DVD player can be operated with the controller
buttons directly.
The player can also be operated with the switches on the
screen.
To operate the switches on the screen, select the switch by the
joy stick and push the “ENT” button. You cannot select the
switches on the screen by touching them directly.
When the switch is selected by the joy stick, the outline of the
switch
changes to blue. Push the “ENT” button, and the switch
will be highlighted in green.

AUDIO
256
DVD video/DVD audio player operation
NOTE: The playback condition of some DVD video discs
may be determined by the DVD video software producer.
This DVD player plays discs as the software producer
intended. Therefore, some functions may not work
properly. Be sure to read the instruction manual for the
DVD video disc separately provided. For detailed
information about DVD video discs, see “DVD video disc
information” on page 283.
Precautions for DVD video discs
When recording on a DVD video, DVD audio, video CD or
audio tracks may not record in some cases while the menu is
displayed. As audio will not play in this case, verify that the
video tracks are playing and then activate playback.
The title/chapter number and playback time display may not
appear while playing back certain DVD video discs.
CAUTION
Conversational speech on some DVDs is recorded at a
low volume to emphasize the impact of sound effects.
If you adjust the volume assuming that the
conversations represent the maximum volume level
available for the DVD, you may be startled by louder
sound effects or when you change to a different audio
source. Loud sounds may have a significant impact on
the human body or pose a driving hazard. Keep this in
mind when you adjust the volume.
(a) Turning the menu screen for the disc on or off
22PY059
 1 For DVD video2 For DVD audio3 Controller button

AUDIO
260To skip to the predetermined screen, push the “Return”
switch on the screen or the “RETURN” button on the
controller. The DVD player starts playing from the
beginning of the predetermined screen.
For further details of the predetermined screen, see the
separate manual for the DVD disc.
(d) Selecting the title/group
22PY064

1 For DVD video2 For DVD audio3 Controller button

AUDIO
261
To display the searching title (DVD video) or group (DVD
audio) screen, push the “Search” switch on
the screen or
the “SEARCH” button on the controller.
 1 For DVD video2 For DVD audio
DVD video: Select the title number by using the “”, “+”
and “+10” switches and push the “Enter” switch to enter
the number. The player starts playing disc for that title
number. The selected title number will appear on the
screen.
Push the “Back” switch to return to the menu screen.
DVD audio: Enter the group number by using the “” and
“+” switches. The selected group number will appear on
the screen. Push the “Enter” switch. The player starts
playing the disc from the entered group number.
Push the “Back” switch to return to the previous screen. (e) Selecting the bonus group (DVD audio only)
Enter the bonus group number on the searching group
screen and push the “Enter” switch on the screen. The
“Enter
Key Code” screen will appear. To enter the number
of the group you want to play, push the group number.
If you enter the wrong number, push the “Clear” switch on the
screen to delete the number.
Push the “Enter” switch on the screen. The player starts
playing the disc from the selected bonus group number.

AUDIO
266Push the “Set Up” switch on the screen or the “SET UP”
button on the
controller, and the initial setting screen will
appear. You can change the initial setting.
After the setting is done, the player plays from the beginning
of the chapter or the track.
There are initial setting switches on the “Setup Menu 1”
screen ( 1 ) and “Setup Menu 2” screen ( 2 ).
To change the screen, push the “Top Page” or “Second Page”
switch on the screen.
After you change the initial setting, push the “Enter” switch.
The initial setting switch will be turned off and return to the
picture previously.
When the “Initial Setting” switch on “Setup Menu 2” is pushed,
all menus are initialized. (k) Changing the audio language
Push the “Audio Lang.” switch on the “Setup Menu 1”
screen ( 1 ) and the “Select Audio Language” screen
( 2 ) appear.
Select the language you want to hear on the screen.
To return to the “Setup Menu 1” screen, push the “Back” switch.
If you cannot find a language you want to hear, push the
“Others” switch. The “Enter Audio Lang. Code” screen will
appear.