steering wheel Lexus IS250 2014 Navigation Manual

295
1. LEXUS PARKING ASSIST MONITOR
PERIPHERAL MONITORING SYSTEM
IS300h/250_Navi_EE
6
1Shift the shift lever to the “R” position.
2Back up until the parking assist guide
line meets the edge of the left-hand di-
viding line of the parking space.
XParking assist guide line
Parking space dividing line
3Turn the steering wheel all the way to
the right, and back up slowly.
4Once the vehicle is parallel with the
parking space, straighten the steering
wheel and back up slowly until the vehi-
cle has completely entered the parking
space.
5Stop the vehicle in an appropriate place,
and finish parking.
PARKING
When parking in a space which is in the
reverse direction to the space described
in the procedure below, the steering di-
rections will be reversed.
IS_Navi_EE_53C71E.book 295 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

296
1. LEXUS PARKING ASSIST MONITOR
IS300h/250_Navi_EE
4. PARALLEL PARKING
VEHICLE MOVEMENT PROCEDURE
<Operation details> <Vehicle movement>
Keeping parallel with the road, stop the vehicle leav-
ing a gap of approximately 3 ft. (1 m) between your
vehicle and the parked vehicle. [PARKING] : STEP 1
Back up until the black and yellow vertical pole just
overlaps the rear end of the parked vehicle. Then
stop the vehicle. [PARKING] : STEP 4
Leaving the vehicle stopped, move the steering
wheel until the blue outline meets the desired park-
ing space, and back up while keeping the steering
wheel in that position. [PARKING] : STEP 5
A curved blue line is displayed. Keep the steering
wheel in the same position and back up until the
curved blue line meets the right corner of the park-
ing space. [PARKING] : STEP 7
When it meets the right corner of the parking space,
turn the steering wheel in the opposite direction as
far as it will go. [PARKING] : STEP 8
Keeping the steering wheel in that position, check
your surroundings visually and using mirrors, and
back up using the distance guide lines etc. as a refer-
ence. [PARKING] : STEP 9
When the vehicle is approximately in the desired
parking location, parallel parking assist is complete.
[PARKING] : STEP 10
CAUTION
●Do not use the system if the display is incorrect due to an uneven (curvy/hilly) road or a non-
straight road.
●Make sure to operate the steering wheel only when the vehicle is stopped.
XApprox. 3 ft. (1 m)
IS_Navi_EE_53C71E.book 296 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

298
1. LEXUS PARKING ASSIST MONITOR
IS300h/250_Navi_EE
2Shift the shift lever to the “R” position.
3Make sure the monitor displays the part
behind the rear tyres of the parked vehi-
cle, and select .
zIf the area is not displayed, move the vehicle
to forward.
4With the steering wheel straight, back
up slowly to a position at which the black
and yellow vertical pole just overlaps the
rear end of the parked vehicle. Then
stop the vehicle.
XBlack and yellow vertical pole
Back the vehicle up to here
5Turn the steering wheel with the vehicle
stopped until the blue outline meets the
desired parking space.
zIf the extended line from the blue outline is
displayed, the parallel parking assist is
operational.
XBlue outline
Black and yellow vertical pole
Extended line
IS_Navi_EE_53C71E.book 298 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

299
1. LEXUS PARKING ASSIST MONITOR
PERIPHERAL MONITORING SYSTEM
IS300h/250_Navi_EE
6
XTurn the steering wheel right
Black and yellow vertical pole
Blue outline
NOTICE
●Be sure to check that there are no obsta-
cles inside the blue outline.
If there are any obstacles inside the blue
outline, do not use the parallel parking
assist.
●When positioning the blue outline over
the parking space, be sure to position it
so that the extended blue line may not
cross the tyre of the vehicle parked in
front of the empty space.
●If the extended line of the blue outline is
crossing the parked vehicle, your vehicle
may be too close. Check that there is a
gap of approximately 3 ft. (1 m) between
your vehicle and the parked vehicle.
XExtended line overlapping wheel
IS_Navi_EE_53C71E.book 299 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

300
1. LEXUS PARKING ASSIST MONITOR
IS300h/250_Navi_EE
6Keep the steering wheel in its current
position and backing up.
zThe parallel parking assist will be canceled
if the steering wheel is moved while back-
ing up. Shift the shift lever out of the “R”
position, and restart from the procedure 1.
7A curved blue line will appear on the
screen. Keep the steering wheel in its
current position and back up slowly.
Stop when the curved blue line meets
the corner of the desired parking space.
XCurved blue line
NOTICE
●When backing up, be careful not to hit
any obstacles with your vehicle. Back the
vehicle up slowly.
IS_Navi_EE_53C71E.book 300 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

301
1. LEXUS PARKING ASSIST MONITOR
PERIPHERAL MONITORING SYSTEM
IS300h/250_Navi_EE
6
XBack up keeping the steering wheel in its
current position
Curved blue line
Curved blue line meets the corner here
zIf you back up too quickly, you may lose
synchronization with the parallel parking
assist.
8Leaving the vehicle stopped, turn the
steering wheel all the way to the left.
zBe sure to turn the steering wheel only
when the vehicle is stopped.
9When the screen changes, keep the
steering wheel in its current position and
back up.
10When the vehicle is parallel with the
road or the shoulder, straighten the
steering wheel.
Check your surroundings visually and
with the mirrors, then back up using the
distance guide lines as a reference, and
stop.
zWhen the vehicle is approximately in the
desired parking location, the parallel park-
ing assist is complete.
NOTICE
●When backing up, be careful not to hit
any obstacles with your vehicle. Back the
vehicle up slowly.
INFORMATION
●There is a possibility that parallel parking
guidance may not be given when backing
up at a very slow speed.
●If the trunk is opened, the parallel parking
assist will be discontinued halfway.
IS_Navi_EE_53C71E.book 301 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

302
1. LEXUS PARKING ASSIST MONITOR
IS300h/250_Navi_EE
1Select .
zIf the Lexus parking assist-sensor detects
an object while you attempt to park in a
parking space on the left, the black and yel-
low vertical pole could be obscured by the
Lexus parking assist-sensor display. In this
event, turn the Lexus parking assist-sensor
switch off (→P.312), and operate the vehi-
cle while checking the safety of the sur-
rounding area direct visually and with
mirror. After the operation, turn the switch
on.
zThe steering wheel has been turned too far,
and the system cannot function. Return the
steering wheel to its original position.
zIf the message is displayed before the out-
line is positioned over the desired parking
space, it is likely that the vehicle is too far
away from the shoulder. Check that there is
a gap of approximately 3 ft. (1 m) between
your vehicle and the parked vehicle.
XNormal mode
Narrow mode
zIf the engine <power> switch is turned off
when the parking assist monitor is canceled
with narrow mode, the caution screen is
displayed first when the parallel parking
assist is selected next time.
CANCELING PARALLEL
PARKING ASSIST
VEHICLES EQUIPPED WITH
LEXUS PARKING ASSIST-
SENSOR
IF THE MESSAGE “Steering
wheel turned too far, please
return.” IS DISPLAYED
NARROW MODE
If the position the vehicle is to be parked
in is narrower than usual, narrow mode
can be used.
IS_Navi_EE_53C71E.book 302 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

311
1. LEXUS PARKING ASSIST MONITOR
PERIPHERAL MONITORING SYSTEM
IS300h/250_Navi_EE
6
The guide lines are very far
out of alignmentThe camera position is out of
alignment.Have the vehicle inspected by
any authorized Lexus dealer
or repairer, or another duly
qualified and equipped pro-
fessional.
•The vehicle is tilted. (There
is a heavy load on the vehi-
cle, tyre pressure is low due
to a tyre puncture, etc.)
•The vehicle is used on an
incline.If this happens due to these
causes, it does not indicate a
malfunction.
Back up while visually check-
ing the vehicle's surroundings.
The estimated course lines
move even though the steer-
ing wheel is straightThere is a malfunction in the
signals being output by the
steering sensor.Have the vehicle inspected by
any authorized Lexus dealer
or repairer, or another duly
qualified and equipped pro-
fessional.
Guide lines are not displayedThe trunk is open.Close the trunk.
If this does not resolve the
symptom, have the vehicle in-
spected by any authorized
Lexus dealer or repairer, or
another duly qualified and
equipped professional.
“System initialising.” is dis-
played•The 12-volt battery has
been reinstalled.
•The steering wheel has
been moved while the 12-
volt battery was being rein-
stalled.
•12-volt battery power is low.
•The steering sensor has
been reinstalled.
•There is a malfunction in the
signals being output by the
steering sensor.Stop the vehicle, and turn the
steering wheel as far as it will
go to the left and right.
If this does not resolve the
symptom, have the vehicle in-
spected by any authorized
Lexus dealer or repairer, or
another duly qualified and
equipped professional.
•On the system initialization
screen, select “?” to display
the operating procedure.
SymptomLikely causeSolution
IS_Navi_EE_53C71E.book 311 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

324
IS300h/250_Navi_EE
1. TELEPHONE OPERATION (HANDS-FREE SYSTEM FOR CELLULAR PHONES)
1. QUICK REFERENCE
The telephone top screen can be used to make a telephone call. To display this screen,
press the “MENU” button on the Remote Touch and select “Telephone”, or the
switch on the steering wheel.
FunctionPage
Telephone operation
Registering/connecting Bluetooth® device50
Calling on the Bluetooth® phone329
Receiving on the Bluetooth® phone337
Talking on the Bluetooth® phone338
Message functionUsing the Bluetooth® phone message function341
Setting up a telephone
Telephone settings347
Contact settings353
Bluetooth® settings56
IS_Navi_EE_53C71E.book 324 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

325
1. TELEPHONE OPERATION (HANDS-FREE SYSTEM FOR CELLULAR PHONES)
IS300h/250_Navi_EE
TELEPHONE
7
2. SOME BASICS
The hands-free system enables calls to
be made and received without having to
take your hands off the steering wheel.
This system supports Bluetooth
®.
Bluetooth® is a wireless data system
that enables cellular phones to be used
without being connected by a cable or
placed in a cradle.
The operating procedure of the tele-
phone is explained here.
CAUTION
●Use a cellular phone or connect the
Bluetooth® phone only when safe and
legal to do so.
●Your audio unit is fitted with Bluetooth
®
antennas. People with implantable car-
diac pacemakers, cardiac resynchroniza-
tion therapy-pacemakers or implantable
cardioverter defibrillators should main-
tain a reasonable distance between
themselves and the Bluetooth
® antennas.
The radio waves may affect the operation
of such devices.
●Before using Bluetooth
® devices, users
of any electrical medical device other
than implantable cardiac pacemakers,
cardiac resynchronization therapy-pace-
makers or implantable cardioverter
defibrillators should consult the manufac-
turer of the device for information about
its operation under the influence of radio
waves. Radio waves could have unex-
pected effects on the operation of such
medical devices.
NOTICE
●Do not leave your cellular phone in the
vehicle. The temperature inside may rise
to a level that could damage the tele-
phone.
INFORMATION
●If your cellular phone does not support
Bluetooth®, this system cannot function.
●In the following conditions, the system
may not function:
• The cellular phone is turned off.
• The current position is outside the com-
munication area.
• The cellular phone is not connected.
• The cellular phone has a low battery.
●When using Bluetooth
® audio and
hands-free system at the same time, the
following problems may occur:
•The Bluetooth
® connection may be cut.
• Noise may be heard on the Bluetooth
®
audio playback.
IS_Navi_EE_53C71E.book 325 ページ ２０１４年５月２９日　木曜日　午前１１時２２分