Lexus IS300 2003 Basic Functions / LEXUS 2003 IS300 OWNER'S MANUAL (OM53439U)

ENGINE
318
Oil identification marks
SOIL11

API Service Symbol
ILSAC Certification Mark
Either or both API registered marks are added to some oil
containers to help you select the oil you should use.
The API Service Symbol is located anywhere on the outside
of the container.
The top portion of the label shows the oil quality by API
(American Petroleum Institute) designation such as SL.
The center portion of the label shows the SAE viscosity
grade such as SAE 5W±30. ºEnergy±Conservingº, shown
in the lower portion, indicates that the oil has fuel±saving
capabilities.
 The ILSAC (International Lubricant Standardization and
Approval Committee) Certification Mark is displayed on the
front of the container. To ensure excellent lubrication performance for your engine,
the ºToyota Genuine Motor Oilº range is available, which has
been specifically tested and approved for all Lexus engines.
Please contact your Lexus dealer for further details of the
ºToyota Genuine Motor Oilº range.
2003 IS300 from Aug. '02 Prod. (OM53439U)

ENGINE
319
CHECKING THE ENGINE COOLANTLEVEL
SV62006

1Reservoir cap 2Upper line 3Lower line
Look at the see±through coolant reservoir when the
engine is cold. The coolant level is satisfactory if it is
between theºFULLº and ºLº lines on the reservoir. If the
level is low, add ethylene±glycol type coolant for a proper
corrosion protection of aluminum components.
The coolant level in the reservoir will vary with engine
temperature. However, if the level is on or below the ºLº line,
add coolant. Bring the level up to the ºFULLº line.
Always use ethylene±glycol type coolant for a proper corrosion
protection of aluminum components. See information in the
next column. If the coolant level drops within a short time after replenishing,
there
may be a leak in the system. V isually check the radiator,
hoses, engine coolant filler cap, radiator cap and drain cock
and water pump.
If you can find no leak, have your Lexus dealer test the cap
pressure and check for leaks in the cooling system.
CAUTION
To prevent burning yourself, do not remove the radiator
cap when the engine is hot.
Coolant type selection
Use of improper coolants may damage your engine cooling
system. Your coolant must contain ethylene±glycol type
coolant for a proper corrosion protection of your engine that
contains aluminum components. We have used ºToyota
Genuine Long Life Coolantº in your Lexus vehicle. In order to
avoid technical problems, we strongly recommend using
ºToyota Genuine Long Life Coolantº or equivalent.
In addition to preventing freezing and subsequent damage to
the engine, this type of coolant will also prevent corrosion.
Further supplemental inhibitors or additives are neither
needed nor recommended.
Read the coolant container for information on freeze
protection. Follow the manufacturer's directions for how much
to mix with plain water (preferably demineralized water or
distilled water). The total capacity of the cooling system is
given on page 310.
2003 IS300 from Aug. '02 Prod. (OM53439U)

ENGINE
320We recommend to use 50% solution for your Lexus, to provide
protection
down to about ±35 C (±31F). When it is extremely
cold, to provide protection down to about ±50C (±58F), 60%
solution is recommended. Do not use more than 70% solution
for better coolant performance.
NOTICE
Do not use alcohol type antifreeze or plain water alone.
The engine cooling system is integral to maximizing
performance of your Lexus vehicle. In line with this, it is
strongly recommended that you use ºToyota Genuine Long
Life Coolantº for protecting the system, as it is an
ethylene±glycol based premium antifreeze coolant with
excellent corrosion protection properties that has been
specifically formulated for use in Lexus vehicles.
Please contact your Lexus dealer for further details of the
ºToyota Genuine Long Life Coolantº range.
CHECKING THE RADIATOR AND CONDENSER
If either of the above parts are extremely dirty or you are not
sure of their condition, take you vehicle to Lexus dealer.
CAUTION
To prevent yourself from burning, be careful not to
touch the radiator or co ndenser when the engine is hot.
NOTICE
To prevent damage to the radiator and condenser, do
not perform the work by yourself.
2003 IS300 from Aug. '02 Prod. (OM53439U)

ENGINE
321
SPARK PLUGS
SV62007
Your engine is fitted with designated iridium±tipped spark
plugs.
NOTICE
Use only designated iridium±tipped spark plugs and donot adjust gaps for your engine performance andsmooth drivability.
2003 IS300 from Aug. '02 Prod. (OM53439U)

ENGINE
322
2003 IS300 from Aug. '02 Prod. (OM53439U)

SECTION 6 ± 3
323
SERVICE PROCEDURES AND
SPECIFICATIONS
Chassis
Specifications324
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . .
Checking brake fluid 329
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
.
Checking power steering fluid 330
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking tire pressure 331
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Rotating tires 333
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . .
Checking and replacing tires 335
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing snow tires and chains 338
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Replacing wheels 340
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . .
Aluminum wheel precautions 341
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Suspension and chassis 342
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2003 IS300 from Aug. '02 Prod. (OM53439U)

CHASSIS
324
SPECIFICATIONS
± MANUAL TRANSMISSIONOil capacity
2.6 L (2.7 qt., 2.3 lmp.qt.)
Oil typeMultipurpose gear oil API GL±4 or GL±5
Recommended oil viscositySAE 75W±90
± DIFFERENTIALOil capacity
1.15 L (1.22 qt., 1.01 lmp.qt.)
Oil typeHypoid gear oil API GL±5
Oil viscosityAbove ±18C (0F): SAE 90
Below ±18 C (0F): SAE 80W or SAE 80W±90
± AUTOMATIC TRANSMISSION
Fluid capacity Drain and refill
2.0 L (2.1 qt., 1.8 lmp.qt.)
Fluid typeToyota Genuine ATF Type T ± IV*
*Change automatic transmission fluid only as necessary.
Generally, it is necessary to change automatic transmission
fluid only if your vehicle is driven under one of the Special
Operating Conditions listed in your ºOwner's Manual
Supplement/Scheduled Maintenanceº. When changing the
automatic transmission fluid, use only ºToyota Genuine ATF
Type T±IVº ( ATF JWS3309 or NWS6500) to aid in assuring
optimum transmission performance.NOTICE
Using automatic transmission fluid other than ºToyota Genuine ATF Type T±IVº may cause deterioration inshift quality, locking up of your transmissionaccompanied by vibration, and ultimately damage theautomatic transmission of your vehicle.
2003 IS300 from Aug. '02 Prod. (OM53439U)

CHASSIS
325
± CLUTCH
Pedal freeplay
5 ± 15 mm (0.2 ± 0.6 in.)
Fluid typeSAE J1703 or FMVSS No. 116 DOT 3
± BRAKESPedal clearance *
199 mm (3.9 in.) Min.
Pedal free play1 ± 6 mm (0.04 ±0.24 in.)
Brake pad wear limit1.0 mm (0.04 in.)
Parking brake lining wear limit1.0 mm (0.04 in.)
Parking brake adjustment *25 ± 8 clicks
Fluid typeSAE J1703 or FMVSS No. 116 DOT 3
*1Minimum pedal clearance when depressed with the force of 490 N (49 kgf,\
110 lbf.) with the engine running
*
2Parking brake adjustment when pulled with the force of 196 N (20 kgf, 4\
4 lbf.)
± STEERING Free play
Less than 30 mm (1.2 in.)
Power steering fluidAutomatic transmission fluid DEXRONII or III
2003 IS300 from Aug. '02 Prod. (OM53439U)

CHASSIS
326± TIRES AND WHEELS (Type A)
Tire size Front
Rear
215/45ZR17
225/45ZR17
Tire inflation pressureRecommended cold tire inflation pressureFront 230 kPa (2.3 kgf/cm2 or bar, 33 psi)
Rear 240 kPa (2.4 kgf/cm2 or bar, 35 psi)
For sustained high speeds above 160 km/h (100 mph), in countries
where such speeds are permitted by law, add 70 kPa (0.8 kgf/cm
2, 0.7
bar, 10 psi) to the front tires and rear tires, but never exceed the
maximum cold tire pressure molded on the tire sidewall.
Wheel size Front
Rear17 x 7 JJ
17 x 7 1/2 JJ
Wheel nut torque103 N´m (10.5 kgf´m, 76 ft´lbf.)
Spare tire
Tire size215/45ZR17
Tire inflation pressure
Recommended cold tire inflation pressure240 kPa (2.4 kgf/cm2 or bar, 35 psi)
Wheel size17 x 7 JJ
Wheel nut torque103 N´m (10.5 kgf´m, 76 ft´lbf.)
NOTE: For complete information on tires (e.g. replacing tires or replacing wheels\
), see ºChecking tire pressureº through ºAluminum
wheel precautionsº on page 331 through 341.
2003 IS300 from Aug. '02 Prod. (OM53439U)

CHASSIS
327
± TIRES AND WHEELS (Type B)
Tire size
215/45ZR17
Tire inflation pressure Recommended cold tire inflation pressureFront 230 kPa (2.3 kgf/cm2 or bar, 33 psi)
Rear 230 kPa (2.3 kgf/cm2 or bar, 33 psi)
For sustained high speeds above 160 km/h (100 mph), in countries
where such speeds are permitted by law, add 70 kPa (0.8 kgf/cm
2, 0.7
bar, 10 psi) to the front tires and rear tires, but never exceed the
maximum cold tire pressure molded on the tire sidewall.
Wheel size17 x 7 JJ
Wheel nut torque103 N´m (10.5 kgf´m, 76 ft´lbf.)
NOTE: For complete information on tires (e.g. replacing tires or replacing wheels\
), see ºChecking tire pressureº through ºAluminum
wheel precautionsº on page 331 through 341.
2003 IS300 from Aug. '02 Prod. (OM53439U)