Lexus IS300 2005 Electrical Components / LEXUS 2005 IS300 OWNER'S MANUAL (OM53489U)

IN CASE OF AN EMERGENCY
284If jump starting is difficult, charge the battery for several
minutes.
2. If required, remove all the vent plugs from the booster
battery.
Lay a cloth over the open vents on the booster battery.
(This helps reduce the explosion hazard, personal injuries and
burns.)
If the booster battery is an extended maintenance interval
battery, it is not necessary to remove the vent plugs.
3. If the engine in the vehicle with the booster battery is not
running, start it and let it run for about 5 minutes. During jump
starting, run the engine at about 2000 rpm with the accelerator
pedal lightly depressed.
4. Locate positive (+) and negative (±) terminals of each
battery. Connect the jumper cables in the exact order (
1
2 3 4) shown in the illustration.
1Connect a positive (red) jumper cable clamp to the
positive (+) terminal of the discharged battery.
2Connect the clamp at the other end of the positive (red)
cable to the positive (+) terminal of the booster battery.
3Connect a negative (black) cable clamp to the negative
(±) terminal of the booster battery.
4Connect the clamp at the other end of the negative (black)
cable to a solid, stationary, unpainted metallic point (such
as shown in the illustration) away from the battery. Do not
connect it to or near any part that moves when the engine
is cranked.
CAUTION
When making the connections, to avoid serious injury,
do not lean over the battery or accidentally let the
jumper cables or clamps touch anything except the
correct battery terminals or the ground.
5. Start your engine in the normal way. After starting, run it at
about 2000 rpm for several minutes with the accelerator pedal
lightly depressed.
6. Carefully disconnect the cables in the exact reverse order:
the negative cable and then the positive cable.
7. Carefully dispose of the battery cover cloths which may
now contain sulfuric acid.
8. If removed, replace all the battery vent plugs.
If the cause of your battery discharging is not apparent (for
example, lights left on), you should have it checked at your
Lexus dealer.
If the first start attempt is not successful...
Check that the clamp on the jumper cables are tight. Recharge
the discharged battery with the jumper cables connected for
several minutes and restart your engine in the normal way.
If another attempt is not successful, the battery may be
depleted. Have it checked at your Lexus dealer.
04 06.30

IN CASE OF AN EMERGENCY
285
IF YOUR VEHICLE OVERHEATS
If your engine coolant temperature gauge indicates
overheating, if you experience a loss of power, or if you
hear a loud knocking or pinging noise, the engine has
probably overheated.
When the engine overheats
Pull safely off the road, stop the vehicle and turn on your
emergency flashers. Put the transmission in ªPº (automatic) or
neutral (manual) and apply the parking brake.
A: If steam is coming from your engine:
Turn off the engine. Leave the hood closed until there is no sign
of steam or coolant. Your engine could have been seriously
damaged already. Call your Lexus dealer for assistance.
CAUTION
To help avoid personal injury, keep the hood closed until
there is no steam. Escaping steam or coolant is sign of
very high pressure.
B: If no steam is coming from your engine:
Leave the engine running and turn off the air conditioning.
Check the following.
Is the cooling fan operating?
 Is the coolant in the acceptable range?
 Is the engine drive belt O.K.?
CAUTION
When the eng ine is running, keep hands and clothing
away from the moving fan and engine drive belt.
 Do not attempt to remove the radiator cap when the
engine and radiator are hot. Serious injury could
result from scalding hot fluid and steam blown out
under pressure.
If the cooling fan is not operating or the coolant is not in the
acceptable range, turn off the engine and call your Lexus
dealer.
If both conditions are O.K., after the engine coolant
temperature has cooled to normal, continue driving your
vehicle.
If the engine coolant temperature does not cool down, or your
vehicle overheats again, have it checked as soon as possible
by your Lexus dealer.
04 06.30

IN CASE OF AN EMERGENCY
286
IF YOU HAVE A FLAT TIRE
1. Reduce your speed gradually, keeping a straight line.
Move cautiously off the road to a safe place ± well away
from the traffic. Avoid stopping on the center divider of
a highway. Park on a level spot with firm ground.
2. Stop the engine and turn on your emergency flashers.
3. Firmly set the parking brake and put the transmission
in ªPº (automatic) or reverse (manual).
4. Have everyone get out of the vehicle on the side away
from traffic.
5. Read the following instructions thoroughly.
CAUTION
When jacking, be sure to observe the following to
reduce the possibility of personal injury:
 Follow jacking instructions.
 Do not put any part of your body under a vehicle
supported by a jack. Personal injury may occur.
 Do not start or run the engine while your vehicle
is supported by the jack.
Stop the vehicle on a level firm ground, firmly
set the parking brake and put the transmission
in ªPº (automatic) or reverse (manual). Block
the wheel diagonally opposite to the one being
changed if necessary.
 Make sure to set the jack properly in the jack
point. Raising the vehicle with jack improperly
positioned will damage the vehicle or may allow
the vehicle to fall off the jack and cause
personal injury.
 Never get under the vehicle when the vehicle is
supported by the jack alone.
 Use the jack only for lifting your vehicle during
wheel changing.
 Do not raise the vehicle with someone in the
vehicle.
 When raising the vehicle, do not put an object
on or under the jack.
 Raise the vehicle only high enough to remove
and change the tire.
NOTICE
Do not continue driving with a deflated tire.
Driving even a short distance can damage a tire
and wheel beyond repair.
04 06.30

IN CASE OF AN EMERGENCY
287
Compact spare tire (Some models)
SV64025
The compact spare tire is designed for temporary
emergency use only.
The compact spare tire is identified by the distinctive
wording ªTEMPORARY USE ONLYº molded into the
sidewall of the tire.
To keep the compact spare tire noticeable, do not hide
the wheel by a wheel cover or such.
The compact spare tire saves space in your luggage
compartment, and its lighter weight helps to improve fuel
economy and permits easier installation in case of a flat
tire. The compact spare tire can be used many times, if
necessary. It has tread life of up to 4800 km (3000 miles)
depending on road conditions and your driving habits.
When tread wear indicators appear on the tire, replace
the tire. (See ªChecking and replacing tiresº on page
368.)
CAUTION

The compact spare tire was designed especially
for your Lexus. Do not use it on any other
vehicle.
 Do not use more than one compact spare tire at
the same time.
 The pressure for the compact spare tire must be
420 Kpa (4.2 kgf/cm
2
or bar, 60 psi).
 Do not exceed 80 km/h (50 mph) when driving
with the compact spare tire.
 Replace the compact spare tire with the
standard tire as soon as possible.
 Avoid sudden acceleration, sudden
deceleration and sharp turns with the compact
spare tire.
04 06.30

IN CASE OF AN EMERGENCY
288
NOTICE
Your ground clearance is reduced when thecompact spare tire is installed so avoid driving
over obstacles and drive slowly on rough,unpaved roads and speed bumps. Also, do not
attempt to go through an automatic car wash asthe vehicle may get caught, resulting in damage.
Access to spare tire (SportCross)
SV41029
1. Pull up the deck board.
04 06.30

IN CASE OF AN EMERGENCY
289
SV41030
2. Take off the hook at the backside of the deck
board.
3. Lift up the back side of the board and secure the
board by hooking it at the top of the back door
opening with the hook at the edge of the strap.
Make sure the board is secured and does not fall down.
SV41034
When closing the board, replace the hook also in its
original position as shown.
NOTICE
If you close the back door with the board hooked,the hook may be damaged.
04 06.30

IN CASE OF AN EMERGENCY
290
Spare tire with turning direction indicators
(Some models)
SV41014
The spare tire with turning direction indicators is of
a uni±directional type and is intended for use on the
passenger side of the vehicle.
Installing the spare tire on the passenger side of the
vehicle will not affect tire performance. However, if the
spare tire is used on the driver side of the vehicle, it
should be used only temporarily and then replaced with
the correct one.
CAUTION
SportCross:
 The spare tire was designed especially for your
Lexus. Do not use it on any other vehicle.
 Do not use more than one spare tire at the same
time.
 Do not exceed 80 km/h (50 mph) when driving
with the spare tire.
 The standard tire should be repaired and
reinstalled as soon as possible.
 Avoid sudden acceleration, sudden
deceleration and sharp turns with the spare tire.
04 06.30

IN CASE OF AN EMERGENCY
291
Changing procedure
SV41027

1Jack 2Jack handle 3Wrench
4 Spare tire
1. Get the jack, wrench and spare tire.
To prepare yourself for an emergency, you should
familiarize yourself with the use of the jack and each tool,
and their storage locations.
SS41005

1Joint
2When removing the jack, turn the joint by hand in the ªcontractº direction until the jack is free.
3When storing, turn the joint by hand in theªexpandº direction until the jack is firmly secured
to prevent it from flying forward during a collision
or sudden braking.
04 06.30

IN CASE OF AN EMERGENCY
292
SV41028
To remove the spare tire:
1Remove the tool tray
2Loosen the bolt and remove it.
When storing the spare tire, place it with the inner side
of the wheel facing up. Then bolt the tire in place and
install the tool tray to prevent the tire from flying forward
during a collision or sudden braking.
SV41033
2. Block the wheel diagonally opposite the flat tire to
keep the vehicle from rolling when it is jacked up.
When blocking the wheel, place a wheel block in front of
one of the front wheels or behind one of the rear wheels.
04 06.30

IN CASE OF AN EMERGENCY
293
SS41008
3. Loosen all the wheel nuts.
Always loosen the wheel nuts before raising the vehicle.
Turn the wheel nuts counterclockwise to loosen them. To
get maximum leverage, fit the wrench to the nut so that
the handle is on the right side, as shown above. Grab the
wrench near the end of the handle and pull up on the
handle. Be careful that the wrench does not slip off the
nut.
Do not remove the nuts yet ± just unscrew them about
one±half turn.
CAUTION
Never use oil or grease on the bolts or nuts. The
nuts may loosen and the wheels may fall off, which
could cause a serious accident.
SV04003
4. Position the jack at the jack points as shown.
Make sure the jack is positioned on a level and solid
surface.
04 06.30