spare tire lexus LS400 1995 Engine / 1995 LS400: IN CASE OF AN EMERGENCY

IN CASE OF AN EMERGENCY
165

Never get beneath the vehicle when supported by a
jack.

Do not start or run the engine while your vehicle is
supported by a jack.
 1
Tool box 2
Jack 3
Spare tire 4
Jack handle
1. Get the tool, jack and spare tire.
To prepare yourself for an emergency, you should familiarize
yourself with the use of the jack and each tool, and their
storage locations.
 1
Joint
2
When removing the jack, turn the joint by hand in the
“contract” direction until the jack is free.
3
When storing, turn the joint by hand in the “expand”
direction until the jack is firmly secured to prevent it from
flying forward during a collision or sudden braking.

IN CASE OF AN EMERGENCY
166
To remove the spare tire:
1
Remove the spare tire cover.
2
Loosen the bolt and remove it.
When storing the spare tire, place it with the inner side of the
wheel facing up. Then bolt the tire in place and install the spare
tire cover to prevent the tire from flying forward during a
collision or sudden braking.
2. Block the wheel diagonally opposite the flat tire to keep
the vehicle from rolling when it is jacked up.
When blocking a wheel, place a wheel block in front of the front
wheels or behind the rear wheels.
Paper for protecting surface
3. Remove the wheel ornament.

IN CASE OF AN EMERGENCY
167 Pry off the wheel ornament, using the screwdriver as shown.
To avoid personal injury, do not attempt to pull off the ornament
by hand.
4. Loosen all the wheel nuts.
Always loosen the wheel nuts before raising the vehicle.
Turn the nuts counterclockwise to loosen them. To get
maximum leverage, fit the wrench to the nut so that the handle
is on the right side, as shown above. Grab the wrench near the
end of the handle and pull up on the handle. Be careful that the
wrench does not slip off the nut.
Do not remove the nuts yet − just unscrew them about one−half
turn.
5. Position the jack at the jack points as shown.
Make sure the jack is positioned on a level and solid surface.
6. After making sure no one is in the vehicle, raise it high
enough so that the spare tire can be installed.
Allow for the fact that you need more ground clearance when
putting on the spare tire than when removing the flat tire.